ページ1に含まれる内容の要旨
Operator's Manual
®
STOP
SUN SHADE
DO NOT RETURN TO STORE
For Missing Parts or Assembly
Questions Call 1-866-576-8388
Model No. 486.24227
CAUTION:
Before using this product, read
this manual and follow all Safety
Rules and Operating Instructions.
Sears, Roebuck and Co., Hoffman Estates, IL 60179 U.S.A.
www.sears.com/craftsman
PRINTED IN U.S.A. FORM NO. 49950 (REV. 8/21/07)
ページ2に含まれる内容の要旨
TABLE OF CONTENTS SAFETY .......................................................................... 2 ASSEMBLY INSTRUCTIONS FOR TRACTORS WARRANTY ................................................................... 2 WITH DUAL SUSPENSION BRACKET ........................ 8 CARTON CONTENTS .................................................... 3 CANOPY INSTALLATION ............................................... 9 HARDWARE CHART ...................................................... 4 OPERATION ...
ページ3に含まれる内容の要旨
CARTON CONTENTS 3 24 25 1 21 7 2 20 4 19 18 5 6 26 REF. PART QTY. DESCRIPTION REF. PART QTY. DESCRIPTION NO. NO. NO. NO. 1 49242 1 Base Top Tube 18 25303 1 Left Base Bracket 2 25014 2 Upright Tube 19 25302 1 Right Base Bracket 3 25013 2 Top Tube 20 25794 1 Left Support Bracket 4 25012 1 U-Tube 21 25835 1 Right Support Bracket 5 25015 3 Support Rod 24 40003 1 Base Leg Tube, Flattened 6 48660 1 Vinyl Canopy 25 49325 2 Base Leg Tube 7 25793 1 Base Bracket 26 25304 2 Rear Base Support
ページ4に含まれる内容の要旨
HARDWARE CHART SHOWN FULL SIZE NOT SHOWN FULL SIZE 9 12 16 13 15 17 22 10 8 11 14 23 REF. PART QTY. DESCRIPTION REF. PART QTY. DESCRIPTION NO. NO. NO. NO. 8 43720 2 Plastic Knob 15 44977 6 Carriage Bolt, 5/16-18 x 2" 9 46594 4 Carriage Bolt, 5/16-18 x 2-3/4" 16 23658 4 Spacer 10 43081 4 Flat Washer, 5/16" 17 47810 6 Nylock Nut, 5/16-18 11 43648 4 Hex Bolt, 1/4-20 x 1-1/2" 22 44180 1 Hex Bolt, 5/16-18 x 2" 12 47189 5 Nylock Nut, 1/4-20 23 43176 1 Carriage Bolt, 1/4-20 x 1" 13 48661 4
ページ5に含まれる内容の要旨
BEFORE YOU BEGIN TOOLS YOU WILL NEED FOR ASSEMBLY (2) 7/16" Wrenches (2) 1/2" Wrench (1) 1/2" or 9/16" Socket Wrench DETERMINE IF THERE IS A SINGLE OR DUAL MOWER DECK SUSPENSION BRACKET(S) UNDER THE FRONT OF YOUR TRACTOR Look under the front of your tractor. If there is a single mower deck suspension bracket located underneath the middle of the front axle as shown in figure 1A, continue on to page 6. If there are dual mower deck suspension brackets located underneath the front axle or loca
ページ6に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS FOR TRACTORS WITH SINGLE MOWER DECK SUSPENSION BRACKET NOTE: Right hand (RH) and left hand (LH) are 5/16" NYLOCK NUT determined from the operator's position while seated on the tractor. THIS HOLE IS HIGHER STEP 1: (Figure 2) Place the base bracket on a flat surface. Identify the 5/16" x 2" highest hole on each side of the bracket. CARRIAGE BOLT STEP 2: (Figure 2) Attach the base bracket as shown to the first and BASE LEG TUBE second holes from the end of the fla
ページ7に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS FOR TRACTORS WITH SINGLE MOWER DECK SUSPENSION BRACKET STEP 6: (Figure 6) UPPER BASE TUBE Insert the ends of the base leg tubes into the upper base tube. BASE TUBE LEGS FIGURE 6 STEP 7: (Figure 7) 5/16" x 1" ORIGINAL Raise the tractor seat and remove the seat springs and the BOLT HEX BOLT four bolts from the rear fender using a 1/2" socket. 5/16" WASHER STEP 8: SPRING If the seat springs were mounted to the rear holes go to step 9. If the seat springs were mounte
ページ8に含まれる内容の要旨
ASSEMBLY INSTRUCTIONS FOR TRACTORS WITH DUAL MOWER DECK SUSPENSION BRACKETS STEP 1: (Figure 8) BASE LEG TUBE 5/16" NYLOCK Identify and position the right base bracket as shown in (ROUND END) NUT figure 6. Attach the right base bracket to the front holes of SPACER a round base leg tube. Make only finger tight. Repeat 5/16" x 2-3/4" for the left base bracket. CARRIAGE BOLT LEFT BASE BRACKET HIGHEST HOLE RIGHT BASE BRACKET FIGURE 8 STEP 2: (Figure 9) UPPER BASE TUBE Insert the ends of the ba
ページ9に含まれる内容の要旨
CANOPY INSTALLATION STEP 1: (Figure 12) UPRIGHT Assemble the upright tubes to the base assembly. TUBES NOTE: If holes are difficult to align, loosen bolts attaching base tubes to mounting bracket(s). If hole alignment is still difficult, loosen bolts attaching mounting bracket to rear fender. Retighten all bolts when finished. 5/16" x 2" CARRIAGE BOLT PLASTIC KNOB 5/16" FLAT WASHER FIGURE 12 STEP 2: (Figure 13) 1/4" x 1-1/2" SUPPORT ROD Assemble the top tubes to the upright tubes. Do not
ページ10に含まれる内容の要旨
OPERATION Read this owner's manual and safety rules before operating your tractor with the sun shade. Check the area of operation thoroughly before using the CAUTION: This sun shade does not provide tractor with the sun shade. The added height of the sun protection against exhaust fumes, collision, shade and a reduced field of vision require extra caution rollover or other accidents. during operation. Remove the upper sun shade frame and canopy before you transport the tractor in an open
ページ11に含まれる内容の要旨
REPAIR PARTS FOR MODEL 71-24227 SUN SHADE 6 11 3 5 3 4 12 12 11 23 21 17 12 15 17 24 2 15 14 26 2 10 12 25 1 20 7 22 9 17 15 9 16 25 13 19 8 10 18 17 16 REF. PART QTY. DESCRIPTION REF. PART QTY. DESCRIPTION NO. NO. NO. NO. 1 49242 1 Base Top Tube 15 44977 6 Carriage Bolt, 5/16-18 x 2" 2 25014 2 Upright Tube 16 23658 4 Spacer 3 25013 2 Top Tube 17 47810 6 Nylock Nut, 5/16-18 4 25012 1 U-Tube 18 25303 1 Left Base Bracket 5 25015 3 Support Rod 19 25302 1 Right Base Bracket 6 48660 1 Vin
ページ12に含まれる内容の要旨
Get it fixed, at your home or ours! Your Home For repair – in your home – of all major brand appliances, lawn and garden equipment, or heating and cooling systems, no matter who made it, no matter who sold it! For the replacement parts, accessories and owner’s manuals that you need to do-it-yourself. For Sears professional installation of home appliances and items like garage door openers and water heaters. ® 1-800-4-MY-HOME (1-800-469-4663) Call anytime, day or night (U.S.A. and Canada) ww
