OmniTek OMNIPROX READER OP30の取扱説明書

ページ1に含まれる内容の要旨

OmniProx™ Reader
Installation Instructions Model Series OP10/20/30/40/45/90
K5336 Rev. 9, 11-Sep-2003


WHAT IS THE Honeywell OmniProx™ READER?
The OmniProx Reader is an RFID proximity card reader to
Check all electrical codes for proper installation.
be installed for use with access control systems.
These installation instructions contain the following
Card Reader Models OP10/20/30/40/45/90 are to be
information:
used with control panels whose power supply is UL
U

ページ2に含まれる内容の要旨

TABLE 1: WIRE GAGE SPECIFICATIONS SPECIFICATIONS Electrical Characteristics: Distance Gage 5 Conductor 6 Conductor Power Supply Type: Linear type Recommended ≤ 200 ft. (61m) 22 Alpha 1295C Alpha 1296C Operating Voltage Range: ≤300 ft. (91m) 20 Alpha 58126 Alpha 58126 5.0 – 16 VDC (Operational down to 4.25 VDC) ≤ 500 ft. (153 m) 18 Alpha 58136 Alpha 58136 Maximum input current: OP10, OP20, OP90 Note: Recommended cable is only a guideline, use any Standby: 35 mA manufacture

ページ3に含まれる内容の要旨

FEDERAL COMMUNICATIONS COMMISSION (FCC) Part 15 STATEMENT This equipment has been tested to FCC requirements and has been found acceptable for use. The FCC requires the following statement for your information: This equipment generates and uses radio frequency energy and if not installed and used properly, that is, in strict accordance with the manufacturer's instructions, may cause interference to radio and television reception. It has been type tested and found to comply with the lim

ページ4に含まれる内容の要旨

ADEMCO Limited Warranty Alarm Device Manufacturing Company, a Division of Pittway Corporation, and its divisions, subsidiaries and affiliates ("Seller"), 165 Eileen Way, Syosset, New York 11791, warrants OmniProx products to be in conformance with its own plans and specifications and to be free from defects in materials and workmanship under normal use and service for the life of the product. Seller's obligation shall be limited to repairing or replacing, at its option, free of charge for ma