ページ1に含まれる内容の要旨
ISSUE EMD-EU2089
MODEL
RU
2ZZ9990082
PRINTED IN JAPAN
March 2005 CE-
ページ2に含まれる内容の要旨
WARNING: The engine exhaust from this product contains chemicals known to the State of California to cause cancer, birth defects or other reproductive harm. NOTICE FEDERAL EMISSION COMPONENT DEFECT WARRANTY and CALIFORNIA EMISSION CONTROL WARRANTY are applicable to only those engines complied with EPA (Environmental Protection Agency) and CARB (California Air Resources Board) emission regulations in the U.S.A. NOTICE To the engines exported to and used in the countries other than the U.S.A., wa
ページ3に含まれる内容の要旨
FEDERAL EMISSIONS COMPONENT DEFECT WARRANTY EMISSIONS COMPONENT DEFECT WARRANTY COVERAGE - This emission warranty is applic- able in all States, except the State of California Fuji Heavy Industries Ltd. and Robin America Inc., Wood Dale Illinois, (herein "ROBIN AMERICA") warrant(s) to the initial retail purchaser and each subsequent owner, that this Nonroad engine (herein "engine") has been designed, built, and equipped to conform at the time of initial sale to all applicable regulations of the
ページ4に含まれる内容の要旨
*The replacement parts used for required maintenance services. *Consequential damages such as loss of time, inconvenience, loss of use of the engine or equip- ment, etc. *Diagnosis and inspection charges that do not result in warranty-eligible service being performed. *Any non-authorized replacement part, or malfunction of authorized parts due to use of non-autho- rized parts. OWNER'S WARRANTY RESPONSIBILITIES As the engine owner, you are responsible for the performance of the required mainten
ページ5に含まれる内容の要旨
CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONS The California Air Resources Board and Fuji Heavy Industries Ltd. (herein "FUJI") are pleased to explain the emission control system warranty on your 2005 and later Small Off-Road engine (herein "engine"). In California, new engine must be designed, built and equipped to meet the State's stringent anti-smog standards. FUJI must warrant the emission control system on your engine for the periods of time described
ページ6に含まれる内容の要旨
LIMITED WARRANTY on Emission Control Systems - California Only - FUJI warrants to the owner of the 2005 and later engine that the engine (1)has been designed, built and equipped so as to conform at the time of manufacture with the applicable regulations of the California Air Resources Board, and (2) is free from defects in materials and workmanship that could cause it to fail to conform with those regulations as may be applicable in the terms and conditions stated below. A. COMMENCEMENT DATE Th
ページ7に含まれる内容の要旨
(4) repairs performed outside of the authorized warranty service dealers (5) use of parts which are not authorized by FUJI. 2. Add-on or modified parts This warranty does not cover any part that malfunctions, fails or is damaged due to alter- ations by changing, adding to or removing parts from the engine. 3. Expenses incurred by processing warranty claims FUJI, any authorized service dealer and warranty station shall not be liable for any loss of use of the engine, for any alternative usage, f
ページ8に含まれる内容の要旨
(5) Miscellaneous Items Used in Above Systems (i)Electronic controls, if applicable (ii)Hoses, belts, connectors, and assemblies. (iii) Filter lock assy (gaseous fuel, if applicable) I. MAINTENANCE STATEMENTS It is your responsibility to have all scheduled inspection and maintenance services performed at the times recommended in the 2005 and later Owner's Manual and to retain proof that inspection and maintenance services are performed at the times when recommended. FUJI will not deny a warrant
ページ9に含まれる内容の要旨
FOREWORD Thank you very much for purchasing a ROBIN ENGINE. Your ROBIN ENGINE can supply the power to operate various sorts of machines and equipment. Please take a moment to familiarize yourself with the proper operation and maintenance procedures in order to maximize the safe and efficient use of this product. Due to constant efforts to improve our products, certain proce- dures and specifications are subjected to change without notice. When ordering spare parts, always give us the MODEL, SP
ページ10に含まれる内容の要旨
