ページ1に含まれる内容の要旨
9OOMHz CORDLESS TELEPHONE
VTECH COMMUNICATIONS LTD.
IVrECH]
Is a trademark of VTECH COMMUNICATIONS LTD.., a member
I
of THE.VTECH GROUP OF COMPANIES.
Distributed in the U.S.A. by VTECH Communications, 8770 SW Nimbus Avenue I
Beaverton, Oregon, 97008.
- 7671 Alderbridge
Distributed in Canada by VTECH Electronics Canada Ltd., Suite 200
Way Richmond, B.C. V~X 1Z9.
BEFORE USING YOUR NEW
PHONE, WE STRONGLY
Copyright 1997 for VTECH COMMUNICATIONS LTD..
RECOMMEND YOU READ THIS
Printed in
ページ2に含まれる内容の要旨
@j ......... ........ OPTIONAL HEADSET INSTALLATION ..... ..... 9::. "... : ....... OPTIONAL HEADSET INSTALLATION .......... .......... ....... AND OPERATING INSTRUCTIONS I.'...'. ..... ..... ....... ......... .......... ......... AND OPERATING INSTRUCTIONS .......... , ........ 4:. ......... .:.: ! i:':.,. :.:.:.:" : ......... ........ ......... OPERATION The headband can be adjusted to fit ...... ........ ......... ,.,. .......... the contour of your head. Using .
ページ3に含まれる内容の要旨
TABLE OF CONTENTS ... Page INTRODUCTION ...................................................................................................... 1 Congratulations! You have purchased PAGE key will cause the .handset to ... Special Features ............................................................................................................. 2 one of the most sophisticated cordless ring in a manner which distinguishes ..-i. Parts Check List .............................................
ページ4に含まれる内容の要旨
Easy answer - When the phone parts ~i~~ , i:;:,:'.:.i , . ;?:@ . . &~i:~j$+$ , . . , . To purchase replacement battery . I.._. ..r_:... _..__.UI.. dl rings, simply press any key other 1. Base unit, Handset and AC ada6or packs, call VTECH Communications Fully Digital Link between Hand- than OFF, MUTE, or the Volume 2. One-Line Telephone Cord at 1-800-595-951 1 in the U.S. and Keys on the handset to answer. 3. Battery Pack 1-800-267-7377 in Canada. set and Base with ADPCM voice Auto ha
ページ5に含まれる内容の要旨
FCC Part 15 FCC Part 68 . This equipment complies with Parts This equipment.may not be used on Warning: Changes or modifications The FCC requires that you connect your 15 and 68 of the Federal Communi- coin service provided by the phone to this unit not expressly approved by cordless telephone to the nationwide cations Commission (FCC) rules for company or Party Lines. the party responsible for compliances the United States. It also complies telephone network through a modular could vo
ページ6に含まれる内容の要旨
Before installing this equipment, users Your VT 1921 is designed to operate When using yourtelephone equipment, 7. This product should be operated only from the type of power source should ensure that it is permissible to at the maximum power allowed by the basic safety precautions should always indicated on the marking label. If be connected to the facilities of the FCC and IC. This means your be followed to reduce the risk of fire, you are not sure of the type of local telecommunications
ページ7に含まれる内容の要旨
-L-.;;_..;.. i.... -r.*.,, .......... --- . . I Y,; INSTRUCTIONS i ........ , . I ....................... Alternatively, if you have purchased CHARGING THE ,HANDSET ,BAT- 12.Unplug this product from the wall 13.Avoid using a telephone (other a spare battery pack and it has been TERY PACK outlet and refer servicing to a than a cordless type) during an charging in the base unit, simply The handset of your VT 1921 cordless VTech authorized service facility electrical storm. There
ページ8に含まれる内容の要旨
4. Do not dispose of the battery in a 1-800-8-BATTERYTM for information Follow the steps below: fire. The cell may explode. on Ni-Cd battery recycleing and 1. Remove the battery case cover disposal banslrestrictios in your by pressing on the ridged lines area.VTechls involvement in this and sliding downward. program is part of its commitment to SLIDE IN THE protecting our environment and conserving natural resources. (contained in ciur product) indicates PRESS and SLIDE Remove the
ページ9に含まれる内容の要旨
Place a battery pack in the Spare 5. Exercise care in handling Setting UpcYour VT 1921 - d " .- -- Battery charger. Make sure the metal batteries in order not to short the Choose an area near an electrical - charging contacts on the underside of battery with conducting materials outlet and a telephone wall jack. the battery pack are aligned with the . ; such as rings, bracelets, and keys. charging contacts in the Spare Battery The battery. or conductor may AC Power Adaptor charger. o
ページ10に含まれる内容の要旨
dAW>'M 0 U N,T USING i;JPS;;.pALLy s.t,,-J,,$ Check for a dial tone. After the ADAPTOR ,:,,~?;'-~:'!'~,i~,~~~~f~~~~~~ f3 battery pack is charged, rotate the 1. Position the wall mount bracket Base Unit antenna to an upright on the base, position. Pick up the Handset and Line up the tabs on the wall mount presscPHONE) "PHONE ON" will adaptor with. the holes on the appear on the LCD, and you will hear bottom of the base (Figure 1). a dial tone. If not, see 'IN CASE OF Snap the wall,
