Home Automation 10A11-1の取扱説明書

ページ1に含まれる内容の要旨

Model 10A11-1, Rev C
Two-Way Audio/Voice Alarm Module
DESCRIPTION

The Model 10A11-1, Rev C Two-Way Audio/Voice Alarm Module allows two-way communication with a central station after an
alarm, paging and listening from an on-premises or remote phone, annunciation of alarm and zone by voice, and voice messaging.
The Model 10A11-1, Rev C also provides a line-level audio output that can be tied into an amplifier or whole home audio system, and
a page output that is activated whenever

ページ2に含まれる内容の要旨

28A00-1, 28A00-2, 33A00-4 CONSOLE, MODEL 10A11-1, REV C 33A00-20 KEYPAD, OR TWO-WAY AUDIO/VOICE ALARM MODULE SPEAKERS / MICROPHONES + SPKR1 (SPEAKER #1 OUTPUT) TWISTED PAIR 8 OHM - SPKR1 (SPEAKER #1 COMMON) SPEAKER + SPKR2 (SPEAKER #2 OUTPUT) - SPKR2 (SPEAKER #2 COMMON) TWISTED PAIR 8 OHM SPEAKER TWO-WIRE + + MIC1 (MICROPHONE #1 INPUT) ELECTRET _ MICROPHONE - MIC1 (MICROPHONE #1 COMMON) TWISTED PAIR WITH SHIELD + MIC2 (MICROPHONE #2 INPUT) TWO-WIRE + ELECTRET - MIC2 (MICROPHONE #2 COMMON) _ MI

ページ3に含まれる内容の要旨

Figure 2 - OmniLT Installation Figure 3 - Omni II, OmniPro II, Lumina, and Lumina Pro Installation CONTROLLER SETUP When using a Model 10A11-1, Rev C for two-way communication with a central station, the Two-Way Voice option must be enabled. From the Installer Setup menu, select the 3 (DCM) key. Press the down arrow ( ) key until you reach the Two-Way Audio option: TWO-WAY AUDIO: 0 0=NO 1=YES ↓ Press 1 (YES), and then press ' # ' to enable two

ページ4に含まれる内容の要旨

CENTRAL STATION OPERATION When an alarm occurs, the communicator first sends the appropriate report to the central station. After the transmission of the alarm to the central station, the operator can talk and listen to people and sounds at the premises. After the report is received by the central station operator, the Two-Way Audio Module is switched on. The central station operator can now listen to the premises. The module is always first switched on in the listen mode. The ope