Harbor Freight Tools Haul-Master Cargo Retaining Bar Adjustable 43569の取扱説明書

ページ1に含まれる内容の要旨

CARGO RETAINING BAR
ADJUSTABLE
ASSEMBLY AND OPERATING INSTRUCTIONS
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
®.
Copyright © 2000 by Harbor Freight Tools All rights reserved. No portion of this manual
or any artwork contained herein may be reproduced in any shape or form without the
express written consent of Harbor Freight Tools.
For technical questions please call 1-800-444-3353
Revised Cover Page

ページ2に含まれる内容の要旨

SPECIFICATIONS (PER UNIT) ITEM DESCRIPTION Construction Mild Steel Tubes Formed Steel Stands Rubber Spacers Finish Bars: Blue Enamel Paint Stands: Chrome Plated Spacers: Black Rubber Net Weight 4.85 Lbs. Bar Diameter 1.105 O.D. Stand Dimensions 2-1/4” W x 3-1/8” L Collapsed Length 38-5/8” L Full Extension Length 74” L Bar Adjusting Capacity 21” Total Adjusting Range (3” Per Hole Increments) Adjusting Bolt Capac

ページ3に含まれる内容の要旨

7. STAY ALERT. Watch what you are doing at all times. Use common sense. Do not operate this product when you are tired or distracted from the job at hand. 8. CHECK FOR DAMAGED PARTS. Before using this product, carefully check that it will operate properly and perform its intended function. Check for damaged parts and any other conditions that may affect its operation. Replace or repair damaged or worn parts immediately. 9. REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identic

ページ4に含まれる内容の要旨

2. Hand screw the two Stands (part #3) inward until they are flush with the ends of Bar A (part #8) and Bar B (part #11). 3 11 2. While firmly holding Bar B with one hand, press in both knobs of the Spring Clamp (part #9) and extend Bar A (part #8) until the Rubber Spacers (part #1) are pressed against the cargo toward the front of the truck bed and against the truck tailgate at the rear end . 3. Release the knobs of the Spring Clamp, and either extend or collapse the length of the Ca

ページ5に含まれる内容の要旨

To Release Cargo Retaining Bar: 1. Twist Bar A and/or Bar B clockwise to screw the Stands inward until they are flush with the ends of Bar A and Bar B. 2. While firmly holding Bar B with one hand, press in both knobs of the Spring Clamp and collapse Bar A into Bar B. MAINTENANCE 1. For better and safer performance, keep all moving parts of this product clean and dry at all times. PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS M

ページ6に含まれる内容の要旨

PARTS DIAGRAM SKU 43569 PAGE 6