Résumé du contenu de la page N° 1
LCD Monitor
LCD Farbmonitor
Moniteur LCD
Monitor LCD
Monitor LCD
LL-T2020
OPERATION MANUAL
BEDIENUNGSANLEITUNG
MODE D’EMPLOI
MANUALE D’USO
MANUAL DE FUNCIONAMIENTO
Résumé du contenu de la page N° 2
Table of Contents / Inhaltsverzeichnis / Table des matières / Indice / Índice Notice for Users in Europe . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Notice for Users in the UK . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Notice for Users in Australia . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Résumé du contenu de la page N° 3
Notice for Users in Europe This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC. Dieses Gerät entspricht den Anforderungen der EG-Richtlinien 89/336/EWG und 73/23/EWG mit Änderung 93/68/EWG. Ce matériel répond aux exigences contenues dans les directives 89/336/CEE et 73/23/CEE modifiées par la directive 93/68/CEE. Dit apparaat voldoet aan de eisen van de richtlijnen 89/336/EEG en 73/23/EEG, gewijzigd door 93/68/ EEG. Dette udstyr overholder
Résumé du contenu de la page N° 4
Notice for Users in the UK FOR CUSTOMERS IN U.K. IMPORTANT The wires in this mains lead are coloured in accordance with the following code : GREEN-AND-YELLOW : Earth BLUE : Neutral BROWN : Live As the colours of the wires in the mains lead of this apparatus may not correspond with the coloured markings identifying the terminals in your plug proceed as follows. The wire which is coloured GREEN-AND-YELLOW must be connected to the terminal in the plug which is marked by the letter E or by the safet
Résumé du contenu de la page N° 5
Notice for Users in the USA FCC Statement WARNING – FCC Regulations state that any unauthorized changes or modifications to this equipment not expressly approved by the manufacturer could void the user's authority to operate this equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
Résumé du contenu de la page N° 6
Environmental requirements Flame retardants Flame retardants are present in printed circuit boards, cables, wires, casings and housings. Their purpose is to prevent, or at least to delay the spread of fire. Up to 30% of the plastic in a computer casing can consist of flame LL-T2020-B LL-T2020-H retardant substances. Most flame retardants contain bromine or chloride, and those flame retardants are Congratulations! chemically related to another group of environmental toxins, You have just purchase
Résumé du contenu de la page N° 7
Table of Contents Tips and safety precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8 Product description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9 Height adjustment, angle adjustment, rotation (long height/width) . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10 Connecting the monitor and turning the monito
Résumé du contenu de la page N° 8
Tips and safety precautions - The LCD module built in this LCD Monitor is The Power Cord - Do not damage the power cord nor place heavy manufactured with highly precise technology. objects on it, stretch it or overly bend it. Also, do However bright pixels or blank pixels may appear not add extension cords. Damage to the cord constantly. Also an irregular color and brightness may result in fire or electric shock. may appear depending on view angle. Please - Use only the power cord supplied with
Résumé du contenu de la page N° 9
Product description 13 12 7 89 10 11 1 2 3 4 5 6 1. INPUT button .............................. To switch between the signal’s input terminals. 2. MENU button............................... This button is used to pop-up, select and close the OSD (On Screen Display) Menu. 3. button ...................................... This button is used to select menu options when the OSD Menu is displayed. 4. buttons ................................ When the OSD Menu is displayed: These buttons are used to i
Résumé du contenu de la page N° 10
Height adjustment, angle adjustment, rotation (long height/width) CAUTION! Rotation (long height/width) The display can be rotated for a long height or - Pressure from hands on the LCD panel could width to suit the displayed content. cause damage. - Before rotating, move the display to its - Be careful not to allow your fingers to be uppermost position. If the display is rotated while pinched. it is set low, it will contact the stand and could lead to damage. Height adjustment - The display can
Résumé du contenu de la page N° 11
Connecting the monitor and turning the monitor on and off CAUTION! 3.Refit the cover. Be careful not to pinch the cable. - When connecting, ensure that both the monitor and computer are switched off. - Be careful not to overly bend the cable or add extension cords as this could lead to a malfunction. Cable storage If necessary, excess cable can be housed in the stand. 1.Remove the cover. Gently pull the top of the cover towards yourself. - If the cover is hard to refit, do not force it. Check w
