ページ1に含まれる内容の要旨
INSTALL INSTRUCTIONS for KK-F-VAK
FORD VAN REAR AIR VENT ADAPTER KIT
TOOLS REQUIRED:
Ratcheting wrench Screwdriver set
Standard & Metric Socket Set Wire cutters
HARDWARE:
QTY DESCRIPTION PART #
1 Heat/Cool Adaptor box assembly KKM01152
1 Ford Rear Air Hose Adapter KKM01153
1 Ford Heat/Cool Box mounting channel KKM99071
10 Hose Clamps 3” GSM20045
2 4” Hose Clamps GSM20042
4’ 4” Diameter Hose
ページ2に含まれる内容の要旨
Remove the hex head screw on Remove the vent cover Remove the hex head lag bolt the vent cover completely. It will not be re-used. located above the blower motor of the OEM rear HVAC unit Remove the hex head lag bolt Remove the hex head screws on Remove the intake cover. holding the intake cover of the the intake cover Intake cover will not be re-used. OEM rear HVAC unit Attach the HVAC hose and View of the components at this Place the unit as shown above clamps to the plenum assem
ページ3に含まれる内容の要旨
Align the assembly so the hole in Attach the (2) #10 x ¾” sheet At the intake side of the OEM the assembly lines up with the “J metal screws at the location unit, attach the hose plate as clip”. Re-attach using the hex shown above. Pre-drill 1/8” hole shown above using (2) #10 x ¾” head lag bolt removed earlier sheet metal screws Tighten the clamp that holds the Attach the intake hose and clamp When routing the hoses, tie together hose to the assembly to the HVAC adapter box using 15” wir
ページ4に含まれる内容の要旨
Route HVAC 2 1/2” blower hoses to Attach the “Y” duct hose adaptor to the approximate locations with tape the 8 foot front duct hose and along ceiling where they will be connect both 4 foot hoses from “Y” installed into the ceiling insert after to vents in driver and passenger side Kwik-Kit insert is installed. Mount front ceiling. This will provide a hoses with wire ties at wall and ceiling total of four ceiling vents. corners only. Leave enough slack to reach hoses for per