ページ1に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 1
E
900 MHz Cordless Telephone
N
®
™
with Clarity Power Technology
G
L
I
Clarity 435 User Guide
S
H
E
S
P
A
Ñ
O
L
F
R
A
N
Ç
A
I
S
ページ2に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 2 Table of Contents Safety Instructions . . . . . . . . . . . . . . . . . .3 Lighted Key Pad . . . . . . . . . . . . . . .13 Getting Started . . . . . . . . . . . . . . . . . . . .5 Page/Handset Locator . . . . . . . . . . .13 Features . . . . . . . . . . . . . . . . . . . . . .5 40 Channel Operation . . . . . . . . . . .13 Connecting Your Telephone . . . . . . . . .8 Security Code . . . . . . . . . . . . . . . . .13 Choosing a Location . . . . . . . . . .
ページ3に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 3 Important Safety Instructions E N When using your telephone equipment, basic 10.Do not place anything on the power G safety precautions should always be followed cord. Install the telephone where no L to reduce the risk of fire, electric shock and one will step or trip on the cord. injury to persons including the following: I 11.Do not overload wall outlets or exten- S 1. Read and understand all instructions. sion cords as this can increase the risk o
ページ4に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 4 Important Safety Instructions that are covered by the operating 17.Never touch uninsulated telephone instructions. Improper adjustment may wires or terminals unless the telephone require extensive work by a qualified line has been disconnected at the technician to restore the telephone to network interface. normal operation. 18.Use caution when installing or modifying E. If the telephone has been dropped telephone lines. or the case has been damage
ページ5に含まれる内容の要旨
CLARITY POWER CLARITY POWER BOOST VOLUME VOLUME CHN MEM FLASH MUTE RD/P 1 23 4 5 6 78 9 0 # TALK ABC DEF GHI JKL MNO PQRS TUV WXYZ * W435UsrGd_8.28 8/28/03 10:28 PM Page 5 Getting Started E N Clarity Features G Handset L I 1. Handset Visual Ringer 9. Flash Button (FLASH) S 2. Headset Jack 10. Mute Button (MUTE) H 3. Dial Pad 11. Redial/Pause Button (RD/P) 4. Handset Charging Contacts 12. Temporary Tone Button (*) 5. Channel Button (CH) 13. Handset Ringer Off/On 6. Talk Button (TALK) 14. BOOS
ページ6に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 6 Getting Started Base Front 1. Visual Ringer 6. Base Ringer Volume Up/Down 2. Charging Contacts 7. Base Ringer Tones 3. Base Antenna 8. Base Ringer On/Off 4. Power LED (RED) 9. Page Button 5. In Use/Charge LED (GREEN) 3 1 2 9 PAGE RINGER ON RINGER VOLUME TONES 4 8 5 7 6 6
ページ7に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 7 Getting Started E N Base Top End G 1. Pulse/Tone L 2. BOOST On/Off I 3. AC (Electrical) Adapter Jack S 4. Telephone Line Jack (TEL) H TEL 1 2 3 4 7
ページ8に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 8 Getting Started Connecting Your Telephone Carefully remove your cordless telephone from it’s box. If there is any visible damage, USE ONLY WITH CLASS ! (CLASSE) 2 POWER SOURCE do not attempt to operate this equipment. PULSE/TONE BOOST 9VDC ON/OFF TEL 500mA Return it to the place of purchase. Check to be sure that you have all items that come with your telephone. You should have a HANDSET, BASE UNIT, AC ADAPTER, TELE- PHONE LINE CORD, BELT CLIP and O
ページ9に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 9 Getting Started E N 4. Plug the adapter into a standard G 120v AC power (electrical) outlet. L BATTERY CONNECTOR 5. Lift the base’s antenna to a I vertical position. BATTERY S BATTERY COMPARTMENT PACK PLUG COVER H 6. Set the PULSE/TONE switch located on the back of the base to correct dialing mode. Please check with your local Phone Company if uncertain of BATTERY the type of service. Diagram A: Installing and Connecting 7. Place handset in the
ページ10に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 10 Getting Started Handset Battery Charging NOTE: 1. Place the handset in the base. 1. Make sure the contact points are The CHARGE LED on the base will touching and the CHARGE LED is lit. light RED. 2. Be careful not to short battery with 2. After the batteries are fully charged, conducting materials such as rings, check for dial tone by pressing TALK bracelets and keys. on the handset. Battery Life 3. When the handset battery gets low, 1. Talk Time: 4
ページ11に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 11 Operating Your Telephone E N Clarity Power Technology Boost On/Off Switch G With the Clarity Power feature, the high This switch will enable/disable the reset L frequency sounds are amplified more than feature of the Clarity Power button I the low frequency sounds so words are as follows: not just louder, but clearer and easier S to understand. ON- When the BOOST ON/OFF switch is H set to “ON”, the Boost function (Clarity Power) will be ON every t
ページ12に含まれる内容の要旨
RINGER OFF ON OFF ON W435UsrGd_8.28 8/28/03 10:28 PM Page 12 Operating Your Telephone Base Ringer Headset Jack The base ringer includes ringer volume and A 2.5mm jack is located on the top of the tones adjustments which are located on the telephone handset that can be used in front of the telephone base. conjunction with a headset. While in headset mode, the volume of the headset is controlled by the telephone’s volume control and the handset’s earpiece and microphone are disabled.
