ページ1に含まれる内容の要旨
Operator's Manual
8000 SERIES
(Diesel Version)
ZTR® MOWERS
2001
Page 1
ページ2に含まれる内容の要旨
IMPORTANT - READ CAREFULLY ® ® The Dixon ZTR Mower is both easy and fun to operate. However, any power mower must be operated properly to be safe. It is not a toy or a recreational vehicle. Before you start to use the mower, read the operator's manual carefully and become completely familiar with the controls. ® ® The information in this operator's manual applies to all Dixon ZTR 8000 Series Diesel Version Commercial Mowers. Your Dixon dealer will gladly answer any questions. See your dealer
ページ3に含まれる内容の要旨
INDEX SAFETY ..................................................................Pages 4-9 WARRANTY POLICY ............................................ Page 10 SPECIFICATIONS .................................................Page 11 CONTROLS ...........................................................Pages 12-15 OPERATION INSTRUCTIONS ........................... Pages 16-20 CARE AND MAINTENANCE ............................... Pages 21-30 STANDARD SERVICE PARTS LIST .....................Page 31 TROUB
ページ4に含まれる内容の要旨
SAFETY RIDING LAWNMOWERS, IF IMPROPERLY OPERATED, CAN CAUSE SERIOUS INJURY OR DEATH The most common causes of injury to the operator or bystander... BLADE CONTACT TIP-OVER RUN-OVER BACK-OVER ...read and understand this manual to prevent injuries. 4
ページ5に含まれる内容の要旨
SAFETY Safety Alert Symbol When you see this symbol, BE ALERT to the potential for injury. Follow recommended safety precautions and safe operating practices. Danger indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury. Warning indicates a potentially hazardous situation which, if not avoided, could result in death or serious injury. Caution indicates a potentially hazardous situation which, if not avoided, may result in minor or moderate inju
ページ6に含まれる内容の要旨
SAFETY Failure to observe the following safety instructions could result in serious injury or death. GENERAL OPERATION: Read, understand, and follow all instructions in the manual and on the mower before starting. Only allow responsible adults, who are familiar with the instructions, to operate the mower. Clear the area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by the blade. Be sure the area is clear of other people before mowing. Stop mower if anyo
ページ7に含まれる内容の要旨
SAFETY SLOPE OPERATION: Slopes are a major factor related to loss-of-control and tip-over accidents, which can result in severe injury or death. All slopes require extra caution. If you cannot back up the slope or if you feel uneasy on it, do not mow it! DO Mow across the slope with your Dixon ZTR - never up or down. Remove obstacles such as rocks, tree limbs, etc. Watch for holes, ruts or bumps. Uneven terrain could overturn the mower. Tall grass can hide obstacles. Use slow speed. Tires ma
ページ8に含まれる内容の要旨
SAFETY CHILDREN: Tragic accidents can occur if the operator is not alert to the presence of children. Children are attracted to lawn mowers and the mowing activity. NEVER assume children will stay where they were last seen. Be alert to avoid accidents. Keep children out of the mowing area and under the watchful care of another responsible adult. Be alert and turn mower off if a child enters the area. Before and during backing, look behind and DOWN for small children. Never carry children
ページ9に含まれる内容の要旨
SAFETY SERVICE: Use extra care in handling gasoline and other fuels. They are flammable and vapors are explosive. Use only an approved container. Never remove fuel cap or add fuel with the engine running. Allow engine to cool before refueling. Do not smoke while refueling. Never refuel the mower indoors. Never store the mower or fuel container inside a building where there is an open flame. If fuel is spilled on clothing, change clothing immediately. To prevent fire and explosion caused by
ページ10に含まれる内容の要旨
DIXON INDUSTRIES, INC. a BLOUNT company AIRPORT INDUSTRIAL PARK PO BOX 1569 COFFEYVILLE KS 67337 0945 316 251 2000 FAX 316 251 4117 DIXON LIMITED WARRANTY POLICY - COMMERCIAL MODELS 8000 Series WARRANTY: Home Owner Application: This Dixon Warranty term is for a period of three (3) years from date of purchase. Commercial Application: Dixon mowers used for commercial application are warranted for one (1) year from the date of purchase or 750 hours whichever comes first. Commercial use is s
ページ11に含まれる内容の要旨
