ページ1に含まれる内容の要旨
1
Installation:
DV1628
Owner's Manual
Getting Started.
It is a good idea to read all of the instructions before you begin the
installation.
Tools and supplies needed:
• Flat and Phillips screwdrivers
• Wire cutters and strippers
• Tools to remove existing radio
• Electrical tape
• Crimping tool
• Volt meter/ Test light
• Crimp connections
Thank you!
• Speaker Requirements: Only connect speakers rated in the load
Thank you for choosing a JENSEN product. W e ve tried to make the
impedance range
ページ2に含まれる内容の要旨
2 • Use factory radio or DV1628 removal tools to remove the radio from the DIN opening. 1 ANTENNA EXTERNAL MUTE KEY IN FIGURE1 2 SUB OUT (VARIABLE PRE-AMP) LEFT STEREO OUT (FIXED PRE-AMP) 3 RIGHT STEREO OUT (FIXED PRE-AMP) VIDEO IN LEFT STEREO IN AUX IN 4. Wire Connections: RIGHT STEREO IN • See Figure #1 VIDEO 1 OUT VIDEO 2 OUT Pin # Wire Color Function 1 Violet w/ Black stripe Right Rear speaker ( - ) 2 Green w/ Black stripe Rear L Speaker ( - ) LEFT STEREO OUT 3 Brown w/ Black stripe Center
ページ3に含まれる内容の要旨
3 Troubleshooting: ERROR CORRECTIVE PROBLEM CAUSE DISPLAY ACTION Check power CDP and CDC Does not No power to connection with operate, Yellow wire, ERR1 appears Mechanism Multi-meter. Check Press Reset button. display does No power to on display Error fuse for continuity not light. Red ERR6 appears with Multi-meter. Sled Error Press Reset button. on display Inline fuse Replace fuse. blown No power to Inline fuse Check and/or unit blown replace fuse. CDP ONLY Speaker Check speaker ER
ページ4に含まれる内容の要旨
4 4. Source: Press the source button to toggle Operation: between Radio, CD/DVD, CDC/DVDC, and Aux mode. (NOTE: CDC/DVDC mode is active only if a changer is 1. Front Panel / Remote Control connected. This source will be skipped if a changer is not • Controls installed.) Press and hold the Source button for 2 seconds to mute the rear speaker and subwoofer. Press and hold for 2 more seconds to re-activate the rear speakers and subwoofer. 27 3 10 11 29 12 26 6 7 15 13 2 5. Enter / Mute: Press t
ページ5に含まれる内容の要旨
5 toggle between EQ settings, each press will toggle from Flat, Classic, Pop, Rock, to off. CLK 14. Angle: Allows the viewer to view the DVD at 1 15 different angles if the DVD is recorded with this feature. SCN RPT Press the angle button while the DVD is Stopped. Then press the / to adjust the brightness and contrast RND D.DN D.UP levels. 15. Disp/Clock: Press to display the Clock or Disc 19 information. Setting the clock: Press and hold the Disp/Clock button until the display begins to flas
ページ6に含まれる内容の要旨
6 • Front Panel removal: 2. MP3 Compatible: a. Press the open button #3. b. Press the middle release button and pull the panel straight This unit supports the following MP3 CD formats: out. • Joliet • Romeo • ISO9660 3. Smart Mode function: The Smart Mode feature allows the user to listen to two different audio sources at the same time. One source can be selected through the speaker system while the DVD can be listened to through an external audio source. Ex. IR transmitter for wireless he
ページ7に含まれる内容の要旨
7 General Setup Cont.: Initial Setup: TV Display: Press the Setup #18 button to enter the Setup mode. Selects the appropriate TV aspect ratio, 4:3 or 16:9 SETUP MENU - - MAIN PAGE • Normal / PS o Pan and Scan for 4:3 aspect ratio. If selected while using GENERAL SETUP a 16:9 TV, the left and right edges will be cut off. SPEAKER SETUP • Normal / LB AUDIO SETUP o Letterbox style for 4:# aspect ratio. If connected to a wide-screen TV, black bands
ページ8に含まれる内容の要旨
8 PIC Mode: Angle Mark: -- GENERAL PAGE -- -- GENERAL PAGE -- TV DISPLAY TV DISPLAY TV TYPE TV TYPE PIC MODE AUTO PIC MODE ANGLE MARK FILM ANGLE MARK ON OSD LANG VIDEO OSD LANG OFF CAPTIONS SMART CAPTIONS SSMART MAIN PAGE MAIN PAGE • Auto o PIC mode automatically selects the setting depending on the DVD. • Film Changes the viewing angle of multi-angle DVD s. If the DVD does not o Suitable for film or progressive so
ページ9に含まれる内容の要旨
