ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
This product complies with the EMC Directives (89/336/EEC, 92/31/EEC) and CE Marking Directive (93/68/EEC). Ce produit est conforme aux directives relatives à la compatibilité électromagnétique (89/336/CEE, 92/31/CEE) et à la directive CE relative aux marquages (93/68/CEE). Dieses Produkt entspricht den EMV-Richtlinien (89/336/EEC, 92/31/EEC) und CE- Markierungsrichtlinien (93/68/EEC). Questo prodotto è conforme alle direttive EMC (89/336/CEE, 92/31/CEE) e alla direttiva sul marchio CE (93/68/CE
ページ3に含まれる内容の要旨
SAFETY INSTRUCTIONS To ensure your personal safety and to maximize the full operating potential of your Drive, read and follow these safety precautions: ENVIRONMENT - Please do not use the unit at places with much dust, high temperature, or high humidity. Please use the unit at a place where it is not subjected to vibrations or shocks. POWER - Turn off your system and attached hardware devices before installation. READ INSTRUCTIONS - Read all safety and operating instructions before the Drive i
ページ4に含まれる内容の要旨
SAFETY INSTRUCTIONS RADIO SIGNAL INTERFERENCE - This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. How
ページ5に含まれる内容の要旨
SAFETY INSTRUCTIONS DO NOT use damaged,cracked, or warped discs. If they break inside the unit, they may damage the optics. The disc in the drive unit ro- tates at high speed. DO NOT use non-standard discs, as these may adversely influence this unit and other equipment. DO NOT play a CD having other shape than a circular disc, such as heart shaped disc, or malfunction may occur. The enclosed device driver is for use with MS-DOS/Windows 3.XX. This driver is not required for use with Windows 95 or
ページ6に含まれる内容の要旨
FEATURES Ö High-speed reading Transfer rate (sustained): maximum 13,500 kBytes/sec. (DVD-ROM) maximum 6,000 kBytes/sec. (CD-ROM) NOTE: The data transfer rate may not be output due to disc conditions (scratches, etc.). Ö High-speed access (Random average): 100 ms (DVD-ROM) 80 ms (CD-ROM) Ö SCSI-2 interface specifications Ö Buffer size: 512 kBytes Ö Applicable discs DVD-ROM (DVD-5, DVD-9) DVD-V DVD-R CD-ROM Mode 1 CD-ROM XA Mode 2 (Form 1, 2) CD-DA CD-R, CD Extra, Video CD, CD-Text support CD-RW/D
ページ7に含まれる内容の要旨
A HARDWARE TOUR Illustrations are provided in this chapter as a visual introduction of the Drive. Please familiarize yourself with these illustrations and refer to them when necessary to complete the installation and operation of the unit. FRONT VIEW DVD-ROM DRIVE 1 PHONES BUSY 4 3 2 5 Fig. 1 1 Disc loading slot Insert the DVD-ROM or CD-ROM with the label facing up. When using 8 cm (3.15-inch) discs, attach a CD adapter (available at stores) to the disc, and insert the disc into the disc loadin
ページ8に含まれる内容の要旨
A HARDWARE TOUR REAR VIEW 49 1 DC INPUT 41 8 1 50 2 +5 G G +12 67 8 9 Fig. 2 6 Audio output This is a connector for output of analog audio. As a Molex 70553 type connecter is used, select a matching connection cable. 7 Function switch Use the accessory short-circuit sockets to set the SCSI ID number and the drive function. Ö ON : put a short-circuit socket Ö OFF : open * The factory setting is ID No. 2. #1 ~ 3 : SCSI ID SCSI-ID Setting switch 0 1 2* 34 56 7 0 (LSB) (#1) OFF ON OFF ON OFF ON
ページ9に含まれる内容の要旨
ページ10に含まれる内容の要旨
CONNECTING THE DRIVE IN THE MIDDLE OF A SCSI CHAIN Sound Board DVD-U04S Audio Cable SCSI HOST Pin 1 Adapter Pin 1 SCSI hard disk SCSI Interface Cable Into an expansion slot of the personal computer To the power supply of the personal computer Fig. 4 When a SCSI hard disk or other SCSI equipment is installed in the computer, please connect according to the following method. ¦ Turn off the power supply of the personal computer. ¦ Set the SCSI ID number so that it is different from the
