ページ1に含まれる内容の要旨
Riva Freestanding Bench
Installation Instructions
Product Codes: RVACB45B (For use with RVF40C)
RVACB100B (For use with RVF40C, RVF66 & RVF76)
RVACB120B (For use with RVF40C, RVF66 & RVF76)
IMPORTANT
Please read these instructions carefully and in conjunction with the appropriate Riva instructions.
Care must be taken when handling the stove to avoid injury or damage to the stove.
PM205 ENG Issue 2 (August 2007)
ページ2に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS Packing list Tools required • 10mm A/F Spanner • User Instructions • 13mm A/F Spanner • 3 x Drilling Templates • Hammer • 4 x M6 x 90 Coach bolts • Center Punch • 4 x M6 Washers • Power Drill with: • 4 x M6 Nuts • Ø8mm Masonry drill bit • 2 x No.8 Hex Coach bolt • Ø8mm Steel drill bit • 2 x Rawl plugs • Pozidrive attachment • 5 x Felt pads 1 3 No8 rawl plug Ø8mm hole PR7582 PR7584 1. Position bench on your hearth and mark 3. Tap in No.8 Rawl plugs. ou
ページ3に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS 5 8 PR7572 8. Remove back cover plate from the stove. PR7569 5. Slide The bench over the coach bolts and 9 tighten. Position drilling template as you would the stove. 6 PR7573 PR7570 9. Lift off stove cover plate. 6. Mark drilling points with a centre punch. 10 7 Felt pads PR7574 10. Firstly remove all internal parts from the PR7571 stove and remove the door. Tip the stove onto its 7. Drill four Ø8mm holes. Straight through both front on a soft surface that will not da
ページ4に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS 11 14 PR7575 PR7578 11. Position the stove onto the bench. 14. Replace the top cover plate. 12 15 M6 nut M6 washer M6 X 90mm coach bolt PR7579 PR7576 15. Re-attach the back cover plate, internal parts 12 Remove ash pan and insert the two coach and door. bolts in the front holes, fixing with the nuts and 16 washers provided. 13 PR7577 13. Repeat step 12 with the rear holes. PR7580 Stovax Ltd, Falcon Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7LF Tel: (0139
