MGA Entertainment Bratz LR06の取扱説明書

ページ1に含まれる内容の要旨

FCC Compliance
NOTE: This equipment has been tested and found to comply with the limits for Class B digital device,
pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
Ages 6+
energy and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no

ページ2に含まれる内容の要旨

QUICK START (con‛t) 2. Take your Bratz™ Movie stars Sharidan™ doll and place her on the Star Fig. 2 Base. Holes in the bottom of her feet will fit on the pegs of the Star Base. (See Fig. 2). 3. Place the doll about 14+ inches away from the camera. CAMERA SETUP AND OPERATION Side & Bottom: The Camera is made up of the following parts (Fig. 3): Fast a. Shutter Release button Slow b. “ANIMATE/CAPTURE” Switch c. “ON/OFF”Switch 3. You can use your Movie Stars camera to animate any of your toys!

ページ3に含まれる内容の要旨

Movie Playback: Now we will watch the movie that you have just created: TV Connection and Camera Start: 1. With the camera still on, change the “ANIMATE”/CAPTURE” Switch to “ANIMATE”. For best results, you should attach the Camera to a TV with the TV Video Cable (included). This will allow 2. The TV screen icons will disappear and a new Frame Counter will appear in the lower left hand corner. This you to see what the camera sees! counter shows the number of total captured images and the curr

ページ4に含まれる内容の要旨

6. Now, move your doll‛s arm to the left and straighten it out as you go. Then, bring her arm back up into Capturing Images: the first position. Do this six times as shown below. Your Camera is designed to take a series of still pictures and play them back rapidly in succession, this process is known as animation. With animation you will be able to make your Bratz™ doll appear to come to life! Here‛s how: 1. Pose your Bratz™ doll in a starting pose. 3. 1. 2. 2. Remove the “Shutter