ページ1に含まれる内容の要旨
OPERATOR’S MANUAL
MODEL STT
PART NUMBER 03059
ページ2に含まれる内容の要旨
WARNING:
ページ3に含まれる内容の要旨
Section 1 GENERAL INFORMATION &
1.1 INTRODUCTION
)
! "#$%% #$&
ページ4に含まれる内容の要旨
Section 2 SAFETY INFORMATION 2.1 INTRODUCTION
2
%
*"$;< +,
0
0
1
ページ5に含まれる内容の要旨
Section 2 2.3 BEFORE OPERATION '9
$
CONSIDERATIONS (CONT'D)
6
" '' ?
@ A /
!
1
1
#
ページ6に含まれる内容の要旨
Section 2 '8 " 2.4 OPERATION CONSIDERATIONS (CONT'D) '> %
8 %
1
> # '6
ページ7に含まれる内容の要旨
Section 2 2.6 SAFETY AND INSTRUCTIONAL DECALS WARNING DANGER INSTALL BELT COVER BEFORE SPINNING BLADE OPERATING MACHINE READ OPERATOR'S MANUAL 481039 KEEP CLEAR CONTACT CAN INJURE FORWARD 48071 R F REVERSE WARNING 481568 ROTATING BLADES AND BELTS KEEP HANDS, FEET & CLOTHING CLEAR KEEP ALL GUARDS IN PLACE SHUT OFF ENGINE & DISENGAGE BLADE CLUTCH BEFORE SERVICING IMPORTANT ADJUSTMENT CLEAR AREA OF DEBRIS BEFORE MOWING PROCEDURES USE CAUTION IN DIRECTING DISCHARGE CAUTION KEEP BYSTANDERS, CHILDREN
ページ8に含まれる内容の要旨
Section 3 SPECIFICATIONS 3.1 ENGINE
! " !#$%&'() & ! " !#%*&$+) ,- ! ".%%'#/!( (') 0 ,-.%%' ,
ページ9に含まれる内容の要旨
Section 3 3.3 TRACTOR (CONT'D)
! A
., (#'(0
2
(#&0 3.4 CUTTER DECK A
ページ10に含まれる内容の要旨
Section 4 7
ページ11に含まれる内容の要旨
Section 4 OPERATING INSTRUCTIONS
CAUTION: ! Do not attempt to operate this mower unless you have read this manual. Learn the location and
" purpose of all controls and instruments before you
# operate this mower. $
% # $
ページ12に含まれる内容の要旨
Section 4 DUMP VALVE !! '
CONTROL LEVER
+
&
#
'
#
& % # " #! '
&
& '
#
%
'
ページ13に含まれる内容の要旨
Section 4 - 8
; 4.5 GROUND TRAVEL AND STEERING
4 <95 -IMPORTANT- = 8
%
# # 4 <=5 9 8
%
ページ14に含まれる内容の要旨
Section 4
# #
! # #
# #
, %
# #
#
'
$
ページ15に含まれる内容の要旨
Section 4 4.7 HILLSIDE OPERATION $ . WARNING: -
&
DO NOT operate on steep slopes. To check a slope,
attempt to back up it (with the cutter deck down). If the machine can back up the slope without the wheels slipping, reduce speed and use extreme = 8
%
#&
ページ16に含まれる内容の要旨
Section 4 ; +
4.10 REMOVING CLOGGED MATERIAL !
%
ROTATING BLADES > " # NEVER PUT YOUR HANDS INTO THE DISCHARGE CHUTE FOR ANY REASON! Shut off the engine and <
& remove the key and only then use a stick or similar @
!$@
ページ17に含まれる内容の要旨
Section 4 LANYARD PIN 4.13 ADJUSTING CUTTING HEIGHT
% &?
7/
>
76-/
#?
E WARNING: Do not adjust the cutting height with the mower blades rotating. Disengage the power to the cutter blades and then adjust cutting height. HEIGHT ADJUSTMENT PEDAL 390S0140 Figure 4-6 Adjusting Cutting Height 7 (
& - $
?
ページ18に含まれる内容の要旨
Section 5 TROUBLESHOOTING CUTTING CONDITIONS CAUSE CURE CONDITION Stringers - Occasional
Blades of Uncut Grass
Width of Deck ! " SGB020 Streaking - Strips of
Uncut Grass in Cutting Path #
ページ19に含まれる内容の要旨
Section 5 TROUBLESHOOTING (CONT'D) CAUSE CONDITION CURE Uneven Cut on Flat
Ground - Wavy High-Low !
Appearance, Scalloped Cut, or Rough Contour
&
' ( "
% ) )
*"
!
)
*"
Width of Deck SGB020 U
ページ20に含まれる内容の要旨
Section 5 TROUBLESHOOTING (CONT'D) CAUSE CURE CONDITION Scalping - Blades
Hitting Dirt or Cutting Very Close to
the Ground
)
.
%
)
.