Résumé du contenu de la page N° 12
Connecting the monitor and turning the monitor on and off Analog connection Connect the analog signal cable to the analog RGB output terminal of the computer. Input terminal 1 and 2 You can connect to Input terminal 1 and 2 either side. You can connect to either side. Digital RGB output Digital signal cable terminal - Paying attention to connector direction, firmly Analog signal cable Analog RGB output insert the signal cable to terminal, and then terminal tighten the screws at both sides. - Pay
Résumé du contenu de la page N° 13
Connecting the monitor and turning the monitor on and off When connecting using a separately sold 2- Connecting the monitor to a power input cable source The separately sold 2-input cable (NL-C03J) enables connection between the DVI-I input terminal on the monitor and the two PCs. (One analog and one digital connection.) Power terminal 1.Connect the 2-input cable to the DVI-I input terminal of the monitor, and then connect the analog signal cable (commercially available) and the digital signal c
Résumé du contenu de la page N° 14
Connecting the monitor and turning the monitor on and off Turning the power on Changing between input terminals 1.Turn on the main power of the monitor. Use the INPUT button to switch between signal input terminals. When not using a 2-input cable Select [INPUT-1] Select [INPUT-2] Main power switch INPUT INPUT-1 INPUT-2 < > < > The input signal type (ANALOG/DIGITAL) is displayed within angle brackets < >. When using a 2-input cable - When switching the main power switch on and Wh
Résumé du contenu de la page N° 15
Connecting the monitor and turning the monitor on and off Turning the power off 1. Turn the computer off. 2. Press the monitor's POWER button. The Power LED will disappear. Turn the computer Press power button off OFF If the monitor will not be used for a long time, turn off the main power switch of the monitor, and remove the power plug from the outlet. 15 English Español Italiano Français Deutsch English
Résumé du contenu de la page N° 16
Adjusting the screen display For analog signal Adjustment lock function 1.First perform an automatic adjustment. (p. 17) By disabling the control buttons (i.e. setting the 2.Perform manual adjustment where necessary. lock) any attempted changes to adjusted values will (p. 18) be voided. For digital signal 1. Turn off the monitor power. The monitor can generally be used without 2.While pressing the MENU button, press the adjustment. If necessary perform manual power button (i.e. turn the power on
Résumé du contenu de la page N° 17
Adjusting the screen display (With analog connection) How to Adjust Automatic screen adjustment 1.Press the MENU button. Options in the ADJUSTMENT Menu can be The ADJUSTMENT Menu will be displayed. adjusted automatically (CLOCK, PHASE, H-POS, ADJUSTMENT V-POS). MANUAL AUTO CLOCK 127 Note: PHASE 6 - When setting up this monitor for the first time or H-POS 149 V-POS 41 after having changed an aspect of the current INPUT-1 ANALOG system, perform an automatic screen adjustment 1600 x 1200 V:60Hz H:7
Résumé du contenu de la page N° 18
Adjusting the screen display (With analog connection) ADJUSTMENT Menu Manual screen adjustment ADJUSTMENT Adjustments can be made using On Screen MANUAL AUTO Display (OSD) Menu provided. CLOCK 127 PHASE 6 On Screen Display for adjustment H-POS 149 V-POS 41 If you are using Windows, open the Adjustment INPUT-1 ANALOG Pattern on the accompanying CD-ROM. (p. 17) 1600 x 1200 V:60Hz H:75kHz If your system is not Windows, you can not use the MANUAL: Individual menu options are manually Adjustment Patt
Résumé du contenu de la page N° 19
Adjusting the screen display (With analog connection) GAIN CONTROL Menu COLOR CONTROL Menu GAIN CONTROL COLOR CONTROL MANUAL AUTO COLOR MODE sRGB STD VIVID WHITE BALANCE BLACK LEVEL 51 GAMMA 0 CONTRAST 65 HUE 0 SATURATION 0 6 COLORS INPUT-1 ANALOG INPUT-1 ANALOG 1600 x 1200 V:60Hz H:75kHz 1600 x 1200 V:60Hz H:75kHz MANUAL: Individual menu options are manually Notes: adjusted. - To choose a menu option: button AUTO: Every menu option is automatically - To go to the next menu: MENU button adjuste
Résumé du contenu de la page N° 20
Adjusting the screen display (With analog connection) COOL .....Color tone bluer than standard MODE SELECT-1 Menu ...........Color tone slightly bluer than standard MODE SELECT-1 STD ........Color tone standard setting INFORMATION ...........Color tone slightly redder than standard OFF TIMER INPUT-1 1LINE 2LINES WARM ....Color tone redder than standard INPUT-2 1LINE 2LINES USER R-CONTRAST ........ button for blue-green INPUT-1 ANALOG 1600 x 1200 V:60Hz H:75kHz button for red Notes:
