Stiga 110 COMBI PRO 8211-0546-03の取扱説明書

ページ1に含まれる内容の要旨

STIGA PARK
2WD
110 Combi Pro
125 Combi Pro
8211-0546-03

ページ2に含まれる内容の要旨

2 1 1 2 3 4 5 6 7 8 C A B 2

ページ3に含まれる内容の要旨

10 9 1/3 12 11 D 13 24 Nm 3

ページ4に含まれる内容の要旨

EN ENGLISH 1 GENERAL 2 DESCRIPTION This symbol indicates WARNING. Seri- 2.1 General ous personal injury and/or damage to The cutting deck is intended for use on Stiga’s 2- property may result if the instructions wheel drive Park machines. are not followed carefully. The cutting deck is supplied in one of the follow- You must read these instructions for use ing versions: and the machine’s safety instructions • With manual adjustment of cutting height. carefully. • With electrical adjustment

ページ5に含まれる内容の要旨

EN ENGLISH 3.2 Belt 4.3 Mowing advice The cutting deck’s rear section should rest on the In order to achieve optimum mowing results, fol- floor (it should not be lifted or secured). low the advice below: Install the belt as follows: • Cut frequently. 1. Set the maximum cutting height. • Run the engine at full throttle. 2. Locate the belt around the machine’s belt pulley • The grass should be dry. (8:B). • Use sharp blades. 3. Tension the belt with the belt idler (8:A)B. The • Keep the undersid

ページ6に含まれる内容の要旨

EN ENGLISH 5.3 Service position 6 SPARE PARTS 1. Activate the parking brake. 2. Set the implement lifter in transport position. STIGA genuine spare parts and accessories are de- 3. Set the highest cutting height. signed specifically for STIGA machines. Please note that ‘non-genuine’ spare parts and accessories 4. If the deck has electrical cutting height adjust- have not been checked or approved by STIGA: ment, disconnect the cable from the machine. See fig. 7. The use of such parts and acces

ページ7に含まれる内容の要旨

www.stiga.com GGP Sweden AB · Box 1006 · SE-573 28 TRANÅS