ページ1に含まれる内容の要旨
INTRODUCTION
Congratulations on your selection of a Honda lawn mower! We are
certain you will be pleased with your purchase of one of the finest
lawn mowers on the market.
OWNER’S MANUAL
We want to help you get the best results from your new mower and to
operate it safely. This manual contains the information on how to do
HRS216PDA • HRS216SDA
that; please read it carefully.
HRR216PDA • HRR216VKA
We suggest you read the DISTRIBUTOR’S LIMITED WARRANTY
(page 20) and EMISSION CONTROL SYSTEM W
ページ2に含まれる内容の要旨
If you decide that your son or daughter can handle the mower safely, LAWN MOWER SAFETY CAREFULLY READ THE OWNER’S MANUAL with your child. Make sure you both understand all instructions and safety information. Also, Most injuries and property damage with walk-behind mowers can be be sure your child wears sturdy shoes and other protective clothing prevented if you follow all instructions in this manual and on the when operating or handling the mower. mower. The most common hazards are discu
ページ3に含まれる内容の要旨
Engine Oil SETTING UP YOUR NEW The mower is shipped WITHOUT OIL in the MOWER engine. A bottle of oil is included Unpacking in the box with your Remove all the cardboard from around the handlebar. mower. Add the entire contents of the oil bottle Handlebar Setup into the oil filler opening. Loosen the two knobs on the lower handlebar All Honda engines are enough to raise the run at the factory prior to handlebar into the packaging. Most of the mowing position. oil is removed prior to
ページ4に含まれる内容の要旨
CONTROL LOCATIONS BEFORE OPERATION (HRS216SDA) Your safety is your responsibility. A little time spent in preparation will CLUTCH LEVER (P. 7) significantly reduce your risk of injury. Read and understand this manual. Know what the controls do and BLADE CONTROL how to operate them. LEVER (P. 7) Familiarize yourself with the lawn mower and its operation before you begin using it. Know how to quickly shut off the lawn mower in case of an emergency. THROTTLE LEVER (P. 7) IS YOUR LAWN MOWER R
ページ5に含まれる内容の要旨
Side Discharge Chute GET THE MOWER READY (HRS) Rear Shield The mower can be used to During normal use the rear shield is subject to deterioration and wear. mulch or side discharge SIDE Remove the grass bag and raise the discharge guard to check the grass clippings. DISCHARGE rear shield for cracks or tears. If the rear shield is excessively worn, GUARD To mulch, make sure the have it replaced by your authorized Honda servicing dealer. side discharge chute is not DISCHARGE GUARD install
ページ6に含まれる内容の要旨
CONTROL ™ Installation OPERATION 1. Raise the discharge guard and hook the grass bag onto the mower deck as shown. SAFE OPERATING PRECAUTIONS 2. Release the discharge guard to secure the grass bag. Before operating the mower for the first time, please review LAWN Removal MOWER SAFETY (page 2). Even if you have operated other mowers, REAR DISCHARGE GRASS BAG take time to become familiar with how this mower works and practice GUARD 1. Raise the rear HANDLE in a safe area until you build up
ページ7に含まれる内容の要旨
5. Pull the starter grip lightly Clutch Lever until you feel resistance, (SDA) STARTER then pull briskly. Return Push the clutch lever forward and hold CLUTCH LEVER (SDA) GRIP the starter grip gently. it against the handlebar to propel the mower forward. Keep your hands and feet away from the mower deck Release the clutch lever to stop the at all time when starting mower’s forward movement. and running the engine. Always release the clutch lever before Continue to hold the blade sta
ページ8に含まれる内容の要旨
Slopes STOPPING THE ENGINE Mow across slopes, not up and down. 1. PDA, SDA: Move the throttle lever to SLOW Avoid steep slopes (more than 20 °), the SLOW position. and be careful when changing direction. Mowing on a slope when the grass is damp or wet could cause you to slip, fall, and lose control of the mower. Obstacles Use the side of the mower to cut close 2. SDA: Release the CLUTCH LEVER to large obstacles, such as fences or clutch lever. (SDA walls. SHOWN) VKA: Release the Rele
ページ9に含まれる内容の要旨
• Read the instructions before you begin, and make sure you have SERVICING YOUR LAWN the tools and skills required. • To reduce the possibility of fire or explosion, be careful when MOWER working around gasoline. Use only a nonflammable solvent, not gasoline, to clean parts. Keep cigarettes, sparks, and flames away Proper maintenance is essential for safe, economical, and from all fuel-related parts. trouble-free operation. It will also help reduce air pollution. MAINTENANCE SCHEDULE B W
ページ10に含まれる内容の要旨
Removal and Installation BLADE(S) If you remove the blade(s) for sharpening or replacement, you will Inspection need a torque wrench for installation. Wear heavy gloves to protect 1. Turn the fuel valve to your hands. FUEL CAP OFF. Disconnect the BLADE SHARPENING: To avoid weakening the blade(s) or causing spark plug cap from imbalance or poor cutting, the blade(s) should be sharpened by the spark plug trained staff at an authorized Honda servicing dealer. (page 13). BLADE REPLACEMENT:
ページ11に含まれる内容の要旨
