ページ1に含まれる内容の要旨
B. REGULATOR INSTALLATION
Note: Remove left access panel above left rear
shock tower (note wing-type nuts).
1. To form brackets for mounting regulator use
(Fig. 7) template. Refer to Owner's Manual on
Regulator Installation for bracket attachment
to regulator.
2. Trirn..il1sulation away from bracket on side of
left shock tower.
3. Align regulator brackets with lower edge of
shock tower bracket. Mark and drill 2, 3/16"
holes. Install regulator using 1/4-14 self-tapping
screws. Fig. 2
4. Route reg
ページ2に含まれる内容の要旨
.rap 5. Attach~bead chain connector to existing throttle as shown in Fig. 3. D. WIRING HARNESS 1. Installation of the wiring harness requires a harness extension part #250-4166. This is due to the engine distance from the fuse panel, brake light switch and control switch. 2
ページ3に含まれる内容の要旨
2. Remove Console .a. Lift out ash trays. remove 2 -7 mm screws from each (under ash trays). Note: This part of the console only needs to be lifted a few inches. Do not pullover gear lever. b. Loosen 2 -7 mm screws at the front of main console. Open glove box, remove 2 -7 mm screws. Lift out console. Note: Use caution upon removal not to damage wiring that is attached to the cigarette lighter. Glove Box Loosen two 7 mm Screws ./ ?~ Removetwo 7 mm .Screws ~ ., ~--"-~--~-:~: Fig. 5 Ash Tray, one o
ページ4に含まれる内容の要旨
Fig.7 Fig.8 4
ページ5に含まれる内容の要旨
E. VACUUM TYPE SYSTEM 1. To install vacuum type system on vehicle follow illustration as shown below. Refer to Owner's Manual for remaining installation. 1st -/HOle Servo- Assembly / Shock ~. /TOWer - '\ \-.- '- To Vacuum Source ---c: ,~ / ---11 ~ ~ 3116" Hole (2) SERVO R~:~~~~ ~ BRACKET Servo Bracket TEMPLATE 3rd Hole F. ELECTRONIC REGULATOR AND HARNESS EXTENSION 1. Follow same procedure as mentioned in Section D, except Electronic Regulator is mounted as shown in console. Regulator , - rC- l!f