ページ1に含まれる内容の要旨
SPOTLIGHT SPOTLIGHT SPOTLIGHT SPOTLIGHT SPOTLIGHT
30 MILLION CANDLEPOWER 30 MILLION CANDLEPOWER
30 MILLION CANDLEPOWER 30 MILLION CANDLEPOWER 30 MILLION CANDLEPOWER
93175
ASSEMBLY AND OPERATING INSTRUCTIONS
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
© ®
Copyright 2005 by Harbor Freight Tools . All rights reserved. No portion of this
manual or any artwork contained herein may be reproduced in any shape or form
without the express written conse
ページ2に含まれる内容の要旨
Specifications Description Item Power Source Battery, sealed lead-acid, 12 VDC, 7 AH Light Bulb Xenon, 12 V, 35 W High Intensity Discharge (HID); 3000 hour life Lens 9 inch (dia.) with reflector Charging Adapters Power cord: 110 VAC Car adapter: 12 VDC Weight 12.6 lbs. Features LED charging status indicator; Carrying strap; Built-in charging adapter compartment; Adjustable stand Save This Manual You will need the manual for the safety warnings and precautions, assembly instructions, operating an
ページ3に含まれる内容の要旨
7. Use the right tool for the job. Do not attempt to force a small tool or attachment to do the work of a larger industrial tool. There are certain applications for which this tool was designed. It will do the job better and more safely at the rate for which it was intended. Do not modify this tool and do not use this tool for a purpose for which it was not intended. 8. Maintenance. For your safety, service and maintenance should be performed by a qualified technician as a high voltage hazard e
ページ4に含まれる内容の要旨
11. Always recharge the Battery when the Spotlight performance begins to diminish. Severe heat is most destructive to a Battery; the more heat generated, the faster the Battery loses power. A Battery that gets too hot can be permanently damaged. Never over-discharge a Battery by using the tool even after tool performance is decreasing. When tool performance begins to diminish, stop the tool, and recharge the Battery. 12. Always remove the Battery from the Spotlight before performing inspection,
ページ5に含まれる内容の要旨
Caution: Never use both charging cords at the same time. Damage will occur to the charging system. To avoid running down the vehicle battery, it is recom- mended to charge the Spotlight while driving, or with the engine running in a well ventilated area. 3. Plug in the charging plug adapter. The Charging Status Indicator turns red, indicating charging. The Battery (2) will charge for approximately 5 hours if the Car Adapter Plug (7) is used, or 7 hours if the AC Charger Plug (8) is used. Monito
ページ6に含まれる内容の要旨
Black Negative Battery Lug Battery (2) Red Positive Battery Bracket (9) Battery Lug 4. Remove the Battery (2) and replace it with a new one of the same make and model (see Specifications on page 2). 5. Push the red wire connector onto the red positive (+) Battery lug. 6. Push the black wire connector onto the black negative (–) Battery lug. 7. Slide the Battery (2) back into the battery compartment and replace the Battery Bracket (9) using four screws. 8. Close the Back Cover and latch the Secur
ページ7に含まれる内容の要旨
5. Squeeze the open ends of the Light Bulb Clip (10) and remove it from the Reflector. See photo below, left. 6. Carefully lift out the Light Bulb (1) assembly. See photo below, right. Lens Reflector (5) Light Bulb (1) Assembly Light Bulb Clip (10) 7. Lift up on each wire connector tab and pull out the Light Bulb (1) connectors. See photo below. 8. Discard the bad Light Bulb. Place the new Light Bulb near the work area. Caution: Be careful not to touch the glass portion of the Lig
ページ8に含まれる内容の要旨
Parts List Part No. Description 1. Xenon Light Bulb, 12 VDC, 35 W, HID 2. Battery, 12 VDC, lead-acid, 1.7 AH 3. Stand 4. Strap, Shoulder 5. Lens and Reflector 6. Switch, On/Off 7. Car Charger Plug 8. AC Charger Plug 9. Battery Bracket 10. Light Bulb Clip NOTE: Some parts are listed for illustration purposes only and are not available individually as replacement parts. PLEASE READ THE FOLLOWING CAREFULLY THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST IN THI