The Swan Corporation KSEU-3020の取扱説明書

ページ1に含まれる内容の要旨

KITCHEN SINK Model No. KSEU-3020
OWNER’S MANUAL CAUTION:
Installation
Read ALL instructions carefully
Care and
MODEL NO.
BEFORE starting your installation.
Cleaning
Save this manual for future reference.
KSEU-3020
Patent Pending

ページ2に含まれる内容の要旨

KITCHEN SINK Model No. KSEU-3020 Step-By-Step Installation Instruction Model KSEU-3020 20
x 39-3/8
(508mm) x (1000mm) Tools Required • Ruler • Drill • Caulk • Saber Saw (if counter top cutout is required) • Screw Driver DRAW A 1-1/2
(38mm) RADIUS AT EACH CORNER 5/16
(8mm) TRACE COMPLETELY AROUND EDGE OF SINK 1. If it is necessary to cut out the counter top, invert sink and 2. Measure in 5/16 (8mm) from the initial sink outline and draw position onto the counter top. Locate sink front to rea

ページ3に含まれる内容の要旨

Installation • Care and Cleaning CUT INSIDE OF LINE DRILL STARTER HOLE INSIDE OF CUTOUT LINE 3. Drill starter hole inside of cutout line. 4. Using a saber saw, cut inside of cutout line. Trial fit sink to check proper fit. IMPORTANT The Euro Style sink design allows for the drainboard to be located on either the left or right side. After you decide on the location of the drainboard, the fixture holes can then be located. NOTE Drill Starter Hole From Bottom Finish Drilling Hole From Top 5. Fixtur

ページ4に含まれる内容の要旨

KITCHEN SINK Model No. KSEU-3020 Installation • Care and Cleaning APPLY CAULK 7. Apply a bead of caulk (not included) to the underside of the 8. Connect all faucet supply lines, disposal (if available), and sink flange and position sink into counter top opening. First, drain trap fittings per manufacturer instructions. tighten screws in front, then tighten rear screws. CHECK FOR LEAKS: • Supply user tubes to faucet • Supply riser tubes to shut off valves or lower connections • Fill sink with wat