Instruction d'utilisation Apple SDRAM DIMM

Résumé du contenu de la page N° 1

 iMac (Slot Loading)
Memory (SDRAM DIMM)
Installation Instructions
Be sure to follow the instructions in this sheet carefully. Failure to follow
these instructions could result in damage to your equipment and may void
your warranty.
Installing memory in your computer requires four basic steps:
• Turn off the computer.
• Open the SDRAM DIMM access door.
• Install the new memory module in its slot.
• Close the access door.
Note: A video version of the installation instructions is

Résumé du contenu de la page N° 2

About Memory The iMac (Slot Loading) computer uses standard PC-100 DIMMs with the following specifications: • PC-100 Synchronous DRAM (SDRAM) • 64-bit wide,168-pin module • maximum of 16 memory devices on the DIMM • unbuffered; do not use registered or buffered Synchronous DRAM (SDRAM) • maximum height of 50 mm There are two DIMM slots accessible from the bottom of the computer. Use a coin, like a quarter, to release the access panel a

Résumé du contenu de la page N° 3

4 Use a coin or screwdriver to turn the latch on the access door. 5 Open the access door. iMac (Slot Loading) - 3

Résumé du contenu de la page N° 4

6 Touch the metal shield that is visible inside the recessed latch area before touching any components on the main logic board. This helps protect the computer from damage caused by electostatic discharge. Important: To avoid electrostatic discharge, always ground yourself by touching the port access covers before you touch any parts or install any components inside the computer. To avoid static electricity building back up in your body, do not walk around the room until you have com

Résumé du contenu de la page N° 5

9 Push the ejector tabs on the slots outward and down so they are in the open position. The module is designed to fit into the slot only one way. 10 Align the notches on the memory module with the small notches inside the slot. Push down the DIMM until it snaps into place. iMac (Slot Loading) - 5

Résumé du contenu de la page N° 6

11 Use a coin or screwdriver to close the latch on the access door. 12 Gently turn the computer right side up. 13 Reconnect the cables you disconnected from your computer. 14 Press the power button on the front of the computer to turn it on. Repackaging the DIMM If you are replacing memory as part of the Customer Installable Parts program (rather than upgrading memory), repackage the SDRAM DIMM you removed from the computer in the static-proof bag and box that you received with the repla

Résumé du contenu de la page N° 7

 Apple Computer, Inc. © 2000 Apple Computer, Inc. All rights reserved. Under the copyright laws, this document may not be copied, in whole or in part, without the written consent of Apple. The Apple logo is a trademark of Apple Computer, Inc., registered in the U.S. and other countries. Use of the “keyboard” Apple logo (Option-Shift-K) for commercial purposes without the prior written consent of Apple may constitute trademark infringement and unfair competition in violation of feder