Metra Electronics 95-5817の取扱説明書

ページ1に含まれる内容の要旨

INSTALLATION INSTRUCTIONS FOR PART 95-5817
APPLICATIONS
FORD
LINCOLN
Explorer 1995-2001 Continental 1995-1997
Explorer Sport Trac 2001-2005
Mark VIII 1996-1998
Ranger 1995-2009 Town Car 1995-2002
Crown Victoria 1995-2009
MAZDA
Econoline 1997-2008
B-Series Pickup 1995-2009
Escape 2001-2007 MERCURY
Windstar 1999-2003
Grand Marquis 1995-2009
Excursion 2000-2005 Marauder 2003-2004
Super Duty 1999-2004
Mountaineer 1997-2001
Mariner 2005-2007
95-5817
KIT FEATURES
• Double DIN Unit Provision
• Stacke

ページ2に含まれる内容の要旨

95-5817 TABLE OF CONTENTS Dash Disassembly - All Vehicles . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .1 Kit Assembly - Double DIN/Stacked ISO Mount Units Provision . . . . . . . . . . . . . . . . . . 2 Final Assembly . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 *Note: Refer also to the instructions included with the aftermarket radio. KNOWLEDGE IS POWER Enhance your installation and fabrication skills by enrolli

ページ3に含まれる内容の要旨

95-5817 DASH DISASSEMBLY ALL VEHICLES Disconnect the negative battery terminal to prevent an accidental short circuit. 1 2 Using the Metra 86-5618 removal keys, slide the radio out of the radio cavity. Unplug and remove the radio. (Figure A) 3 Cut and remove obstructions in dash cavity. (Be careful not to cut into harnesses or electronic components) Continue to kit assembly. 1

ページ4に含まれる内容の要旨

95-5817 KIT/FINAL ASSEMBLY DOUBLE DIN/STACKED ISO MOUNT UNIT(S) PROVISION *Note: Refer also to the instructions included with the aftermarket radio. NOTE: Sub dash modifications are necessary to use this dash kit. You will need to trim the sub dash to gain suitable depth and height. NOTE: Once the kit is snapped in, it cannot be removed without dash panel removal. A 1 Attach the double DIN brackets to the double DIN or stacked ISO Mount unit(s) using the screws supplied with the unit(s). (Figure

ページ5に含まれる内容の要旨

95-5817 KIT/FINAL ASSEMBLY FINAL ASSEMBLY NOTE: Major sub dash modifications are necessary to use this dash kit. You will need to trim the sub dash to gain suitable depth and height. Continued from page 2. C 4 Slide the double DIN radio or stacked ISO Mount unit assembly into the modified sub dash until it clicks into place. 5 Clip the filler bar into the bottom of the radio opening under the radio assembly with the rounded edges facing toward the dash. Tip: Hook one side in then push the othe

ページ6に含まれる内容の要旨

95-5817 NOTES 4

ページ7に含まれる内容の要旨

95-5817 NOTES 5

ページ8に含まれる内容の要旨

95-5817 INSTRUCTIONS www.metraonline.com 1-800-221-0932 REV. 06/08/10 © COPYRIGHT 2009-10 METRA ELECTRONICS CORPORATION INST95-5817