ページ1に含まれる内容の要旨
43-1087.fm Page 1 Tuesday, August 17, 1999 2:46 PM
Cat. No. 43-1087
OWNER’S MANUAL
Please read before using this equipment.
ET-917
900-MHz • Digital Cordless Telephone
with 10-Number Memory
ページ2に含まれる内容の要旨
43-1087.fm Page 2 Tuesday, August 17, 1999 2:46 PM FEATURES ® Your RadioShack ET-917 900-MHz • COM-LOK — ensures that other Digital Cordless Telephone with 10- cordless phone users cannot use your Number Memory uses advanced digi- phone line when the handset is on the tal cordless telephone technology to cradle. give you superior sound quality. It uses the 900 MHz band which means less Page — lets you send a paging signal interference, clearer sound, and great- from the base to the handset to
ページ3に含まれる内容の要旨
43-1087.fm Page 3 Tuesday, August 17, 1999 2:46 PM This telephone has been tested and Warning: To prevent fire or shock haz- found to comply with all applicable UL ard, do not expose this product to rain and FCC standards. or moisture. Important Note: Cordless phones such as this one require AC power to READ THIS BEFORE operate. When the AC power is off, INSTALLATION you cannot dial out or receive incoming calls using your ET-917. To be safe, Each device that you connect to the you should a
ページ4に含まれる内容の要旨
43-1087.fm Page 4 Tuesday, August 17, 1999 2:46 PM CONTENTS Installation ............................................................................................................ 5 Selecting a Location ........................................................................................ 5 Placing the Base on a Desk Top ............................................................... 5 Mounting the Base on a Wall Plate ........................................................... 6 Mounting
ページ5に含まれる内容の要旨
43-1087.fm Page 5 Tuesday, August 17, 1999 2:46 PM INSTALLATION • The phone company will charge SELECTING A you for the installation of neces- LOCATION sary jacks. You can place the phone on a desk top • The USOC number of the jack to or table, or mount it on a wall. Select a be installed is RJ11C (RJ11W if location that is: you want to mount it on a wall plate). • near an AC outlet • near a telephone line jack Placing the Base on a • out of the way of normal activities Desk Top • away fro
ページ6に含まれる内容の要旨
43-1087.fm Page 6 Tuesday, August 17, 1999 2:46 PM 3. Insert the supplied AC adapter’s Mounting the Base on a barrel plug into the DC IN 9V jack Wall Plate on the back of the base. 1. Plug one end of the supplied short modular cord into the TEL.LINE jack on the back of the base. 4. Route the adapter’s cord through the strain relief slot on top of the base. Strain Relief Slot 2. Route the modular cord through the top right slot on the bottom of the base. 5. Plug the adapter into a standard A
ページ7に含まれる内容の要旨
43-1087.fm Page 7 Tuesday, August 17, 1999 2:46 PM 3. Insert the supplied AC adapter’s 6. Align the base’s keyhole slots with barrel plug into the DC IN 9V jack the wall plate studs and slide the on the back of the base. base downward to secure it. 4. Route the adapter’s cord through the slot on top of the base and 7. Press and lift out the handset through the left slots on the bot- holder, rotate it 180°, then snap it tom of the base. back into place so it holds the handset. 8. Plug the adap
ページ8に含まれる内容の要旨
43-1087.fm Page 8 Tuesday, August 17, 1999 2:46 PM 5 1. Drill two holes 3 /16 3 4. Insert the supplied AC adapter’s /16 inches apart. Then barrel plug into the DC IN 9V jack thread a screw into on the back of the base. each hole, letting the heads extend about 3 /16 inch from the 5 16 3 / wall. 5. Route the adapter’s cord through 2. Plug one end of the supplied mod- the slot on top of the base and ular cord into the TEL.LINE jack on through the left slots on the bot- the back of the base. t
ページ9に含まれる内容の要旨
43-1087.fm Page 9 Tuesday, August 17, 1999 2:46 PM 8. Press and lift out the handset 2. Insert the battery pack’s plastic holder, rotate it 180°, then snap it connector into its socket. The plug back into place so it holds the fits only one way. handset. Note: For easier battery pack con- nection, lift it out of the compart- ment, insert its connector into its socket and replace the battery pack inside the compartment. 9. Plug the adapter into a standard AC outlet. The POWER indicator on the
ページ10に含まれる内容の要旨
43-1087.fm Page 10 Tuesday, August 17, 1999 2:46 PM Notes: ing the handset off the base until the TALK/BATT LOW indicator • If the CHARGE indicator does not flashes. Otherwise, the battery light when you place the handset pack loses its ability to fully re- on the base, be sure the battery charge. pack and AC adapter are correctly and securely connected. • If the TALK/BATT LOW indicator does not light but the phone does Also, check the charging contacts not work, recharge the battery on the h
ページ11に含まれる内容の要旨
