ページ1に含まれる内容の要旨
26”/32”/42”
A626N/A632N/A642N
INSTRUCTION MANUAL
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
TABLE OF CONTENT FOR YOUR SAFETY .......................................................................................... 2 PRECAUTIONS AND REMINDERS ............................................................. 3 IMPORTANT SAFETY INSTRUCTIONS ..................................................... 4 PACKAGE CONTENTS ................................................................................... 5 PREPARATION ...................................................................................
ページ4に含まれる内容の要旨
SYMBOL SYMBOL DEFINITION DANGEROUS VOLTAGE: The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of SA 1965 electrical shock to persons. INSTRUCTIONS: The exclamation point within on equilateral triangle to alert the user to the presence of important operating and maintenance (servicing) SA 1966 instruct
ページ5に含まれる内容の要旨
PRECAUTIONS AND REMINDERS Place unit on even surfaces. Unplug immediately if other Do not cover or block foreign materials are put any vents and openings. inside TV box or if the TV Inadequate ventilation fell down. may shorten the life of the display unit and cause overheating. Unplug immediately if is Prohibit/Avoid opening TV Avoid direct sunlight, dusty, malfunction like no picture, cabinet. high humidity and smoky no video/audio, smoke and areas. bad odor from TV. Don't throw any
ページ6に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS Read before operating equipment 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any of the ventilation openings. Install in accordance with the manufacturers instructions. 8. Do not install near an y heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9.
ページ7に含まれる内容の要旨
21. W all or Ceiling Mounting – The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer. 22. P ower Lines – An outdoor antenna should be located away from power lines. 23. Outdoor Antenna Grounding – If an outside antenna is connected to the receiver, be sure the antenna system is grounded to provide some protection against voltage surges and built up static charges. Section 810 of the National Electric Code, ANSI/NFPA No. 70-1984, provides information w
ページ8に含まれる内容の要旨
For 42" model PREPARATION IMPORTANT: Do not apply pressure to the screen display area which may compromise the integrity of the display. The manufacturer’s warranty does not cover user abuse or improper installations. PREPARING YOUR LCD HDTV FOR WALL MOUNTING We suggest that you keep your TV at least 2.36 inches (60 mm) from the wall to prevent cable NOTE interference. Wall mount bracket & screws are not Before mounting your TV on the wall, you need included. to remove the base. Ple
ページ9に含まれる内容の要旨
2. Connect the antenna cable or CATV cable to the aerial socket TV ANTENNA at the back of the TV set. 3. Remote control: Remove the cover of the battery compartment. Insert the 2 batteries supplied (Type AAA 1.5V). 4. Power: Inser t the power cord in the wall socket with AC power supply. You can see LED states at the front panel. If the LED colour is Blue, means the TV set is power on. If the LED colour is Red, which means this TV set is in standby state. 5. Turn the TV on: Pr ess the
ページ10に含まれる内容の要旨
PERIPHERAL CONNECTION GUIDE 26/32 42 ⑭ ⑨ 26/32 AC POWER ① ① ② ③ ② ④ ⑭ ⑫ ⑨ ⑩ ⑪ ⑧ ⑬ ⑦ ③ 42 ④ ⑤ ⑤ ⑥ ⑥ ⑮ ⑫ ⑩ ⑪ ⑧ ⑬ ⑦ ① COMMON INTERFACE (CI) – Conditional Access Module (CAM) use only. Please contact your service provider for details. AV IN – Connect the primary source for composite video devices, such as a ②、③、④ VCR or video game. Use the white and red connectors to connect the external audio from the same source. ⑤ USB – Technician service use only. ⑥ Earphone Output – Connect to the headphone
ページ11に含まれる内容の要旨
1 2 3 4 5 6 7 OPERATING INSTRUCTIONS TO USE THE FRONT PANEL CONTROL 1 VOL + VOL +: Press to increase the sound volume level. 2. VOL - VOL - : Press to decrease the sound volume level. 3. CH ▲ CH ▲: Press to select the next higher Programme number. 4. CH ▼ CH ▼: Press to select the next lower Programme number. 5. MENU Menu key: Press to open or exit the OSD (on-screen display) menu. 6. INPUT Input key: Press to select the input source. Power key: Press to turn on / off (standby) the TV set. (Pres
ページ12に含まれる内容の要旨
