Snapper Z-riderの取扱説明書

ページ1に含まれる内容の要旨

SET-UP INSTRUCTIONS & PRE-OPERATION CHECKLIST
SNAPPER ZERO TURNING Z-RIDER with MID MOUNT MOWER

INTRODUCTION: These instructions cover the set-up of the Snapper Mid Mount Z-Rider Mower. Complete each
of the following steps carefully. Review and complete each item as instructed on the Pre-Operation checklist.
The Snapper Product Registration card must be filled out and sent to Customer Service department at Snapper
when completed.

IMPORTANT: The battery for this unit is shipped dry. A p

ページ2に含まれる内容の要旨

STEP 13: HYDRAULIC OIL RESERVOIRS WARNING Check the level of the fluid in both of the fluid reservoirs. The Handle fuel with care! Use an approved fuel reservoirs are located underneath the operator’s seat. Wipe container. DO NOT smoke near open fuel container away all dirt and debris from around reservoir cap before and keep fuel container away from open flame. DO removing. Oil must remain absolutely clean! Check with NOT fill fuel tank indoors or when engine is machine on a level surfa

ページ3に含まれる内容の要旨

STEP 15: HYDRAULIC SYSTEM, PURGING HYDRAULIC After replacing or repairing hydraulic system RESERVOIRS components, one or both of the wheel drives may not pull properly. This is likely to be caused by air entrapped in the system. If you experience a pulling issue after completing repairs or during initial setup, perform the following procedure to purge the air from one or both of the hydraulic drive systems. IMPORTANT: WHEN REPLACING THE HYDRAULIC FLUID FILTERS, PRE-F

ページ4に含まれる内容の要旨

PRE-OPERATION CHECKLIST Snapper has completed initial adjustments and performed operational tests prior to shipping the machine. Due to the possible effects of shipping, handling and storage, Snapper intends for all of the following items to be verified and necessary final adjustments made at time of setup. It remains good practice and is strongly recommended that all the items also be checked prior to placing the machine into service. It is very important that setup is verified and all o