9 OSD Language Setup: Speaker Setup: -- GENERAL PAGE -- SETUP MENU - - MAIN PAGE ENGLISH TV DISPLAY GENERAL SETUP FRENCH TV TYPE SPEAKER SETUP GERMAN PIC MODE AUDIO SETUP ANGLE MARK PREFERENCES OSD LANG CAPTIONS SPANISH EXIT SETUP MAIN PAGE Selects the Language that the OSD will be displayed in. Down Mix: Closed Captioning: • LT/RT o Activates Dolby Surround compatible output. --
ページ10に含まれる内容の要旨
10 Speaker selection: DOWNMIX DOWNMIX CENTER CENTER ON REAR REAR OFF 15MS SUBWOOFER SUBWOOFER CNTR DELAY CNTR DELAY 9MS REAR DELAY REAR DELAY TEST TONE TEST TONE 3MS BASS BASS OFF MAIN PAGE MAIN PAGE Highlight the desired speaker selection then the ON / OFF Selection to turn the desired speaker ON or OFF. Individual speaker DOWNMIX selection is active only in Downmix mode. CENTER Select Rear Delay and / or CNTR Delay to control the delay of the audio signal to the Rear and Center speakers. REAR
ページ11に含まれる内容の要旨
11 AUDIO SETUP: -- DOLBY DIGITAL SETUP -- DOWNMIX SPDIF OFF CENTER OP MODE ON DUAL MONO REAR D R C SUBWOOFER LPCM OUTPUT CNTR DELAY MAIN PAGE REAR DELAY TEST TONE ON BASS OFF SPDIF - Turns the SPDIF optical output Off and On MAIN PAGE -- DOLBY DIGITAL SETUP -- SPDIF OP MODE LINE MODE Test Tone: By selecting TEST TONE, the unit will send a tone to each of DUAL MONO the speakers in the following order: D R C LPCM OUTPUT LEFT CENTER RIGH
ページ12に含まれる内容の要旨
12 -- DOLBY DIGITAL SETUP -- -- DOLBY DIGITAL SETUP -- SPDIF FULL SPDIF OP MODE OP MODE 6/8 DUAL MONO DUAL MONO STEREO D R C D R C CH1 MONO 4/8 LPCM OUTPUT LPCM OUTPUT CH2 MONO 2/8 MIX - MONO MAIN PAGE MAIN PAGE OFF DRC — Dynamic Range Control: Dual Mono: Select DRC to adjust the dynamic range of the Dolby Digital encoded program. The dual mono reproduction is for the Dolby Digital program -- DOLBY DIGITAL SETUP -- with 1+1 A
ページ13に含まれる内容の要旨
13 -- PREFERENCES PAGE -- AUDIO Language Setup screens: SUBTITLE ENGLISH DISC MENU FRENCH -- PREFERENCES PAGE -- LOCALE SPANISH AUDIO ENGLISH PARENTAL JAPANESE SUBTITLE FRENCH PASSWORD CHINESE DISC MENU SPANISH SMART NAV GERMAN LOCALE CHINESE DEFAULTS ITALIAN PARENTAL JAPANESE MAIN PAGE PASSWORD GERMAN SMART NAV Audio — Selects the language to be heard through the audio output. DEFAULTS Disc Menu — Selects the language to be displayed
ページ14に含まれる内容の要旨
14 Setting a new password — Select change and press enter. Type in the old Parental Controls: password and press enter. The factory default password is 3308. Type in a new 4 digit password. -- PREFERENCES PAGE -- Smart NAV: LANGUAGE 1 G -- PREFERENCES PAGE -- SUBTITLE 2 DISC MENU 3 PG LANGUAGE LOCALE 4 PG 13 SUBTITLE PARENTAL 5 DISC MENU PASSWORD 6 PG - R LOCALE SMART NAV 7 NC - 17 PARENTAL DEFAULTS 8 ADULT PASSWORD SMART NAV NO MENU MAIN PAGE
ページ15に含まれる内容の要旨
15 Default Table: WIDE TV DISPLAY MULTI TV TYPE PIC MODE AUTO GENERAL SETUP ANGLE MARK ON OSD LANGUAGE ENGLISH OFF CAPTION SPEAKER SETUP DOWNMIX OFF SPDIF OFF LINE MODE OP MODE DUAL MONO STEREO AUDIO SETUP DRC OFF LPCM 96K LPCM OUTPUT ENGLISH AUDIO SUBTITLE ENGLISH DISC MENU ENGLISH USA LOCALE PREFERENCES PARENTAL NO-PARENTAL PASSWORD 3308 WITH MENU SMART NAV 15
ページ16に含まれる内容の要旨
16 AM GENERAL SPECIFICATIONS: Frequency coverage : 522 to 1620 KHz (Europe Version) : 530 to 1710KHz (USA Version) Power Supply Requirements : DC 12 Volts, Negative Ground IF : 450 KHz Chassis Dimensiions(mm) : 178(W) x 160(D) x 50(H) Sensitivity (S/N = 20 dB) : <35 dBu Tone Controls - Bass (at 100 HZ) : +14dB/-14dB - Treble (at 10 KHZ) : +14dB/-14dB - SUPER
ページ17に含まれる内容の要旨
17 This warranty is in lieu of all other express warranties or liabilities. ANY WARRANTY IMPLIED WARRANTIES, INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY, SHALL BE LIMITED TO THE DURATION 90 DAY / 12 MONTH LIMITED OF THIS WARRANTY. ANY ACTION FOR BREECH OF ANY WARRANTY WARRANTY HEREUNDER INCLUDING ANY IMPLIED WARRANTY OF MERCHANTABILITY MUST BE BROUGHT WITHIN A PERIOD OF 30 DAYS FROM THE DATE OF ORIGINAL AUDIOVOX SPECIALIZED APPLICATIONS, LLC (the Company) PURCHASE. IN NO CASE SHALL THE
ページ18に含まれる内容の要旨
18 www.asaelectronics.com 88-V1621-13 18
