ページ1に含まれる内容の要旨
INTRODUCTION
Congratulations on your selection of a Honda lawn mower! We are
certain you will be pleased with your purchase of one of the finest
lawn mowers on the market. OWNER’S MANUAL
We want to help you get the best results from your new mower and to
HRS216PDA • HRS216SDA
operate it safely. This manual contains the information on how to do
HRR216PDA • HRR216TDA
that; please read it carefully.
We suggest you read the Distributor’s Limited Warranty (page 19) and
Emission Control System W
ページ2に含まれる内容の要旨
If you decide that your son or daughter can handle the mower safely, LAWN MOWER SAFETY CAREFULLY READ THE OWNER’S MANUAL with your child. Make sure you both understand all instructions and safety information. Also, Most accidents with walk-behind mowers can be prevented if you be sure your child wears sturdy shoes and other protective clothing follow all instructions in this manual and on the mower. The most when operating or handling the mower. common hazards, according to accident stati
ページ3に含まれる内容の要旨
Engine Oil SETTING UP YOUR NEW The mower is shipped WITHOUT OIL in the MOWER engine. A bottle of oil is included Unpacking in the box with your Remove all the cardboard from around the handlebar. mower. Add the entire contents of the oil bottle Handlebar Setup into the oil filler opening. Loosen the two knobs on the lower handlebar All Honda engines are enough to raise the run at the factory prior to handlebar into the packaging. Most of the mowing position. oil is removed prior to s
ページ4に含まれる内容の要旨
CONTROL LOCATIONS BEFORE OPERATION DRIVE CLUTCH LEVER Your safety is your responsibility. A little time spent in preparation will FLYWHEEL BRAKE (SDA & TDA) (P. 7) significantly reduce your risk of injury. LEVER (P. 6) Read and understand this manual. Know what the controls do and how to operate them. Familiarize yourself with the lawn mower and its operation before you THROTTLE LEVER (P. 6) begin using it. Know how to quickly shut off the lawn mower in case of an emergency. IS YOUR LAWN M
ページ5に含まれる内容の要旨
Removal GET THE MOWER READY REAR DISCHARGE GUARD 1. Raise the rear REAR Mulching Plug discharge guard, GRASS BAG DISCHARGE (HRR) grasp the grass bag HANDLE GUARD The mulching plug helps to handle and remove curve the inside of the the grass bag. BAG mower deck for more 2. Release the rear efficient mulching. discharge guard. Install and remove the 3. When the grass bag mulching plug by raising is clear of the rear the rear discharge guard discharge guard, you as shown. The mulching
ページ6に含まれる内容の要旨
4. Pull back on the FLYWHEEL OPERATION flywheel brake lever and BRAKE LEVER hold it against the MOWING PRECAUTIONS handlebar. STARTER Before operating the mower for the first time, please review LAWN 5. Pull the starter grip GRIP MOWER SAFETY (page 2). Even if you have operated other mowers, lightly until you feel take time to become familiar with how this mower works and practice resistance, then pull in a safe area until you build up your skills. For your safety, avoid briskly. Ret
ページ7に含まれる内容の要旨
SPEED 3 2 1 3. Release the flywheel Drive Clutch Lever FLYWHEEL brake lever. (SDA, TDA) BRAKE LEVER Push the drive clutch lever DRIVE CLUTCH LEVER (SDA, TDA) forward and hold it against the handlebar to propel the mower forward. Release the drive clutch lever to stop the mower’s 4. When the mower is not forward movement. in use, turn the fuel Always release the drive valve to OFF. clutch lever before starting OFF the engine. If the drive clutch is engaged, the mower will move forwa
ページ8に含まれる内容の要旨
SAFE MOWING PRACTICES SERVICING YOUR LAWN For your safety, keep all four wheels on the ground, and be careful to MOWER avoid losing your footing and your control of the mower. Keep a firm grip on the handlebar, and walk, never run, with the mower. Be very careful when mowing uneven or rough ground. Proper maintenance is essential for safe, economical, and trouble-free operation. It will also help reduce air pollution. If stuck, do not kick or shove the mower with your foot. Use the handle
ページ9に含まれる内容の要旨
Remember that an authorized Honda servicing dealer knows your BLADE(S) mower best and is fully equipped to maintain and repair it. Inspection To ensure the best quality and reliability, use only new, genuine 1. Turn the fuel valve to Honda parts or their equivalents for repair and replacement. OFF. Disconnect the MAINTENANCE SCHEDULE spark plug cap from the spark plug (page 12). BLADE(S) 2. Tilt the mower to the Interval Item right, so the air cleaner side is up. This will help Inspect
ページ10に含まれる内容の要旨
BLADE HOLDER GRASS BAG CLEANING AND REPLACEMENT HRS (HRR) SINGLE BLADE Cleaning Wash the bag with a garden hose, and allow it to dry completely before use; a wet bag will clog quickly. SPECIAL Replacement WASHER (2) Replace a worn or damaged bag with a Honda replacement bag or its equivalent (page 18). BLADE BOLT (2) Bag Removal BAG 1. Unclip the plastic edges of BLADE HOLDER the bag from the frame. HRR 2. Remove the frame from UPPER BLADE the bag. LOWER BLADE PLASTIC EDGE FRAME SPECIAL Bag
ページ11に含まれる内容の要旨
ENGINE MAINTENANCE Engine Oil Level Check Please dispose of used motor oil and the containers in a manner that is compatible with the environment. We suggest you take it in 1. Unscrew and remove the filler cap/dipstick and wipe it clean. a sealed container to your local recycling center or service station 2. Insert and remove the dipstick without screwing it into the filler for reclamation. Do not throw it in the trash, pour it on the ground, neck. Check the oil level shown on the dipstick.