ページ11に含まれる内容の要旨
LCD Display Messages FEATURES is displayed when the handset 'THE HANDSET microphone has been muted. the PHONE ON indicator is displayed is displayed when the handset ringer ANTENNA when the phone is in use. has been programmed off. shows the handset volume setting. is displayed when the handset has lost communication with the base unit and is attempting to reestablish a link by scanning all channels. VOLUME UP & DOWN - I LCD DISPLAY is displayed when the unit is in a low- BAlTERY 7
ページ12に含まれる内容の要旨
......:... -.::..'>a : .....-.... ..,. ...-... i SET-UP;. .:- . ,::,: 'i,'.;,::. ., .: . . , : . TO MUTE-A CALL&^,^^^^^^^^ Plug AC adaptor into a standard Press (m) to disable the electrical outlet and Base Unit handset microphone. Set Dial Mode switch to PULSE or Press (m] again to return to TONE. The unit is factory set to normal two way conuersation. THE BASE UNIT FEATURES TONE. Let the handset battery pack To age from the base, press charge for 16 hours before first *dl use
ページ13に含まれる内容の要旨
&&&;; To view the time and date of the MAKING - -. - CALLS .. .- -..- -.-. -- - FM.2H You can use vour VT 1921 cordless call press and hold the 7 @ key. NOTE: There are two different ways phone with services such as Call The time and date will be shown to dial a number: Waiting. Simply press the (PHONE] along with the phone number. You key to FLASH the line. will see something like: STORlNG 1. Press the (m) key and wait , -. .... ... ...I. ... . ... . ."': :"': :"': .! THE PHONE
ページ14に含まれる内容の要旨
,,*WlypRp,- ". &.- >" Temporary,Toneh&&* U...._ 4 YC s+~~\>& La> ~~&~A~~G&~J$~~~>$~$-~~{>&~&~~~+ If you have rotary (dial-pulse) While you are on a call, you will hear telephone service (TONEIPULSE an alert signal, warning that a second switch is set to PULSE), this feature caller is trying to reach you. CALL To select a different ringer type do allows you to temporarily switch to WAITING is a subscription service, the following: TONE dialing for such purposes as available from mos
ページ15に含まれる内容の要旨
Storing Memory: (Speed) Dial 2,;; '. Advanced Dialing ,J:~;;,'_+. numbers$! i", .cr+! ..:$,.':.I; :-:I : i"'; p..i p..i 'i' f.. f i"'. There are two different ways to d~al . iY ! i i . .i. i 7 Ci To program a speed'dial idcation, do a number: TURNING OFF THE the following: I"': !.'.""'. I :"" ""' :"" 1. Press the (PHONE) key and wait RINGER iE ..". 'L j... ! . ....... i i i .... : .... i i:::. for a dial tone. Then dial the PRESS With the phone OFF, enter the number you want ei
ページ16に含まれる内容の要旨
NOTE: Storing Special Codes YJ -&,%tXq The ability to temporarily add memory To insert a ause in a phone number, contents to digits already entered on press & at the appropriate point Press m, you're prompted to the display operates in the same way when entering the number on the LCD. for CID and speed dial, memories. enter a speed dial location This inserts a 2 second pause. A number: " P " appears in the display to show In this way, long distance and area For longer pauses, press
ページ17に含まれる内容の要旨
NOTE: You must be in an area where CID Your VT 1921 cordless phone is the received telephone number will be If for 'any reason the telephone capable of displaying the name and/ service is available and you mus I used. Consequently, you would number of the caller is unavailable, or or phone number of the person calling, subscribe to it to use this feature. actually dial this: ' if the caller is outside the CID service before you answer the phone. area, the message UNAVAILABLE is Subscr
ページ18に含まれる内容の要旨
Press and hold the (Cmi To find out the corresponding phone DELETING- NUMBER$@:? * ? - number as well as the date and key for more than 2 seconds to Pressing the (cLR/DEL)button delete: Calls stored in memo can be delete the entire contents of CID the call, press and hold the CID number displayed. reviewed by pressing b CID . The memory. The display will show time the 7 8 1 key. The date and time will display will show the number of the While the phone is in CID mode, the following, f
ページ19に含まれる内容の要旨
,,r*.w,..r a, .., TAKING .,CARE :*OF.&.YO,URJ~TEL;- ~E$&@!JLEREER~ENCE&&~ OUT OF RANGE WHEN PHONE IS Cleaning y-qur telep,h>one~ai .,.&i B ON-,:., , ,,>,, : 1 % EPHONE!.,,; .* ,:h:',j2:,l;;< Your telephone has a durable plastic Your VT 1921 cordless tele~hone has Your VT 1921 cordless telephone casing that should retain its luster for auto-channel scan circuitry'which will If you are presently engaged in 'a contains sophisticated elec'tronic many years. Clean it only with a soft detec
ページ20に含まれる内容の要旨
If you have difficulty operating your "YOU GET -NOISE, STATIC, OR-A COMMON CURE FOR ELECTRONIC phone, the suggestions below should WEAK 'SIGNAL ' WHEN,;,YOUIRE EQUIPMENT ..,, AWAY ,FROM THE BASE UNIT. 5'5 Electronics, like people, can sometimes solve the problem. If you still have difficulty after trying these suggestions, You may be' out of range. Either get confused. If the unit does not call VTECH Communications at move close to the base, or relocate seem to be responding normally, then