CONTENTS 1.SAFETY PRECAUTIONS 1 2. COMPONENTS 4 3. PRE-OPERATION CHECKS 7 4. OPERATING YOUR ENGINE 8 5. EASY TROUBLESHOOTING 10 6. MAINTENANCE SCHEDULE 11 7. "HOW-TO" MAINTENANCE 13 8. PREPARATIONS FOR STORAGE 17 9. SPECIFICATIONS 18
ページ11に含まれる内容の要旨
SYMBOLS Read the owner's manual. Stay clear of the hot surface. Exhaust gas is poisonous. Do not operate in an unventilated area. Stop the engine before refueling. Fire, open flame and smoking prohibited. Plus ; On (Run) positive polarity Off (Stop) Battery Engine start Engine oil (Electric start) Add oil ENGLISH (US)
ページ12に含まれる内容の要旨
1. SAFETY PRECAUTIONS Please make sure you review each precaution carefully. Pay special attention to statement preceded by the following words. WARNING “WARNING” indicates a strong possibility of severe personal injury or loss of life if instructions are not followed. CAUTION “CAUTION” indicates a possibility of personal injury or equipment damage if instructions are not followed. WARNING : EXHAUST PRECAUTIONS Never inhale exhaust gasses. They contain carbon monoxide, a colorless, odorless
ページ13に含まれる内容の要旨
WARNING : OTHER SAFETY PRECAUTIONS Place the protective covers over the rotating parts. If rotating parts such as the drive shaft, pulley, belt, etc. are left exposed, they are potentially hazardous. To prevent injury, equip them with protective covers or shrouds. Be careful of hot parts. The muffler and other engine parts become very hot while the engine is running or just after it has stopped. Operate the engine in a safe area and keep children away from the running engine. Do not touch th
ページ14に含まれる内容の要旨
CAUTION : PRE-OPERATION CHECKS Carefully check fuel hoses and joints for looseness and fuel leakage. Leaked fuel creates a potentially dangerous situation. Check bolts and nuts for looseness. A loose bolt or nut may cause serious engine trouble. Check the engine oil and refill if necessary. Check the fuel level and refill if necessary. Take care not to overfill the tank. Keep cylinder fins and recoil starter free of dirt, grass and other debris. Wear snug fitting working clothes when oper
ページ15に含まれる内容の要旨
2. COMPONENTS EH025 Plug cover Air cleaner Stop switch Clutch Fuel tank cap P.T.O. Shaft Fuel tank A Type P Type (Pump) Choke lever Carburetor Muffler Primer pump Oil gauge ( ) Oil filler Starter handle Engine serial No. Recoil starter - 4 - ENGLISH (US)
ページ16に含まれる内容の要旨
EH035 Plug cover Air cleaner Clutch Fuel tank cap Fuel tank P.T.O. Shaft A Type Carburetor P Type (Pump) Choke lever Primer pump Muffler Starter handle Oil gauge (Oil filler) Recoil starter - 5 -
ページ17に含まれる内容の要旨
EH035V Fuel tank cap Fuel upper level Oil upper level Fuel tank Oil drain screw Spark plug (Plug cap) Muffler Carburetor Choke lever Primer pump Starter handle Air cleaner Oil gauge (Oil filler) Clutch Fuel tank Fuel tank cap Recoil starter - 6 - ENGLISH (US)
ページ18に含まれる内容の要旨
3. PRE-OPERATION CHECKS CHECK ENGINE OIL Oil gauge Before checking or refilling engine oil, be sure the engine is located on a stable, level surface and stopped. Do not thread the gauge into oil filler to check oil level. Upper level If the oil level is below the lower level Lower level line on the dipstick, refill with the proper oil (see table) up to the upper level (up to the point of overflowing the filler neck). OIL CAPACITY EH025 : 80 mL 5W EH035 : 100 mL 10W (EH035V) Before filling o
ページ19に含まれる内容の要旨
4. OPERATING YOUR ENGINE STARTING STOP SWITCH PRIMER PUMP 1 3 ON ON OFF Set the throttle lever to the idling position. If the stop switch is installed on the engine.Set the stop switch to the Push the primer pump 7 to 10 times position "ON or I ". to feed the fuel to the carburetor. If the stop switch is installed on a machine side.Set the stop switch to the position "ON or I ". CHOKE LEVER RECOIL STARTER 2 4 Pull the starter handle slowly, until resistance is felt. This is the "compression
ページ20に含まれる内容の要旨
STOPPING STOP SWITCH CHOKE LEVER 1 5 ON OFF OFF Set the throttle lever at the low speed position and allow the engine to run at low speed for 2 or 3 minutes before stopping. If the stop switch is installed on the After starting the engine, gradually engine.Set the stop switch to the position "OFF or O ". open choke by turning the choke lever and finally keep it fully If the stop switch is installed on a opened. machine side.Set the stop switch to the position "OFF or O ". Do not fully open
