ページ1に含まれる内容の要旨
Remote Start Keyless Entry
Model 5101
Owner’s Guide
© 2009 Directed Electronics, Vista, CA
G4102V 2009-08
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
Contents Government regulations .................................................................................... iii Warning! Safety first ......................................................................................... v What’s included ................................................................................................1 Important information ........................................................................................1 Your warranty..........................
ページ4に含まれる内容の要旨
Using the remote start ......................................................................................17 Manual transmission vehicles ...................................................................18 Timer mode ............................................................................................19 Turbo timer mode ....................................................................................20 Smart start activation ........................................................
ページ5に含まれる内容の要旨
Government regulations This device complies with Part 15 of FCC rules. Operation is subject to the fol- lowing two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesirable operation. This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection aga
ページ6に含まれる内容の要旨
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its use is authorized only on a no-interference, no-protection basis; in other words, this device must not be used if it is determined that it causes harmful interference to services authorized by IC. In addition, the user of this device must accept any radio interference that may be received, even if this interference could affect the operation of the device. Warning: Changes or modifications not expressly
ページ7に含まれる内容の要旨
Warning! Safety first The following safety warnings must be observed at all times: Due to the complexity of this system, installation of this product must only be performed by an authorized Directed dealer. When properly installed, this system can start the vehicle via a command signal from the remote control transmitter. Therefore, never operate the system in an enclosed area or partially enclosed area without ventilation (such as a garage). When parking in an enclosed or partially enclosed
ページ8に含まれる内容の要旨
Use of this product in a manner contrary to its intended mode of operation may result in property damage, personal injury, or death. (1) Never remotely start the vehicle with the vehicle in gear, and (2) Never remotely start the vehicle with the keys in the ignition. The user must also have the neutral safety feature of the vehicle periodically checked, wherein the vehicle must not remotely start while the car is in gear. This testing should be performed by an authorized Directed dealer in
ページ9に含まれる内容の要旨
What’s included • Two five-button/1-way Supercode remotes • The control module (installed out-of-sight) • Control Center with integrated status LED and Control button • A remote start defeat toggle switch • Window decals • Your warranty registration Important information Congratulations on the purchase of your state-of-the-art remote start and keyless entry system. Due to the complexity of this system, it must be installed by an authorized dealer only. Installation of this product by an
ページ10に含まれる内容の要旨
+ + ➢ System maintenance The system requires no specific maintenance. Your remote is powered by a small coin cell lightweight 3-volt lithium battery that lasts approximately one year under normal use. The remote uses one CR2032 cell battery. When the battery begins to weaken, the operating range is reduced. ➢ Low battery indicator When the battery is low on the remote the vehicle system emits an additional honk when unlocking to let you know it is time to change the battery. Note: The optio
ページ11に含まれる内容の要旨
+ + 2. Turn both the unit front and circuit board over, remove battery from clip and replace. Note: Verify that the bat- tery polarity is correct when replacing. 3. Reposition all parts and snap together. ➢ Two car operation You can use the remote control system for two cars, with full command capabil- ity for both vehicles. To change the car selection: A U X • Press and hold the button for 3 seconds until the amber LED blinks once or twice indicating the current vehicle: One blink: Ca
ページ12に含まれる内容の要旨
1-way remote 1 2 3 4 A U X 5 6 Description Feature 1 Transmit indicator 2 Lock button Press for one second to lock. 3 Unlock Press for one second to unlock. button 4 Remote start Press for one second to activate remote button start. 5 Auxiliary Press and hold for 1.5 second to activate button optional trunk release. 7 1 6 Function button Allows access to programming and modi- fies operation of the other buttons. 2 8 3 Note: If Keypad Lock is On, press and then press to unlock. 4 A U X 5
ページ13に含まれる内容の要旨
➢ Transmitter configuration Basic Advanced Commands Commands Function Function Function Function A U X A U X A U X A U X Level 1 Level 2 Level 3 Level 4 Level Direct Access x 1 x 2 x 3 x 4 Button Lock Silent Lock Unlock Silent Unlock Valet Mode Car Finder Remote Start Reset Runtime Timer Mode Smart Start Rear Defogger A U X A U X A U X A U X Trunk Release AUX 1 AUX 2 AUX 3 AUX 4 A U X Function Shift * A U X *Used to access function levels for Advanced Commands ( with multiplier in third r
ページ14に含まれる内容の要旨
Control Center The Control Center, typically located on the upper part of the front windshield sends and receives commands or messages to and from your system. It consists of: • The In-vehicle system antenna, for 1-way communication to the system. • The Status LED, as a visual indicator of the system’s status. • The Control button, for placing the system into Valet Mode and to per- form the Emergency Override operation. Control button LED © 2009 Directed Electronics. All rights reserved
ページ15に含まれる内容の要旨
Basic commands ➢ Lock Command: Press one time to Lock. Notes: Press/hold for 1.5 seconds to lock the system and then activate the Panic output. For Panic to work, the optional horn honk feature must be connected. ➢ Unlock A U X Command: Press one time to Unlock. ➢ Remote Start A U X Command: Press one time to activate Remote Start. A U X ➢ Aux (trunk) A U X Command: Press and hold for 1.5 seconds to open trunk. A U X ➢ Function shift Comma
ページ16に含まれる内容の要旨
Advanced commands: function level 1 ➢ Silent lock A U X Command: Press one- time and then press Notes: Locks the system without horn honks* A U X ➢ Silent unlock A U X Command: Press one- time and then press . A U X Notes: Unlocks the system without horn honks* * Horn honk is an optional feature. The panic feature is also available when this option is installed. ➢ Runtime reset A U X A U X Command: Press one-time and then . Notes: Re-starts the remote start runtime counter if remote s
ページ17に含まれる内容の要旨
ALL Advanced commands: function level 2 ➢ Valet mode A U X Command: Press two-times and then . A U X Notes: Prevents the system from automatically activating the Failsafe Starter Kill and locking the door passively. ➢ Timer mode A U X Command: Press two-times and then . Notes: Enables or disables the remote start timer mode. The parking lights flash fast 4 times when turned on, and flash slowly 4 times when timer mode is off. ➢ Aux 2 A U X A U X Command: Press two times and then p
ページ18に含まれる内容の要旨
Advanced commands: function level 3 ➢ Car finder A U X Command: Press three-times and then . A U X Notes: The vehicle emits 1 long horn honk and the parking lights flash 10 times. Lock/Unlock cancels the parking light flashes. ➢ Smart start A U X A U X Command: Press three-times and then press . Notes: Enables or disables the Smart Start feature. The parking lights flash fast 5 times when turning on, and flash slowly 5 times when the feature is off. ➢ Aux 3 A U X AUX Command: Press
ページ19に含まれる内容の要旨
Advanced commands: function level 4 ➢ Rear defogger* A U X A U X Command: Press four times, and then . (after remote start is on.) Notes: Manually turns on the defogger when remote start is on. ➢ Aux 4 A U X AUX Command: Press four times and then press . Notes: Activates or deactivates optional Aux 4. See your authorized Directed dealer for details. *Additional parts and labor may apply. © 2009 Directed Electronics. All rights reserved. 11
ページ20に含まれる内容の要旨
Using the system ➢ Locking the vehicle To lock the vehicle, press the button on the remote control. The horn in the vehicle honks one-time, and the parking lights flash one-time. If the power door locks are connected, the doors lock and the optional Failsafe Starter Kill activates. The system automatically checks for errors when it locks. If errors are found when locking: If the door is open when you lock the vehicle, the horn honks once and the parking lights flash. The horn then honks a s
