Korg EasyStart microXの取扱説明書

ページ1に含まれる内容の要旨

EasyStart

















microX Main Features:
microX Main Features:

• Generous 64MB wave ROM with over 1000 of Korg’s best Programs and Combis – THE ULTIMATE HARDWARE

INSTRUMENT FOR ANY SOFTWARE STUDIO!

• 62-note polyphony, dual polyphonic arpeggiators, and a four-part effects processor- the power of Korg’s

HI-Synthesis!
• Small size makes it a great sound module, as well as a portable performance instrument

• 25 full-size, velocity-sensitive ke

ページ2に含まれる内容の要旨

microX EasyStart Making Connections Making Connections 1. Connect the included power supply, power-up the microX, and with the VOLUME all the way down, connect the MAIN OUTPUTS (L/MONO and R) on the back panel to your mixer/amp/monitors/interface. You can also connect a 1/8” headphone jack to the front panel. 2. If you are using the microX as a sound source, or as a controller for another piece of gear, make sure that your MIDI IN/OUT cables are connected properly (IN to OUT, OUT to IN)

ページ3に含まれる内容の要旨

microX EasyStart Note: ClickPoint is useful everywhere in the microX, not just at the Category screen. The basic rule of thumb (or finger, or whatever) is: Navigate to something you want to change, and click on it. Then, moving up or down will change the value. Click once again to go back to navigating. Octave buttons, X/Y Joystick, Knobs Octave buttons, X/Y Joystick, Knobs The sounds in the microX are voiced across an entire 88-key range, and they are very tweakable! Here’s how to ma

ページ4に含まれる内容の要旨

microX EasyStart Multi mode Multi mode The microX is 16-part multitimbral, which makes it a perfect sound module (the fact that it’s not humongous helps, too). Let’s dig into Multi mode and make those MIDI channels work… 1. Press the MULTI button. 2. There are 16 built-in Multi setups that you can use, covering a wide variety of musical styles. Each one has: • Eight voices pre-selected • Pan/Level pre-set for the chosen instruments • Insert effect, 2 master effects, and master EQ pr