ページ1に含まれる内容の要旨
DRX332 Accessory Handset and
TM
MULTIRANGE Charger User's Guide
What's in the box?
DRX332
accessory handset with
TM
MULTIRANGE charger
AC adapter
(PS-0033)
Rechargeable
Battery
battery pack
cover
(BT-1018)
If any items are missing or damaged, contact our Customer
Care Line immediately. Never use damaged products!
Need Help? Get answers 24/7 at our website: www.uniden.com.
If You... Contact Uniden’s... Phone Number
817-858-2929 or
have a question or problem Customer Care Line*
800-297
ページ2に含まれる内容の要旨
What's in the manual? Important Safety Instruc ti ons! ..2 Registering the MULTIRANGE charger .................................. 7 Se tti ng Up Your Handset ..........3 Placing the MULTIRANGE Install the Ba tt ery ....................3 charger .................................. 8 Connect the Charger ...............3 Registering the Handset ..........4 Important Informa ti on ..........10 Using the Handset ...................5 Specifi ca ti ons ........................10 TM Ba tt ery Informa ti
ページ3に含まれる内容の要旨
Se tti ng Up Your Handset Install the Ba tt ery 1. Unpack the handset, battery pack, and battery cover. If the battery cover is already on the handset, press in on the notch and slide the cover down and off. 2. Line up the battery pack connector with the jack inside the handset. (The battery connector only fits one way.) 3. Push the battery pack connector in until it clicks into place. Tug gently on the wires to make sure the battery pack is securely connected. 4. Place the cover over th
ページ4に含まれる内容の要旨
Registering the Handset Registering the handset is a separate process from registering the TM MULTIRANGE charger. You can use the handset normally even if the charger is not registered. The accessory handset will not work until you register it to a base! Compa ti ble Bases This handset is designed for use with Uniden's DECT3380 base. Other Uniden DECT6.0 bases might be compatible with this handset. For up-to-date list of compatible bases for this handset, see our website. Register t
ページ5に含まれる内容の要旨
Test the connec ti on Pick up the handset and press TALK. Make sure you get a dial tone. (Press END to hang up.) If... Try... - you don't hear a dial tone Making sure the handset is fully the display says Registration - charged, then trying again. Failed Using the Handset When the handset registers to a base, it adapts its software to match that specific base. This means that the exact features and operation of the handset will vary slightly depending on which base you register the hand
ページ6に含まれる内容の要旨
TM Using the MULTIRANGE Charger How It Works TM The DRX332 MULTIRANGE charger extends the range of your base in all directions, including up and down. Each handset will automatically connect to the charger or the base, depending on which signal is stronger. (The handset operates exactly the same way whether it's connected to the base or to the MULTIRANGE charger.) Base Coverage Area Handsets in this area always connect to the base. Overlap Coverage Base Area TM Handsets in MULTIRANGE cha
ページ7に含まれる内容の要旨
Each of these bases can support up to two DRX332 MULTIRANGE chargers, including any that were supplied with your phone. Usually, you can't tell when a handset switches between the base and the charger in the middle of a call, but sometimes, you might notice a brief pause in your conversation. Registering the MULTIRANGE charger Registering the MULTIRANGE charger is a separate process from registering the handset. You can use the charger even if the handset is not registered. 1. On th
ページ8に含まれる内容の要旨
Some important things to remember: Only register one charger at a time. If more than one charger is in registration mode at the same time, they can interfere with each other. If you want to use the MULTIRANGE charger with a different base, just register the charger to the new base. The charger automatically erases the link to the old base when it registers to the new one. Only register the charger to one base at a time. If more than one base is in registration mode at the same time, y
ページ9に含まれる内容の要旨
2. While on the call, carry the handset away from the base towards the general area where you want to put the charger. 3. Watch the signal strength icon on the handset. Make a note where the icon drops from 4 bars to 3 bars. 4. Continue walking away from the base. Make a note where the signal strength icon drops from 3 bars to 2 or if you start to hear noise on the line (which indicates the signal is getting weaker). 5. Place the charger anywhere inside the range where the signal strengt
ページ10に含まれる内容の要旨
Important Informa ti on Specifi cations Part number PS-0033 AC Adapter Input voltage 120V AC, 60 Hz Output voltage 6.5V AC @ 350mA Part number BT-1018 Battery pack Capacity 500mAh, 2.4V DC Use only the supplied AC adapter. Be sure to use the proper adapter for the base and any chargers. Do not place the power cord where it creates a trip hazard or where it could become chafed and create a fire or electrical hazard. Do not place the unit in direct sunlight or subject it to high temperatur
ページ11に含まれる内容の要旨
With normal use, the battery should last about one year. Replace the battery when the talk time becomes short even when the battery is charged. To buy a replacement battery, call the Parts Department listed on the front cover. Rechargeable Nickel-Metal-Hydride Ba tt ery Warning CAUTION! Risk of explosion if battery is replaced by an incorrect type! Dispose of used batteries according to the instructions. Do not open or mutilate the battery. Disconnect the battery before shipping this prod
ページ12に含まれる内容の要旨
Compliance Information Any changes or modifi ca ti ons to this product not expressly approved by the manufacturer or other party responsible for compliance could void your authority to operate this product. FCC Part 15 information This device complies with part 15 of the FCC rules. Opera ti on is subject to the following two condi ti ons: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undes
ページ13に含まれる内容の要旨
RF exposure information This product complies with FCC radia ti on exposure limits under the following condi ti ons: • The base must be placed to allow a minimum of 20 cm (8 inches) between the antenna and all persons during normal opera ti on. • The base must not be collocated or operated in conjunc ti on with any other antenna or transmi tt er. The handset is designed for body-worn opera ti on and meets FCC RF exposure guidelines when used with any belt clip, carrying case, or other acces
ページ14に含まれる内容の要旨
Radio equipment The term IC before the radio cer ti fi ca ti on number only signifi es that Industry Canada technical specifi ca ti ons were met. Opera ti on is subject to the following two condi ti ons: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired opera ti on of the device. "Privacy of communica ti ons may not be ensured when using this telephone". One-year Limited Warranty Important: Evidence o
ページ15に含まれる内容の要旨
parts, service, or any other cost (except shipping and handling) incurred by warrantor or its representa ti ves in connec ti on with the performance of this warranty. Warrantor, at its op ti on, may replace the unit with a new or refurbished unit. THE LIMITED WARRANTY SET FORTH ABOVE IS THE SOLE AND ENTIRE WARRANTY PERTAINING TO THE PRODUCT AND IS IN LIEU OF AND EXCLUDES ALL OTHER WARRANTIES OF ANY NATURE WHATSOEVER, WHETHER EXPRESS, IMPLIED OR ARISING BY OPERATION OF LAW, INCLUDING, BUT
ページ16に含まれる内容の要旨
• Uniden® is a registered As an Energy Star® trademark of Uniden America Partner, Uniden has Corpora ti on. determined that this • Call wai ti ng, CID, CIDCW, product meets the Energy and Voice Mail are telephone Star® guidelines for energy line services. Your phone e ffi ciency. Energy Star® is supports these services, but a U.S. registered mark. you have to arrange for them through your telephone provider. Contact your provider for details. • The pictures in this manual are for ex
