ページ1に含まれる内容の要旨
Remote Start Keyless Entry
Model 1.3X
Owner’s Guide
© 2011 Directed Electronics, Vista, CA
G4202X 2011-03
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Contents Government regulations .................................................................................... iii Warning! Safety first ......................................................................................... v What’s included ................................................................................................1 Important information ........................................................................................1 Your warranty..........................
ページ4に含まれる内容の要旨
Using your system ...........................................................................................19 Locking the vehicle ..................................................................................19 Unlocking the vehicle ..............................................................................19 Valet mode ...........................................................................................20 Panic Mode ...............................................................
ページ5に含まれる内容の要旨
Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection aga
ページ6に含まれる内容の要旨
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interference to services authorized by IC. In addition, the user of this device must accept any radio interference that may be received, even if this interference could affect the operation of the device. Warning: Changes or modifications not expressly
ページ7に含まれる内容の要旨
Warning! Safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage). When parking in an enclosed or partially enclosed
ページ8に含まれる内容の要旨
Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have the neutral safety feature of the vehicle periodically checked, wherein the vehicle must not remotely start while the car is in gear. This testing should be performed by an authorized Directed dealer in
ページ9に含まれる内容の要旨
What’s included • One five-button/2- way Supercode Responder LE remote control • One five-button/1- way Supercode remote • The control module (installed out-of-sight) • Control Center with integrated status LED and Control button • A remote start defeat toggle switch • Window decals • Your warranty registration Important information Congratulations on the purchase of your state-of-the-art remote start and keyless entry system. Due to the complexity of this system, it must be installed b
ページ10に含まれる内容の要旨
Responder LE 2- way remote 8 6 1 2 9 3 AUX 4 7 5 Description Feature 1 Lock button Press for one second to lock. 8 6 1 2 Unlock button Press for one second to unlock. 2 3 Remote start Press for one second to activate remote button star 3 t. AUX 4 Auxiliary Press and hold for 1.5 second to activate 4 7 button optional trunk release. 5 5 Function Allows access to programming and button modifies operation of the other buttons. 6 Label Back of remote has label to identify the re
ページ11に含まれる内容の要旨
8 6 1 2 9 3 AUX 4 7 5 1-way companion remote 8 6 1 2 3 AUX 4 7 5 Note: See call-out table for 2- way remote. © 2011 Directed Electronics. All rights reserved. 3
ページ12に含まれる内容の要旨
➢ Transmitter configuration Basic Advanced Commands Commands Function Function Function Function A U X A U X A U X A U X Level 1 Level 2 Level 3 Level 4 Level Direct Access x 1 x 2 x 3 x 4 Button Lock Silent Lock Unlock Silent Unlock Valet Mode Car Finder Remote Start Reset Runtime Timer Mode Smart Start Rear Defogger A U X A U X A U X A U X AUX Trunk Release AUX 1 AUX 2 AUX 3 AUX 4 Function Cabin Temp. Lock Runtime * Shift** Request** Status** Check** (2- way only) (2- way (2- way only)
ページ13に含まれる内容の要旨
Control Center The Control Center, typically located on the upper part of the front windshield sends and receives commands or messages to and from your system. It consists of: • The In-vehicle system antenna, for 2- way communication to the system. • The Status LED, as a visual indicator of the system’s status. • The Control button, for placing the system into Valet Mode and to per- form the Emergency Override operation. Control Button LED © 2011 Directed Electronics. All rights reser
ページ14に含まれる内容の要旨
Basic commands Lock Command: Press one time to Lock Feedback: Lock LED turns on with 1 beep. Notes: Press/hold for 1.5 seconds to Lock the system and then activate the Panic output* Unlock Command: Press one time to Unlock Feedback: Unlock LED turns on and remote beeps twice. A U X Notes: Remote A U X Start Command: Press one time to activate Remote Start Feedback: Remote Start LED turns on, remote start tones. Notes: Remote Start AUX A U X Command: Press and hold for 1.5 secon
ページ15に含まれる内容の要旨
Function shift A U X Command: Press 1 to 4 times. ( See Function shift table.) Feedback: LED indicators turn on (according to the feature com- mand) Function Shift Notes: Each Press then release, shifts the function of the com- mand button. Feedback is available on the 2- way remote only. *Horn honk is an optional feature. The panic and horn honk feature is avail- able when this option is installed. Pressing more than one button simultaneously generates an error tone and the Function LE
ページ16に含まれる内容の要旨
Advanced commands: function level 1 A U X Silent lock Command: Press one- time and then press . Feedback: Lock LED turns on. A U X Notes: Locks the system without horn honks* A U X Silent unlock Command: Press one- time and then press . A U X Feedback: Unlock LED turns on. Notes: Unlocks the system without horn honks* A U X Runtime reset A U X Command: Press one-time and then . Feedback: Remote start on tones sound, all LEDs light up to indicate start time has been restored. Notes: Re-s
ページ17に含まれる内容の要旨
Advanced commands: function level 2 Valet mode A U X Command: Press two-times and then . A U X Feedback: Remote beeps 1 to 2 times when entering or exiting Valet Mode and unlock LED turns on. Notes: To enter or exit Valet mode, even if Locked. When entering Valet Mode the remote beeps one-time. When exiting Valet Mode the remote beeps two-times. Timer mode A U X A U X Command: Press two-times and then . Feedback: Remote start LED turns on, with 1 beep when enabled and 2 beeps for
ページ18に含まれる内容の要旨
Advanced commands: function level 3 Car finder A U X Command: Press three-times and then . A U X Feedback: The remote emits 1 short beep, the vehicle emits 1 long horn honk*, and the parking lights flash 10 times. Notes: Lock/Unlock cancels the parking light flashes. Smart start A U X A U X Command: Press three-times and then press . Feedback: Remote start LED turns on, with1 beep for enable or 2 beeps for disable. Notes: Enables or disables the Smart Start feature. (see Page 27) Aux
ページ19に含まれる内容の要旨
Advanced commands: function level 4 Rear defogger A U X A U X Command: Press four times, and then . (after remote start is on.) Feedback: Remote start LED turns on, 1 beep. Notes: Manually turns on the defogger when remote start is on. If re- mote start is not active the 2- way responds with an error tone. This is an optional feature. See your authorized Directed dealer for details. Aux 4 A U X Command: Press four times and then press AUX . Feedback: The AUX LED turns on, Aux activatio
ページ20に含まれる内容の要旨
Out of range notification If a command is issued from the remote, but the remote is beyond the range of the vehicle to receive the command, the remote will respond with an out-of range notification. If this occurs, the transmit indicator on the remote flashes rapidly, the key LED turns on, and the remote emits the error tone sounds. Since conditions will vary in different areas (i.e.: Weather, RF interference, etc) range may be affected and require you to be closer to the vehicle for success