Installation ENGINE MAINTENANCE 1. Clean dirt and grass from around the blade mounting area. Engine Oil Level Check 2. Install the blade(s) using the two blade bolts and special washers 1. Unscrew and remove the filler cap/dipstick and wipe it clean. as shown. Be sure to install the special washers with the concave 2. Insert and remove the side toward the blade(s) and the convex side toward the bolts. dipstick without screwing it into the filler B WARNING neck. Check the oil level sho
ページ12に含まれる内容の要旨
Engine Oil Change Air Cleaner Service Drain the used oil while the engine is warm. Warm oil drains quickly A dirty air cleaner will restrict air flow to the carburetor, reducing and completely. engine performance. If you operate the mower in very dusty areas, clean the air cleaner more often than specified in the MAINTENANCE 1. Turn the fuel valve OFF. This will reduce the possibility of fuel SCHEDULE (page 9). leakage. 2. Wipe the oil filler area clean, then remove the oil filler cap/dipsti
ページ13に含まれる内容の要旨
Spark Plug Service Spark Arrester Service (optional equipment) Recommended Spark Plug: NGK - BPR5ES Your lawn mower engine is not factory-equipped with a spark arrester. An incorrect spark plug can cause engine damage. In some areas, it is illegal to operate an engine without a spark arrester. Check local laws and regulations. An optional USDA For good performance, the spark plug must be properly gapped and approved spark arrester is available from an authorized Honda free of deposits. ser
ページ14に含まれる内容の要旨
FUEL SYSTEM TRANSPORTING If the engine has been running, allow it to cool for at least 15 minutes Refueling before loading the mower on the transport vehicle. A hot engine and This engine is certified to operate on unleaded gasoline with a pump exhaust system can burn you and can ignite some materials. octane rating of 86 or higher. 1. Turn the fuel valve to the OFF position. This will prevent carburetor Refuel in a well-ventilated area with the engine stopped. If the engine flooding an
ページ15に含まれる内容の要旨
Fuel Handlebar Folding Remove the grass bag (HRR) if installed. You can place it on top of NOTICE the engine, with the bag opening to the front. Depending on the region where you operate your equipment, fuel . formulations may deteriorate and oxidize rapidly. Fuel deterioration and oxidation can occur in as little as 30 days and may cause damage to the carburetor and/or fuel system. Please check with your servicing dealer for local storage recommendations. Gasoline will oxidize and det
ページ16に含まれる内容の要旨
Mowing and Bagging Problems TAKING CARE OF Possible Cause Correction UNEXPECTED PROBLEMS Engine speed is too slow to cut Move the throttle lever to the FAST well (PDA, SDA) position (page 7). Engine Will Not Start Possible Cause Correction Mower is moving too fast for lawn Release the clutch lever and push conditions slower (SDA, PDA). Move at a slower Fuel valve OFF Turn the fuel valve ON (page 6). speed (VKA). Throttle lever in the wrong Move the throttle lever to the CHOKE Cutting height
ページ17に含まれる内容の要旨
Problems That May Affect Emissions CARBURETOR MODIFICATION FOR HIGH If you are aware of any of the following symptoms, have your engine ALTITUDE OPERATION inspected and repaired by your servicing dealer. At high altitude, the standard carburetor air-fuel mixture will be too • Hard starting or stalling after starting rich. Performance will decrease, and fuel consumption will increase. A very rich mixture will also foul the spark plug and cause hard starting. • Rough idle Operation at an alti
ページ18に含まれる内容の要旨
SPECIFICATIONS ENGINE FEATURES Model GCV160 Model HRS216 HRR216 Engine type 4-stroke, overhead-cam, single-cylinder, Type PDA SDA PDA VKA air-cooled Push Displacement 9.8 cu in (160 cc) Self-propelled, 1-speed Bore and stroke 2.52 x 1.97 in (64 x 50 mm) Variable speed Compression ratio 8.5:1 Automatic choke Ignition system Transistorized magneto Single blade Twin blades MAINTENANCE Grass bag Fuel Unleaded gasoline See page 14 Mulching plug with a pump octane Side-discharge guard & chute rat
ページ19に含まれる内容の要旨
DEALER LOCATOR INFORMATION CONSUMER INFORMATION To find an Authorized Honda Servicing Dealer anywhere in the United States: REPLACEMENT PARTS, Visit www.HondaPowerEquipment.com and click on Dealer Locator. OPTIONAL EQUIPMENT, AND SERVICE ITEMS Contact an authorized Honda servicing dealer to purchase any of CUSTOMER SERVICE INFORMATION these (or other) Honda Genuine items for your lawn mower. Honda Power Equipment dealership personnel are trained Replacement Parts professionals. They shoul
ページ20に含まれる内容の要旨
Disclaimer of Consequential Damage and Limitation of Implied DISTRIBUTOR'S LIMITED WARRANTY Warranties: Honda Power Equipment American Honda disclaims any responsibility for loss of time or use of the product, transportation, commercial loss, or any other incidental or consequential damage. This warranty is limited to the following Honda Power Equipment products Any implied warranties are limited to the duration of this written limited warranty. when distributed by American Honda Motor Co.,
