Graco Ultra Clear 2700の取扱説明書

ページ1に含まれる内容の要旨

Failure to follow these warnings
Please read this Owner’s
and the assembly instructions could
Ultra clear
Manual completely BEFORE
result in serious injury or death.
first use of your monitor! Pay
Nursery
special attention to the warn-
This device is designed only to monitor the sounds of your child. It will
ings. Keep these instructions not alert you to your child’s silent activities. This product is not
Monitor designed or intended for use as a medical monitor. Always be sure that
for future

ページ2に含まれる内容の要旨

Product Features FRONT VIEW: REAR VIEW: Antenna Antenna Power Light Power Light Handle Handle Channel Channel Signal Selector* Selector* Indicator Lights Belt Clip AC Adapter AC Jack Adapter On/Off/ On/Off Jack Volume Switch Control Nursery Unit (Transmitter) Parent’s Unit (Receiver) Battery *Both the Parent’s Unit and the Nursery Unit MUST be set to AC Adapters the same channel. If receiver detects sounds from another Compartment (2 included) nursery monitor or cordless phone, set both units to

ページ3に含まれる内容の要旨

BATTERY USE TIPS Installing A Battery Charging of a rechargeable battery Remove battery from Parent’s Unit if it will not be used for a long time. should only be done by an adult. Battery changing should only be Remove a dead battery promptly. A Battery power will be conserved done by an adult. dead battery left in unit may leak, when Parent’s Unit is powered through AC adapter. It is not damaging your unit. The Parent’s Unit can be operated necessary to remove battery when on battery power. Do

ページ4に含まれる内容の要旨

System Setup Solving Problems Most problems have a simple solution. First, check that: SETTING UP TESTING THE UNITS ! Power is turned ON for both units THE MONITOR ! Both units are plugged in (or battery is fresh in Parent’s Unit) It is VERY IMPORTANT to test the ! Electrical outlet works system when first set up, and at regular 1. Check that both Nursery Unit ! Units are set to same channel times thereafter. Test the units any time and Parent’s Unit are set to the ! Volume is turned up on Pa