ページ12に含まれる内容の要旨
Spark Plug Service Spark Arrester Service (optional equipment) Recommended Spark Plug: NGK - BPR6ES Your lawn mower engine is not factory-equipped with a spark arrester. In some areas, it is illegal to operate an engine without a spark NOTICE arrester. Check local laws and regulations. An optional USDA approved spark arrester is available from an authorized Honda Incorrect spark plugs can cause engine damage. servicing dealer. See page 18 for part numbers. For good performance, the spark pl
ページ13に含まれる内容の要旨
FUEL SYSTEM TRANSPORTING Refueling If the engine has been running, allow it to cool for at least 15 minutes Fuel tank capacity: 0.29 US gal (1.1 l) before loading the mower on the transport vehicle. A hot engine and exhaust system can burn you and can ignite some materials. Use unleaded gasoline with a pump octane rating of 86 or higher. 1. Turn the fuel valve to the OFF position. This will prevent carburetor This engine is certified to operate on regular unleaded gasoline with a floodin
ページ14に含まれる内容の要旨
Drying Draining the Carburetor and Fuel Tank 1. After washing the lawn mower, wipe dry all accessible surfaces. 1. Make sure the fuel valve is OFF. Remove the carburetor drain bolt with a 10 mm wrench, and drain the fuel from the carburetor bowl 2. With the mower in an upright position, start the engine outdoors, into an approved container. engage the blade control lever, and let the engine run until it reaches normal operating temperature to evaporate any water remaining on the engine. W
ページ15に含まれる内容の要旨
Loss of Power PLACING IN STORAGE Possible Cause Correction If your mower will be stored with gasoline in the fuel tank and carburetor, it is important to reduce the hazard of gasoline vapor Throttle not set to FAST Move the throttle to FAST (page 6). ignition. Select a well-ventilated storage area away from any Grass is too tall to cut Raise the cutting height (page 5), cut a appliance that operates with a flame, such as a furnace, water heater, narrower swath, use a slower ground or clot
ページ16に含まれる内容の要旨
EMISSION CONTROL SYSTEM TECHNICAL INFORMATION Source of Emissions SERIAL NUMBER LOCATIONS The combustion process produces carbon monoxide, oxides of nitrogen, and hydrocarbons. Control of hydrocarbons and oxides of nitrogen is very important because, under certain conditions, they react to form photochemical smog when subjected to sunlight. Carbon monoxide does not react in the same way, but it is toxic. Honda utilizes lean carburetor settings and other systems to reduce the emissions of ca
ページ17に含まれる内容の要旨
AIR INDEX An Air Index Information hang tag/label is applied to engines certified FRAME to an emission durability time period in accordance with the Model HRS216 HRR216 requirements of the California Air Resources Board. Type PDA SDA PDA TDA The bar graph is intended to provide you, our customer, the ability to 61 1/8 in 63 7/8 in 61 5/8 in 64 1/2 in compare the emissions performance of available engines. The lower Length (1554 mm) (1621 mm) (1566 mm) (1637 mm) the Air Index, the less polluti
ページ18に含まれる内容の要旨
CONSUMER INFORMATION MAINTENANCE REPLACEMENT PARTS, Fuel Unleaded gasoline See page 13. OPTIONAL EQUIPMENT, AND SERVICE ITEMS with a pump octane rating of 86 or higher Contact an authorized Honda servicing dealer to purchase any of these (or other) genuine, original Honda items for your lawn mower. Engine oil SAE 10W-30 See page 11. Spark plug type NGK - BPR6ES See page 12. Maximum governed 2,950 ~ 3,100 rpm See shop manual. speed Model Item Part Number Throttle cable Adjust for proper See s
ページ19に含まれる内容の要旨
DEALER LOCATOR INFORMATION DISTRIBUTOR'S LIMITED WARRANTY This warranty is limited to the following Honda Power Equipment products To find an Authorized Honda Servicing Dealer anywhere in the United when distributed by: States: American Honda Motor Co., Inc., Power Equipment Division, 4900 Marconi Drive, Alpharetta, Georgia 30005-8847. Visit our website: PRODUCTS COVERED BY LENGTH OF WARRANTY www.hondapowerequipment.com THIS WARRANTY (from date of original retail purchase) Noncommercial/ Comme
ページ20に含まれる内容の要旨
Disclaimer of Consequential Damage and Limitation of ACCESSORIES, REPLACEMENT PARTS, AND Implied Warranties: APPAREL WARRANTY American Honda disclaims any responsibility for loss of time or use of the This warranty is limited to Honda Power Equipment parts, accessories and product, or the power equipment on which the product is installed, apparel when distributed by American Honda Motor Co., Inc., transportation, commercial loss, or any other incidental or consequential 4900 Marconi Driv