SPECIFICATIONS 8000 Series (Diesel Version) CHASSIS: 11 GA - rectangular tube, 7 GA reinforcement SEAT: Designed for operator comfort with padded back and arm rests. Seat is adjustable fore and aft. Mounted on operator suspension system with damper. MOWER DECK: 2 Decks are available. Both decks are made of 10 GA fabricated welded construction with 1/4 " reinforcement plate. 3 blades combine for either a 60" or 72" cut width. Deep deck with discharge tunnel. Cut height approximately 1.5" to
ページ12に含まれる内容の要旨
CONTROLS CONTROL LEVERS Note: For access to the seat move control levers to neutral position and swing them outward. TO GO FORWARD: From neutral position, gently push both control levers forward. To increase speed, move levers further forward. TO GO BACKWARD: From neutral position, gently pull both control levers toward you. TURNING: Turning is controlled by moving one control lever slightly forward or rearward of the other. To turn left, move left lever rearward of the right lever. To turn righ
ページ13に含まれる内容の要旨
CONTROLS PARKING BRAKE: A parking brake is located to the left of the seat. Engine will kill if control levers are not in the outboard position when the parking brake is engaged. To engage brake: pull up and back. To disengage brake: push forward and down. Note: The parking brake is not intended to be used as a service brake. Note: Always set parking brake before dismounting. Release parking brake before moving mower. Note: Engage parking brake before starting engine. MOWER DECK LIFT: The mow
ページ14に含まれる内容の要旨
CONTROLS MOWER BLADE SWITCH: To engage blades: pull up on switch. To disengage blades: push down. IGNITION SWITCH: Turn to run position to energize glow plugs. Turn to start position when glow plug light turns off, then crank engine. Release when it starts. For headlights - rotate switch one notch counter-clockwise from run. NOTE: Remove key when mower is not in use. THROTTLE CONTROL LEVER: Located on control panel to operator's right. Controls engine speed. While mowing, throttle control
ページ15に含まれる内容の要旨
CONTROLS 15
ページ16に含まれる内容の要旨
OPERATION INSTRUCTIONS The safe and successful operation of the Model ZTR 8000 Series Diesel version will depend upon the operator having the correct knowledge of all controls used on the mower and making good judgements about the terrain to be mowed. NEVER allow anyone to operate the mower without complete knowledge of all controls and their functions. During initial operation, "learning to drive", set throttle at slow speed. BEFORE OPERATING MOWER: 1. Read and observe all safety instructions
ページ17に含まれる内容の要旨
OPERATION INSTRUCTIONS TESTING OF SAFETY INTERLOCK SYSTEMS: Do not operate mower if safety switches are not operating properly. Your Zero Turning Radius Mower is equipped with control interlocks for your safety. 1. The engine will not start if the mower blades are engaged. 2. The engine will not start unless the steering control levers are neutral "OUT" position. 3. The engine will stop if the mower blade clutch is engaged and the operator leaves the driver's seat. 4. The engine will stop if the
ページ18に含まれる内容の要旨
OPERATION INSTRUCTIONS STARTING INSTRUCTIONS: 1. Operator must be seated in normal operating position. 2. Set parking brake. 3. Move control levers to outboard position. 4. Assure blade clutch is off. 5. Push throttle control lever to slow setting. 6. Insert ignition key and turn to run position. Glow plug light should light. 7. When glow plug light goes off turn ignition key to "start" position. When engine starts, release ignition key. Key will return to "run" position. NOTE: Turn k
ページ19に含まれる内容の要旨
OPERATION INSTRUCTIONS MOWING INSTRUCTIONS: Be sure that deflector is properly installed on the discharge chute. CAUTION 1. Start engine and set throttle at full speed. 2. Set desired cut height. 3. Release park brake. 4. Move control levers in and operate per the control instructions on Page 12. CAUTION Check the area around the mower to assure there is no one near. 5. Set RPM at approximately 1/2 speed and engage mower blades. GRASS HEIGHT AND CUTTING SUGGESTIONS: Do Not Attempt To Cut Gr
ページ20に含まれる内容の要旨
OPERATION INSTRUCTIONS TO LIFT SEAT: To lift the seat, move the control levers to the neutral out position. Unhook the seat damper by rotating the clip of the retaining pin off of the clevis end and remove the retaining pin. Remove the clevis end of the seat damper from the seat hold down bracket and replace the pin and rotating pin clip to lock them in place. Release the seat latch and rotate the counterbalanced seat support frame upward and forward. To return the seat to the operating posit