43-1087.fm Page 11 Tuesday, August 17, 1999 2:46 PM SETTING THE DIALING SETTING THE RINGER MODE TONE/VOLUME Set DIAL MODE on the back of the base You can select one of four different for the type of service you have. If you ringer tone/volume settings while the are not sure which type you have, do phone is not in use. this test. 1. Set DIAL MODE to T. VOLUME 1. Press . The ET-917 2. Lift the handset and listen for a sounds the current ringer tone. dial tone. VOLUME 2. Repeatedly press until
ページ12に含まれる内容の要旨
43-1087.fm Page 12 Tuesday, August 17, 1999 2:46 PM OPERATION handset beeps, followed by a brief MAKING AND pause as your phone searches for a RECEIVING CALLS clear channel. To make or answer a call, lift the hand- set. Or, if the handset is away from the cradle, press TALK. The TALK/BATT LOW indicator on the handset and the IN USE indicator on the base light. Note: If the handset is too far from the base, the channel might not change. Move closer to the base and try again. SETTING THE HANDS
ページ13に含まれる内容の要旨
43-1087.fm Page 13 Tuesday, August 17, 1999 2:46 PM Notes: USING TONE SERVICES • The redial memory holds up to 32 ON A PULSE LINE digits, so you can redial long- distance as well as local numbers. Some special services, such as bank- by-phone, require tone signals. If you • The redial memory also holds have pulse service, you can still use pause entries. See “Entering a these special tone services by follow- Pause” on Page 15. ing these steps. • The redial memory does not store 1. Be sure DI
ページ14に含まれる内容の要旨
43-1087.fm Page 14 Tuesday, August 17, 1999 2:46 PM 1. Lift the handset. If the TALK/BATT PAGING LOW indicator lights, press TALK to turn it off. To page the person who has the hand- set or to locate the handset when the 2. Press MEMO. The TALK/BATT PAGE phone is not in use, press on the LOW indicator blinks. base. The handset beeps for 2 sec- onds. 3. Enter the number and any TONE/ mode changes or REDIAL/P entries (see “Entering a Pause” on Page 15). Note: Each TONE/ or REDIAL/P MEMORY DI
ページ15に含まれる内容の要旨
43-1087.fm Page 15 Tuesday, August 17, 1999 2:46 PM 6. Attach the sticker to the phone. Dialing a Memory Number To dial a number stored in memory, lift the handset or press TALK. The TALK/ BATT LOW indicator lights. When you hear a dial tone, simply press MEMO and enter the memory lo- cation number for the number you want to dial. Chain-Dialing Service Numbers When calling special services (such as To erase a stored number, simply alternate long distance or bank by store a new number in its
ページ16に含まれる内容の要旨
43-1087.fm Page 16 Tuesday, August 17, 1999 2:46 PM TROUBLESHOOTING We do not expect you to have any problems with your phone, but if you do, the fol- lowing suggestions might help. Problem Suggestion Low volume or unusual sounds. Someone has picked up another phone on the same line. Hang up the other phone. Severe noise interference. • Press CH to change the channel. • Keep the handset away from comput- ers, remote control toys, wireless microphones, alarm systems, inter- coms, room monit
ページ17に含まれる内容の要旨
43-1087.fm Page 17 Tuesday, August 17, 1999 2:46 PM Problem Suggestion Handset does not ring or receive a • Return the handset to the cradle to page. recharge the battery pack. • Lift the base’s antenna to a fully verti- cal position. • Move the handset closer to the base. • Move the base away from other elec- trical devices. The handset stops working or works • Move the handset closer to the base. poorly during a call. • Be sure the handset’s battery pack is charged. (If the battery pack p
ページ18に含まれる内容の要旨
43-1087.fm Page 18 Tuesday, August 17, 1999 2:46 PM CARE AND MAINTENANCE Your ET-917 900-MHz Digital Cordless Telephone with 10-Number Memory is an example of superior design and craftsmanship. The following suggestions will help you care for your cordless telephone so you can enjoy it for years. Keep the ET-917 dry. If it gets wet, wipe it dry immediately. Liquids might contain minerals that can corrode the electronic circuits. Handle the ET-917 gently and carefully. Dropping it can damage c
ページ19に含まれる内容の要旨
43-1087.fm Page 19 Tuesday, August 17, 1999 2:46 PM Cautions: REPLACING THE • You must use a replacement bat- BATTERY PACK tery of the same size and type. If you follow the instructions in “Con- • Do not dispose of the battery in a necting and Charging the Battery fire because it might explode. Pack” on Page9, the battery pack should last about one year. If the bat- • Do not open or mutilate the bat- tery does not hold a charge for more tery. than 2 hours after an overnight charge, • Be care
ページ20に含まれる内容の要旨
43-1087.fm Page 20 Tuesday, August 17, 1999 2:46 PM If you cannot eliminate the interfer- THE FCC WANTS YOU ence, the FCC requires that you stop TO KNOW using your phone. In the unlikely event that your phone Some cordless telephones operate on causes problems on the phone line, frequencies that may cause interfer- the phone company can temporarily ence to nearby TVs and VCRs. To discontinue your service. If this hap- minimize or prevent such interference, pens, the phone company attempts to
