Gianni Industries DG-15 Seriesの取扱説明書

ページ1に含まれる内容の要旨

DG-15 series Digital Keypad Entry system
Operation User's Manual


1. Specifications:
Operating Voltage: 12 Vdc
Current Draw: Average 15mA, Peak 100mA @ 12Vdc
Input: request-to-exit, time out reed switch contact
Output: Dual relays, N.O./N.C./Com. Output (free voltage
contact)
Relays Electric Current: 2A MAX @30Vdc ；0.4A @
120Vac
Relay Activation Time:
Relay 1 time delay setting code 「＊3

ページ2に含まれる内容の要旨

Enter the Programming mode → Press the slot position code of your choice to delete (example "06") →Press「＊06 」→ 「0000 」（or 「00000 」）→ （beep ） →delete → Press 「# 」 to exit from the programming mode, or programming other operating. To Program Relocking Timer Enter the Programming mode, A. Relay 1 ：Press 「＊30 」Followed by the number of seconds the relay should open → 「05 」=5 seconds （01 ~99 = seconds, 「00 」Sets the relay to latching mode ）→ （beep ）→enrolled → Press 「# 」 t

ページ3に含まれる内容の要旨

Note: The suggested wire gauge is #22~26 AWG. The varistor or diode must be connected across the lock terminal (electromagnet...) operated by the device. The vartistor controls the overload produced by the strike coil (EMP). Egresses switch should be N.O. type. REED contact input for anti-trailing （Relay 1 ）. Contact door reed switch, this reed switch is used to reset the re-locking time to 0 second when the door is moved. Using N.O. contact in case of door closed changeover to N.C