ページ1に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS
The most careful attention has been devoted to quality standards
in the manufacture of your new telephone. Safety is a major
factor in the design of every set, but, safety is YOUR
responsibility too.
Please read carefully the helpful tips listed below and on the next
6211 Telephone Quick Reference
page. These suggestions will enable you to take full advantage of
your new telephone. Then, retain these tips for later use.
Issue 2, June 2001
555-233-715
Use
Comcod
ページ2に含まれる内容の要旨
Figure 2. The Bottom of the 6200 Series Telephones PROCEDURES FOR USING THE FEATURES 2 Remove the desk stand by sliding it to the left until it is free of the telephone base. ANSWERING AND PLACING A CALL To answer or place a call Note: The Message light flashes when a call is coming in (that is, when the telephone is ringing). Desktop 1 To place or answer a call, lift the handset. Slide stand stand to left and lift 2 To place a call, next, dial the desired number. 3 To end the call, hang up t
ページ3に含まれる内容の要旨
PART 68: NETWORK REGISTRATION NUMBER c. Reposition d. Replace handset handset retainer This equipment is registered with the FCC in accordance with (up retainer Part 68 of the FCC Rules. position) down PART 68: ANSWER SUPERVISION SIGNALLING Allowing this equipment to be operated in a manner that does not (down provide proper answer-supervision signaling is in violation of Part position) 68 Rules. This equipment returns answer-supervision signals to the public switched network when: • Answer
ページ4に含まれる内容の要旨
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause interference to radio or television reception, which can be determined by turning the equipment on and off, the user is encouraged to try to correct the interference by one or more of the following measures: • Reorient the receiving television or radio antennae where this may be done safely. • To the extent possible, relocate the receiver with respect to the telephone
