ページ1に含まれる内容の要旨
700 lbs High Lift Telescopic
Transmission Jack
Operating Instructions & Parts Manual
BH7000
SFA Companies ©2005
10939 N. Pomona Ave. Kansas City, MO 64153
816-891-6390
sales@blackhawk-automotive.com
- Before using this product, read this manual and follow all its Safety Rules and Operating Instructions
Made in PRC
ページ2に含まれる内容の要旨
ONE YEAR LIMITED WARRANTY For a period of one (1) year from date of purchase, SFA Companies will repair or replace, at its option, without charge, any of its products which fails due to a defect in material or workmanship under normal usage. This limited warranty is a consumer's exclusive remedy. Performance of any obligation under this warranty may be obtained by returning the warranted product, freight prepaid, to SFA Companies Warranty Service Department, 10939 N. Pomona Ave., Kansas City,
ページ3に含まれる内容の要旨
SAVE THESE INSTRUCTIONS For your safety, read, understand, and follow the information provided with and on this jack. The owner and operator of this equipment shall have an understanding of this jack and safe operating procedures before attempting to use. The owner and operator shall be aware that use and repair of this product may require special skills and knowledge. Instructions and safety information shall be conveyed in the operator's native language before use of this jack is authorized. I
ページ4に含まれる内容の要旨
ASSEMBLY Refer to Figure 1 & 2: 1. Attach the base halves (#1) to the upright post (#2), then secure using bolt rods, washers and M12 nuts (#3, 4 & 5) provided. 2. Attach all four casters (#6) to the base halves (#1) using the washers and M12 nuts (#4 & 5) provided. 3. Place hydraulic unit (#7) on top of the upright post (#2) and secure with M10x25 bolts and washers (#8 & 9). 4. Attach saddle assembly (#10) above the ram of hydraulic unit (#7) using pin and spring pin (#11 & 12). 5. Attach all
ページ5に含まれる内容の要旨
OPERATION Raise saddle: ! WARNING 1. Turn release valve clockwise until firm. Pump handle until load is contacted. To avoid crushing and related 2. Follow vehicle manufacturers recommended injuries: NEVER work on, under or procedures for removing the load as outlined in vehicle around a load supported only service manual or repair guide. by a jack. Immediately 3. Secure load with provided chains. Ensure load's center transfer the load to an of gravity is centered on the saddle and load is stabl
ページ6に含まれる内容の要旨
TROUBLESHOOTING Corrective Action Symptom Possible Causes • Release valve not tightly closed • Ensure release valve tightly closed Jack will not lift load • Overload condition • Remedy overload condition • Release valve not tightly closed • Ensure release valve tightly closed Jack bleeds off after lift • Overload condition • Remedy overload condition • Hydraulic unit malfunction • Contact Blackhawk Tech. Service Jack will not lower after unloading • Reservoir overfilled • Drain fluid to prope
ページ7に含まれる内容の要旨
REPLACEMENT PARTS Not all components of the jack are replacement items, but are illustrated as a convenient reference of location and position in the assembly sequence. When ordering parts, give Model number, parts number and description. Call or write for current pricing: SFA Companies 10939 N. Pomona Ave. Kansas City MO 64153, U.S.A. Tel:(816) 891-6390 Fax: (816) 891-6599 E-Mail: sales@blackhawk-automotive.com BH7000 Replacement parts Item Part# Description
ページ8に含まれる内容の要旨
memo.
