DeWalt D514302の取扱説明書

ページ1に含まれる内容の要旨

9. Ensure top gasket (J) is properly
placed between the top cap and
frame before fastening the top cap.
10. Replace top cap (A) and fasten 4
J
screws with a 4 mm Allen wrench.
11. Tighten screws snugly to prevent
leaks.
12. Ensure trigger and contact trip are
D514302 - 7/16" Piston/Driver Assembly
working smoothly.
Instructions
13. Set pressure on compressor or air
FOR USE WITH THE D51430 MEDIUM CROWN STAPLER
line at 80 psi.
If you should have difficulty understanding the following instruc-
14.

ページ2に含まれる内容の要旨

5. Dégager le sous-ensemble piston/enfonceur (C), le cylindre (D), la PARA CAMBIAR LA UNIDAD butée (E), la plaque de butée (F) et la cloison (G) de l’outil. 1. Desconecte el aire antes de efectuar 6. Lubrifier le joint torique (H) de l’ensemble piston/enfonceur en util- reparaciones o servicio a la herra- isant la graisse fournie. mienta. 2. Saque todos los clavos del cartucho y B A de la nariz antes de efectuar repara- E ciones o servicio. C 3. Quite los 4 tornillos de la tapa superi- or (A) co