ページ1に含まれる内容の要旨
PROFESSIONAL
SERIES
ca 3051
Owner’s Guide
Keyless Upgrade Security System
IMPORTANT NOTE: The operation of the Security and Convenience System as described in this manual is applicable to
most vehicles. However, due to the configuration of some vehicles, some functions AND/OR SAFETY PRECAUTIONS may
not apply. Please see your installing dealer for more information.
ca3051 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
ページ2に含まれる内容の要旨
Your system has many features and available options some of which are selected at time of installation. Consult your installing dealer for options that may have been installed and are not listed. ARMING THE SYSTEM: 1. Turn the engine OFF, exit the vehicle, and close all doors, hood and trunk. 2. Press and release the LOCK button of your Factory (OEM) transmitter one time. The parking lights will flash once, the siren will chirp once, and the dash mounted LED will begin to flash slowly confirming
ページ3に含まれる内容の要旨
Whenever the system is triggered, the vehicle's parking lights will flash for the full siren sounding period. Optional - whenever the system is triggered, the interior courtesy light will flash for the full siren sounding period. Optional- whenever the system is armed, the vehicle starter circuit is disabled, and the vehicle will not start with the ignition key. Whenever the system is armed, any strong impact to the vehicle will cause the shock sensor to trigger the alarm. Any lesser impact w
ページ4に含まれる内容の要旨
If the LED flashes 4 times...pause, 4 times...pause etc., then an intrusion attempt was made by impact or a strong vibration that the shock sensor detected. Check the vehicle for possible damage to the glass or body panels. NOTE: The LED intrusion warning indications are stored in the system's memory and will be erased when the ignition switch is turned on. VALET/OVERRIDE SWITCH: The valet switch allows you to temporarily bypass all alarm functions, eliminating the need to hand your transmitter
ページ5に含まれる内容の要旨
ELIMINATING/RETURNING THE NORMAL ARM/DISARM CHIRPS You can selectively eliminate the normal arm & disarm chirps using the valet/ override switch, following these steps. 1. Turn the ignition key ON the OFF. 2. Within 10 seconds of turning the ignition key OFF, press and release the valet/override switch 3 times. 3. If, before step 1, the chirps were ON, then you will hear 2 short chirps, which indicates the chirps are turned OFF. 4. If, before step 1, the chirps were OFF, then you will hear 1 sho
ページ6に含まれる内容の要旨
Code Systems, Inc. Limited Lifetime Warranty Code Systems Inc. (“CODE”) warrants to the ORIGINAL PURCHASER of this CODE vehicle security product (the “Product”), purchased from an authorized CODE dealer, that (except as provided below) should this Product under normal use and conditions, be proven defective in material or workmanship DURING THE LIFETIME OF THE VEHICLE IN WHICH IT WAS ORIGINALLY IN- STALLED, such defect(s) will be repaired or replaced (at CODE’s option) without charge for parts d
ページ7に含まれる内容の要旨
ca3051 rev B. 2011 Audiovox Electronics Corporation. All rights reserved.
ページ8に含まれる内容の要旨
Audiovox Electronics Corporation. Customer Service 1-800-421-3209 WWW.CODE-ALARM.COM FCC COMPLIANCE This device complies with Part 15 of the FCC rules and with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including any interference that may cause undesired operation. Warning! Changes or modifications not expressly approved by the party responsible for