ページ13に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 13 Operating Your Telephone E N To locate the handset if it is away from the Last Number Redial: G base, press and hold the PAGE button for The last number dialed (up to 22 digits) is L approximately five (5) seconds. A series of stored in the redial memory until another rings will sound for approximately six (6) I number is dialed. seconds. Return the handset to the base or S press the TALK button to cancel the page. H To use this feature: Channel Opera
ページ14に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 14 Operating Your Telephone Hearing Aid Compatibility To Delete a Number Stored into Memory: The handset has a special coil inside of it to 1. Press the MEM button. couple the sound to hearing aids equipped 2. Press the # key once. with T-Switches/T-Coils. 3. Press the MEM button again. 4. Press the button for the memory loca- tion you want to delete the number. MEMORY STORAGE 5. A long beep will indicate the process is complete. Memory Storage Locations
ページ15に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 15 Operating Your Telephone E N To Dial from Memory: Handset Out of Base: G 1. Press the TALK button. 1. Press the TALK button. L 2. Press the MEM button. I 3. Press the number on the dial pad Ending a Call: (0-9) where the desired number has S been stored. Place the handset in the base cradle or H 4. The call will automatically dial. press the TALK button to disconnect the line. 5. Adjust volume and Clarity Power as needed. MAINTENANCE AND CARE To Dial
ページ16に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 16 Troubleshooting The unit will not operate/no dial tone: The phone does not ring when you receive a call: • Verify the TALK Button is lit. • Make sure the RINGER switch on the • Verify the AC Adapter is securely handset and base are set to ON. plugged into the base of the telephone. • Verify the AC Adapter is securely plugged into the base of the • Verify the telephone line cord is telephone. securely plugged into the wall jack and the telephone.
ページ17に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 17 Troubleshooting E N Noise, Static, Interference or Other Calls Difficulty in Placing or Receiving Calls: G Heard while Using the Handset: • Move closer to the base and L • Try changing channels. try again. I • Make sure the base antenna is in an • If moving closer does not work, you S upright position. may have lost the security code. H • Make sure you are in the usable • Reset code by placing the handset range of the base station. back on the base f
ページ18に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 18 Regulatory Compliance Part 68 of FCC Rules Information local telephone company. For products approved after July 23, 2001, the REN for a) This equipment complies with Part 68 of this product is part of the product identifier the FCC rules and the requirements adopted that has the format US:AAAEQ##TXXXX. by the ACTA. On the bottom of this equip- The digits represented by ## are the REN ment is a label that contains, among other without a decimal point (
ページ19に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 19 Regulatory Compliance E N f) If trouble is experienced with this telephone Customer-Owned Coin/Credit Card Phones: G equipment, for repair or warranty informa- To comply with state tariffs, the telephone L tion, please contact Walker Ameriphone, company must be given notification prior to I 1-800-552-3368. If the equipment is causing connection. In some states, the state public harm to the telephone network, the telephone S utility commission, public s
ページ20に含まれる内容の要旨
W435UsrGd_8.28 8/28/03 10:28 PM Page 20 Regulatory Compliance to radio communications. However, there is Industry Canada Technical Specifications no guarantee that interference will not occur This product meets the applicable Industry in a particular installation; if this equipment Canada technical specifications. does cause harmful interference to radio or television reception, which can be determined Before installing this equipment, users should by turning the equipment off and on, you are