ページ11に含まれる内容の要旨
CONNECTING THE DRIVE AS THE ONLY SCSI DEVICE Sound Board Audio Cable SCSI HOST Pin 1 Adapter Power Cable SCSI Interface To the power supply of Cable the personal computer Into an expansion slot of the personal computer Fig. 5 When no SCSI hard disk or other SCSI equipment is used, connect according to the following connection method. ¦ Turn off the power supply of the personal computer. ¦ Set the SCSI ID number. ¦ Enable internal SCSI termination (switch #5 = ON). ¦ Connect the powe
ページ12に含まれる内容の要旨
DISC OPERATION DISC SETTING METHOD ¦ Insert the disc into the disc loading slot with the label facing up. Fig. 6 ¦ When using 8 cm/3.15-inch discs, attach a CD adapter (available at stores) to the disc, and insert the disc into the disc loading slot. 8 cm disc CD adapter Fig. 7 Do not insert 8 cm/3.15-inch disc without the CD adapter. Use 8 cm/3.15-inch disc adapters labeled with the ' mark (recommended standard product). Do not use adapters which cause the disc to idle, nor adapters which are
ページ13に含まれる内容の要旨
DISC OPERATION Do not attempt to insert more than two discs at one time, nor insert discs during play. Do not insert the disc with excessive force so that it bends nor attempt to insert it by force. While the unit is pulling in or ejecting discs, do not attempt to do the opposite using force as this may cause damage to the disc or malfunction of the unit. DISC REMOVAL METHOD ¦ Confirm that the BUSY indicator of the drive is not lit, and then press the Eject button (0). ¦ Remove the disc after it
ページ14に含まれる内容の要旨
TROUBLESHOOTING Incorrect operations are often mistaken for trouble and malfunctions. If you think that there is something wrong with this unit, check the points below according to the symptom. If your computer did not start up correctly because the initial diagnostics did not recognize a SCSI device, check these items: ¦ Were all of your SCSI devices plugged in and turned on before you started your computer ? — The Drive and all of the SCSI devices in the daisy chain must be turned on before yo
ページ15に含まれる内容の要旨
SPECIFICATIONS [General functions] Disc diameter 12 cm ( 4.72 in ), 8 cm (3.15 in )* * When using 8 cm discs, attach a CD adapter (available at stores) to the disc. Transfer rate (Sustained) DVD-ROM maximum 13,500 kBytes/sec.* CD-ROM maximum 6,000 kBytes/sec.* * The data transfer rate may not be output due to disc conditions (scratches, etc.). Access time (Random average) DVD-ROM 100 ms CD-ROM 80 ms Data buffer capacity 512 kBytes [Audio output part] Line 0.7 Vrms ± 0.5 Vrms (at 10 kW loa
ページ16に含まれる内容の要旨
ABOUT REGION CODES Region codes are part of the DVD standard. There is a Region number located within one or all of the components required for DVD-VIDEO playback. The Region number defines the region of the DVD-ROM drive and its playback hardware/software. DVD- VIDEO discs may also contain a Region number in the shape of a world globe. Unless the Region number on both the DVD-VIDEO disc and DVD-ROM drive and its playback components match, playback is not possible. When the word “ALL” is located
ページ17に含まれる内容の要旨
AFTER-SALES SERVICE FOR PIONEER PRODUCTS Please contact the dealer or distributor from where you purchased the product for its after-sales service (including warranty conditions) or any other information. In case the necessary information is not available, please contact the Pioneer’s subsidiaries (regional service headquarters) listed below: PLEASE DO NOT SHIP YOUR PRODUCT TO THE COMPANIES at the addresses listed below for repair without advance contact, for these companies are not repair locat
