ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
SAFETY PRECAUTIONS The following marks and symbols are located on The lightning flash with an arrowhead symbol, within the equilateral triangle, is back of the unit. intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within the equilateral triangle is intended to alert the user to the presence of important operating and maintenance
ページ3に含まれる内容の要旨
SAFETY PRECAUTIONS FCC Information This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) This device must accept any interference received, including interference that may cause undesired operation. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable
ページ4に含まれる内容の要旨
IMPORTANT SAFETY INSTRUCTIONS 1. Read these instructions. 2. Keep these instructions. 3. Heed all warnings. 4. Follow all instructions. 5. Do not use this apparatus near water. 6. Clean only with a dry cloth. 7. Do not block any of the ventilation openings. Install in accordance with the manufacturer's instructions. 8. Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including amplifiers) that produce heat. 9. Do not defeat the safety purpose
ページ5に含まれる内容の要旨
TABLE OF CONTENTS Safety Precautions .............................................. 1 - 2 Repeat Playback .................................................... 19 Important Safety Instructions ................................. 3 DVD Programmable Memory ................................ 20 Table of Contents ..................................................... 4 DVD Programmable Memory ........................... 20 Disc Formats ............................................................ 5 Viewing
ページ6に含まれる内容の要旨
DISC FORMATS The unit can play DVDs [8cm/12cm disc] Compatible Audio CDs [8cm/12cm disc] Region Management Information Region Management Information: This unit is designed and manufactured to respond to the Region Management Information that is encoded on DVDs. If the region number printed on the DVD does not correspond to the region number of this unit, this unit cannot play that disc. The region number of this unit is 1. Disc Function or Operation that is Not Available When the “ ” symbol appe
ページ7に含まれる内容の要旨
ACCESSORIES Please Check and Identify the Included Accessories. Remote control ............................................................................................................................. x 1 AAA 1.5V battery .......................................................................................................................... x 2 Mounting template ......................................................................................................................... x 1 1.0
ページ8に含まれる内容の要旨
CONTROL REFERENCE GUIDE Remote Control 1) MUTE Button Press to turn off the sound. 2) STANDBY/ON Button Turns on the unit and puts it in standby 1 mode. STANDBY/ON MUTE FUNCTION 3) DISPLAY Button 2 Changes disc status information 3 PICTURE DISPLAY GOTO SUBTITLE displayed on the screen. 4 4) PICTURE Button ANGLE RETURN AUDIO SOUND Selects from preset screen display 5 settings to match the type of show you are watching. 6 EXIT MTS DVD MENU TV MENU 5) ANGLE Button 7 During DVD playback, switch the
ページ9に含まれる内容の要旨
CONTROL REFERENCE GUIDE Remote Control FUNCTION Button 15) Use to select DVD, TV or RADIO mode. 16) GOTO Button Goes directly to a location on a DVD/CD. SUBTITLE Button 17) Selects one of the subtitle languages MUTE STANDBY/ON FUNCTION programmed on a DVD. 18) SOUND Button 15 Press to select from preset sound 16 PICTURE DISPLAY GOTO SUBTITLE settings to match the type of show you 17 are watching. 19) AUDIO Button ANGLE RETURN AUDIO SOUND Selects audio soundtracks of a DVD or 18 change the output
ページ10に含まれる内容の要旨
CONTROL REFERENCE GUIDE Unit 12 3 4 5 6 78 9101112 13 14 15 16 17 1) Disc Tray 10) DVD/TV/RADIO Button Opens or closes the tray by pressing OPEN/ Use to select DVD, TV or RADIO mode. CLOSE button. 11) TIMER Button Use to set the cooking timer. Place a disc on the disc tray, label side up. 2) Display Window 12) PREV/ NEXT/ ADJUST Buttons Displays system information. PREV Button 3) POWER ON Indicators Press to go back to previous chapters/ tracks. DVD : DVD indicator NEXT Button TV : TV indic
ページ11に含まれる内容の要旨
MOUNTING INSTRUCTIONS TOOLS NEEDED: 1) Electric drill with 1/4” bit; 2) Phillips-head (cross style) screwdriver. STEP 1 STEP 3 If your cabinet does NOT have an overhang: If your cabinet does NOT have an overhang: a)Place the Mounting Template in the desired a)Eight screws are included with this unit, but location inside or underneath the cabinet you will only need four of them. Select the (whichever has less obstructions, and will be screw length which will go completely through easier for you
