ページ1に含まれる内容の要旨 
                    
                         E SERIES 1200 
Installation Instructions 
234 FISCHER AVENUE  COSTA MESA, CA 92626 
(714) 424-6500  (800) 840-0288  (714) 424-6510 FAX 
http://www.channelvision.com  E-Mail: sales@channelvision.com 
© 2001, CHANNEL VISION™                                                                                                                                                                                                                                                                                     
                    
                    ページ2に含まれる内容の要旨 
                    
                        Channel Vision  - II CAUTION  T  With FCC Sta n- RISK OF ELECTRIC SHOCK  ! DO NOT OPEN   N part 15 of the FCC Rules.  These limits are designed to    in a residential installati   installed and used in accordance with the   t  -      •   • Certification Requirements: Must be professional installing dealer, pass  • certification test and familiar with TV and antenna systems. Call 800/840 - • 0288 for Channel Vision Training Manual and certificat ion test.  Step 7:     Thank you for choosing Chann
                    
                    ページ3に含まれる内容の要旨 
                    
                        E Series 1200 Basic Setup  propagating back up the input line.    Cable or cable ports on you network with appropriate terminators.    Bandpass filters stop unwanted frequencies while passing all others along.  3102 Filter  in use.    MULTI ROOM VIDEO TECHNOLOGY Taps are used  to redirect a portion of a signal from the "main" trunk line while  passing the remaining signal strengt h through. For example, a 12dBmV tap  would pass 29dBmV from a 30dBmV trunk line signal and pass the remaining   line
                    
                    ページ4に含まれる内容の要旨 
                    
                        2.        3.    and amplifiers are broadband.    Splitters should be 5MHz to 1GHz, and amps should be 40MHz      4.   Check and make sure that a ll televisions are set up for the proper    frequency spectrum (i.e. UHF or cable).  5.   Make sure that the channels you want to modu late on have “clean    snow“. No lines or interference.  6.   Use a low pass filter on every installation to clean up the    frequencies the modulator will be assigned to and keep any  Trouble shooting any system can mak
                    
                    ページ5に含まれる内容の要旨 
                    
                        leakage may occur or if the shielding braid is touching the  3     Check all connectors for 75 Ω .      2.     - biner.      1.    Insert grounding block in line and ground coax cable  Grainy Modulated Channel : Good Picture on the Cable  before it enters the TV.    2.     1.       the components and the modulator.  modulated channels.   O u c h!!!          If the modulated channels are good, use a low pass filter to  - up" the incoming frequencies to be modulated.            B)          - necto
                    
                    ページ6に含まれる内容の要旨 
                    
                          Channel Vision Technology will repair or replace any defect in material or workmanship which o ccur during  normal use of this product with new or rebuilt parts, free of charge in the USA, for two years from the date of  original purchase.  This is a no hassle warranty with no mail in warranty card needed.  This warranty does not  cover damages in shipment, failures caused by other products not supplied by Channel Vision Technology, or  failures due to accident, misuse, abus e, or alteration o