ページ1に含まれる内容の要旨
SET-UP INSTRUCTION & PRE-OPERATION CHECKLIST
SNAPPER 21" STEEL DECK COMMERCIAL RECYCLING WALK MOWERS
INTRODUCTION: The SNAPPER Walk Behind Mowers are shipped almost fully assembled and require minimal
set-up. Complete each of the following steps carefully. Review and complete each item as instructed on the
Pre-Operation checklist. The Snapper Product Registration card must be filled out and sent to Customer
Service department at Snapper when completed.
WARNING – DO NOT ATTEMPT TO STAR
ページ2に含まれる内容の要旨
STEP 4: To adjust handle height loosen bolts on both lower handle brackets. See Figure 4. Move handles up or down for desired height. See Figure 5. Tighten all bolts and nuts on all handles and brackets. MOVE SQUEEZE BRAKE UPPER CONTROL HANDLE UP OR DOWN FOR PROPER HEIGHT PULL RECOIL ROPE AND HOOK INTO ROPE GUIDE FIGURE 7 STEP 7: 1. Install Operator console onto upper handle section with four 1/4-20 x 1/2” torx screws. See Figure 8. 2. Firmly press Engine speed han
ページ3に含まれる内容の要旨
5. Thread rod in until upper end of rod aligns with DRIVE ASSEMBLY hole in bottom of ground speed control lever. See Figure 11. Insert upper end of rod into hole, STEP 1: and secure with 5/16” flat washer and hair pin. 1. Remove driven disc spring from driven disc 6. Slide Ground speed lever back, then fully assembly as shown. See Figure 9. forward again. Check driven disc position. If needed, repeat #5 above until 1/8” in Figure 10 is maintained, then tighten jam nut secu
ページ4に含まれる内容の要旨
STEP 2: IMPORTANT: Clutch cable adjustments are made to the machine at the factory. The following adjustments are provided for reference only. Complete all items on the Pre-Operation Checklist as instructed. Check the clearance between the clutch cable and clutch spring. NOTE: Clearance between spring and cable is very important. Excessive clearance will cause drive system NOT to operate when wheel drive control handle is depressed. No clearance at all will cause mower to
ページ5に含まれる内容の要旨
B. GRASS BAG DISCHARGE ASSEMBLY (Optional Accessory on Some Models) NOTE: Discharge assemblies vary by model. Some 1: Install grass bag adapter to the deck in place of assembly steps shown may not apply to your model. recycling cover. See Figure 16. Refer to side discharge deflector installation instructions. Your mower comes with a recycling cover already installed, and is ready for use as a recycling mower. The recycling cover is designed to remain on the machine at all t
ページ6に含まれる内容の要旨
3: Install the top wire to the grass bag. Tie the slider to FOAM BLADE BLOCK REMOVAL the top wire. Fold bag opening into a "Z" and install Tip mower back against the upper handle to gain access to slider. See Figure 17. the underside of the cutting blade. Remove foam shipping block from cutting blade. This must be removed before starting the engine. BAG SLIDER IMPORTANT: DO NOT tip machine with carburetor or spark plug down. Oil from crankcase will saturate the air “Z” FOLD BAG AS
ページ7に含まれる内容の要旨
NOTES 7
ページ8に含まれる内容の要旨
PRE-OPERATION CHECKLIST for SNAPPER 21” STEEL DECK COMMERCIAL RECYCLING WALK MOWERS Snapper has completed initial adjustments and performed operational tests prior to shipping the machine. Due to the possible effects of shipping, handling and storage, Snapper intends for all of the following items to be verified and necessary final adjustments made at time of setup. It remains good practice and is strongly recommended that all the items also be checked prior to placing the machine into s