ページ12に含まれる内容の要旨
MOUNTING INSTRUCTIONS (Continued from previous page) e) Partially tighten each screw, but do not fully tighten the screws until all of them have been c) Insert the four selected screws through each started (see Figure 6). hole from the inside of the cabinet going down (see Figure 5). Figure 6 Figure 5 d) Hold each screw head down and push the unit f) Gently tighten each screw until they are firmly and spacers onto the screws, then hold the holding the unit in place. The top front edge of unit up
ページ13に含まれる内容の要旨
CONNECTIONS Connecting the TV Antenna Connect a TV antenna or CATV cable or Satellite system to the TV antenna terminal. TV antenna To the TV ANT 2 IN terminal 1 Connecting the Unit to a TV or other Video Equipment Use the Video cable (not supplied). Connect the VIDEO OUT on the rear of the unit to the VIDEO IN on your TV or other video equipment. TV or other Video Equipment (yellow) VIDEO IN Video cable (not supplied) Connecting the AM LOOP Antenna and FM Wire Antenna Connect the AM LOOP antenn
ページ14に含まれる内容の要旨
CONNECTIONS Plugging in the Unit Plug the AC power cord into the wall outlet a) Before plugging in the power cord, make sure the voltage of the unit matches your local voltage. b) Plug the power cord directly into the nearest wall outlet, and wrap the remaining cord around the cord storage knob at the rear of the unit. CAUTION: TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF PLUG TO WIDE SLOT OF WALL OUTLET, THEN FULLY INSERT. AC power cord To AC outlet MONITOR OPERATION Follow the illustrations
ページ15に含まれる内容の要旨
UNIT OPERATION Turning the Unit On While the power cord is connected and the unit is on standby, power will be consumed and only the clock display will flash. Press the ON/OFF button to turn the unit on and the DVD indicator lights up. After a short period of time, “DVD” will appear on the front display and the DVD logo (start-up picture) will appear on the screen. Press the DVD/TV/RADIO button (the FUNCTION button on the remote control) to TV mode and the TV indicator lights up. After a sh
ページ16に含まれる内容の要旨
SETTING THE CLOCK To adjust the clock, the unit must be in standby mode. To enter standby mode, make sure that the unit is plugged in, but not turned on. Check that the rated voltage of the unit matches your local voltage. 1. When the AC power cord is plugged in, the clock 3. Press the / buttons to set the current display will blink. hours then press the SET CLOCK button once to confirm. Then, the MINUTE blinks. 2. Press the SET CLOCK button until the HOUR 4. Press the / buttons to set th
ページ17に含まれる内容の要旨
PLAYING A DISC This owner’s manual explains the basic instructions of this unit. Some DVDs are produced in a manner that allows specific or limited operation during playback. Such as, the unit may not respond to all operating commands. This is not a defect in the unit. Refer to the instruction notes of discs. “ ” may appear on the screen during operation. A “ ” means that the desired operation is not permitted by the unit or disc. Playing a Disc 1. Press the ON/OFF button to turn on the unit.
ページ18に含まれる内容の要旨
PLAYING A DISC Angle Selection Some DVDs contain scenes which have been shot from a number of different angles. For these discs, the same scene can be viewed from each of these different angles. 1. While you are playing a DVD with different angles recorded, press the ANGLE button to view the num- Sequence of angle shots ber of current angles available. (Example) 2. Press the ANGLE button repeatedly to change the scene to the next angle in those recorded. About two seconds later, playback conti
ページ19に含まれる内容の要旨
PLAYING A DISC Display Function While the disc is playing, press the DISPLAY button on the remote control repeatedly to display information on operation status. Time: The elapsed time from the beginning of the title which is currently playing. Title/Chapter: The number of the title/chapter currently playing and total titles/chapter on disc. Audio: The type of the audio currently selected is displayed. Subtitle: The subtitle number and language currently selected is displayed. When a disc with on
ページ20に含まれる内容の要旨
SPECIAL FUNCTION Setting Favorite Bookmarks During Playback While a disc is playing, you can mark the desired scene. 1. Press the GOTO button until Bookmark1 appears. 2. Press the ENTER button to mark the desired scene and the time of this point will be shown in Bookmark1. 3. Press the ENTER button to play the favorite bookmark. To Set Other Bookmarks 1. Press the GOTO button until Bookmark1 appears, then use the or button on the remote to select Bookmark2/Bookmark3. 2. Press the ENTER button.
