Hisense Group PDP5010EUの取扱説明書

ページ13に含まれる内容の要旨

ページ14に含まれる内容の要旨

ページ15に含まれる内容の要旨

ページ16に含まれる内容の要旨

Using the TV features Teletext Operations ENTER TELETEXT MODE Select the channel that is broadcasting the desired Teletext program. Press < Text> button on the remote control to enter the Teletext mode ,and press the same button quit the Teletext mode.. Note:1)All the operations the below should be under the Teletext mode. 2)There are some multiplex buttons on the remote control for Teletext operation. PAGE SELECTION You can directly input your desired page number by pressing <0>~<

ページ17に含まれる内容の要旨

ページ18に含まれる内容の要旨

Appendix Troubleshooting Before calling a service technician, please check the following table for a possible cause of the problem and some solutions. Possible Solutions Symptoms Make sure the power cord is plugged in, then press . TV will not turn on The remote control batteries may be dead. Replace the batteries. Check if you have set the off timer. No picture, no sound Check the antenna/cable connections. Press [Display] to see if you have select the right signal source. The sound ma

ページ19に含まれる内容の要旨

Specifications 50 INCHES PDP Diagonal display size Television system Multi- standard(PAL,SECAM) VHF-L: E2-S8 Channel coverage VHF-H: S9-S37 UHF: S38-E69 1366 X76 8 Res olut ion 2500:1 Contrast 2 1000cd/m Brig htne ss o o 170(H)/170(V) Viewing angles AC100V--240V, 50/60Hz Power source Power consumption 500W 7W+7W Audio output RF input: Cable/ Antenna RF 1 VIDEO input: VIDEO 1 YPbPr/YCbCr 1 Connection interface GRAPHIC in