TO USE THE REMOTE CONTROL POWER ZOOM Press to turn ON/OFF Select the display aspect from (standby) the TV. Auto, Normal (4:3), Wide (16:9), subtitle, full screen, or SOURCE 14:9 mode. Press repeatedly to choose the various input sources. DUAL Press to select from mono, Number buttons stereo, Dual I, or Dual II. Press to enter TV channel number to select channel. AUDIO ADJ EPG Press to choose from Personal, YPbPr EPG Speech, Music. Press to display the Electronic Programme Guide. VIDEO AD
ページ13に含まれる内容の要旨
EPG YPbPr TELETEXT Vol Press to display or close the Teletext. MIX DUAL Display the Teletext with TV. SIZE Press to change the font size: Full screen, Top half and Bottom half. SUBPAGE MENU /EXIT INFO Display the sub page (when available). INDEX Press to return to page 100 or the index page. SUBTITLE • In TV mode: It works only for turning FAV CH-LIST AD FREEZE on the subtitle and change to the next page marked as subtitle. • In Text mode: Select the next page marked as a subtitle page
ページ14に含まれる内容の要旨
VIEWING MODE ILLUSTRATIONS CONNECTING EQUIPMENT 42" Coaxial (RF) Normal Mode Using Your Antenna or Digital Cable for The original content would be at the centre of the screen. DTV. 26"/32" 1. Turn off the HDTV. 16:9 Content 4:3 Content 2. Connect the coaxial (RF) connector fr om your antenna or cable (out-of-the-wall, not from the Cable Box) to the TV ANTENNA connector at the rear of the HDTV Wide Mode The original content in this mode has to fill the entire screen of the display. 3. Tu
ページ15に含まれる内容の要旨
CONNECTING EQUIPMENT 42" Coaxial (RF) Using Your Antenna or Digital Cable for DTV. 26"/32" 1. Turn off the HDTV. 2. Connect the coaxial (RF) connector fr om your antenna or cable (out-of-the-wall, not from the Cable Box) to the TV ANTENNA connector at the rear of the HDTV 3. Turn on the HDTV. 42" 4. S elect ATV/DTV using the SOURCE button on the remote control or the control key on the side of the TV. Using the Antenna or Cable for your VCR 26"/32" 1. Turn off the HDTV. 2. Connect the co
ページ16に含まれる内容の要旨
4. Select ATV/DTV using the SOURCE button 4. Select HDMI using the SOURCE button on Using Component Video 7. Select YPbPr using the SOURCE button on on the remote control or the control key the remote, side of the HDTV, or directly the remote, side of the HDTV or directly Connecting your HDTV Set-Top Box on the side of the TV. by pressing the HDMI button on the by pressing the YPbPr button on the (Better): Remote Control. Remote Control. 26"/32" NOTE NOTE NOTE If you have an off-air
ページ17に含まれる内容の要旨
Using Component Video 7. Select YPbPr using the SOURCE button on the remote, side of the HDTV or directly Connecting your HDTV Set-Top Box by pressing the YPbPr button on the (Better): Remote Control. 26"/32" NOTE Ref er to your HDTV Set-Top Box user manual for more information about the video output requirements of the product or consult your cable or satellite operator. Connecting Your Basic Set-Top Box 42" Using Composite Video 1. T urn off the HDTV and HDTV Set-Top Box. 1. Turn
ページ18に含まれる内容の要旨
Using Coax (RF) Connecting your DVD Player (Best) 26"/32" 26"/32" 42" 42" 1. Turn off the HDTV and DVD player. 1. T urn off the HDTV and Set-Top Box. 2. Connect a HDMI cable to the HDMI output 2. Using a Coax (RF) cable, connect one end of your DVD player and the other end to to the TV OUT (RF) on your Set Top Box the HDMI Input at the rear of the HDTV. and the other end to the TV input at the rear of the HDTV. 3. Turn on the HDTV and DVD player. 3. T urn on the HDTV and Set-Top Box. 4.
ページ19に含まれる内容の要旨
Using Component Video 7. Select YPbPr using the SOURCE button on the remote, side of the HDTV or directly Connecting your DVD Player (Better) by pressing the YPbPr button on the Remote Control. 26"/32" NOTE Refer to your DVD player user manual for more information about the video output requirements of the product. Using SCART Connecting your DVD Player (Good): 42" 26"/32" 1. Turn off the HDTV and DVD player. 42" 2. Connect the Pr (r ed colour) connector on your DVD player to the co
ページ20に含まれる内容の要旨
Using Composite (AV) Video 1. Turn off the HDTV and VCR or Video Camera. 2. Connect the SCART socket of your VCR Connecting your DVD Player (Good) or Video Camera to the SCART socket of the HDTV. 3. Turn on the HDTV and VCR or Video Camera. 4. Select AV using the SOURCE button on the remote, side of the HDTV or directly by pressing the VIDEO button on the Remote Control. NOTE 1. Turn off the HDTV and DVD player. Refer to your VCR or Video Camera user 2. C onnect the Video (yellow
