ページ1に含まれる内容の要旨
VIKING
111 Front Street
USE/INSTALLATION
Greenwood, Mississippi 38930 USA
(662) 455-1200
INSTRUCTIONS
VRBD/VUBD 24” W. BEVERAGE DISPENSER
Retain for Future Reference
IMPORTANT - PLEASE READ AND FOLLOW
•Before beginning, please read these instructions completely and carefully.
Do not remove permanently affixed labels, warnings, or plates from the product. This may void the warranty.
The installer should leave these instructions with the consumer for future reference.
GENERAL INFORMATION
1. A
ページ2に含まれる内容の要旨
Proper Disposal of Your Old Refrigeration Product Suffocation Hazard Remove doors from your old refrigerator. Failure to do so can result in child entrapment, which can cause death or brain damage IIM MP PO OR RT TA AN NT T:: Child entrapment and suffocation are not problems of the past. Junked or abandoned refrigerators are still dangerous, even if they will sit for “just a few days.” If you are getting rid of your refrigeration product, please follow the instructions below to help prevent ac
ページ3に含まれる内容の要旨
CASTERS Your beverage dispenser is equipped with four casters. the front two casters can be locked. For built-in applications, the four casters can be removed by removing the nut located inside the dispenser cabinet and then pulling the threaded caster spindle through the base of the unit. Lock and Unlock CABINET CUTOUT - FREESTANDING MODELS D A 24” (61.0 cm)* B 35 9/16” (90.3 cm)** A C 24” (61.0cm) D 24 3/4” (62.9 cm) B *24” width for cabinet only. 24 1/4” (61.6 cm) needed for cabinet and doo
ページ4に含まれる内容の要旨
DIMENSIONS - FREESTANDING MODELS FRONT SIDE 24 5/8” (62.5 cm) 2 1/16” 13 15/16” (5.2 cm) 1 1/4” (35.4 cm) (3.2 cm) 3/4” (1.9 cm) 24” 41 25/32” (61.0 cm) 35 9/16” (106.2 cm) (95.4 cm) 2 3/8” (6.0 cm) 22” (55.9 cm) 2 1/2” (6.4 cm) 4 3/16” (10.6 cm) 25 1/8” (63.8 cm) 12 7/8” (32.7 cm) TOP 13 3/4” (34.9 cm) 24 5/8” (62.5 cm) 23 1/8” (58.7 cm) 12 5/16” (31.3 cm) 3/4” (1.9 cm) TYP 3/4” (1.9 cm) TYP 4
ページ5に含まれる内容の要旨
CABINET CUTOUT - UNDERCOUNTER MODELS A 24” (61.0 cm)* B Min. 34 1/8” (87.9 cm Max. 35 1/8” (89.2 cm) C 24” (61.0 cm) *24” width for cabinet only. 24 1/4” (61.6 cm) needed for cabinet and door width clearance if door is recessed between cabinets. Rear Wall Countertop Countertop 1 1/2” (3.8 cm) 24” 12” (61.0 cm) (30.5 cm) 1 11/32” Standard (3.4 cm)TYP 1 11/32” Cabinet (3.4 cm)TYP 1 1/2” Depth (3.8 cm) dia. 25” 4” (63.5 cm) 8” 11” Standard (20.3 cm) (27.9 cm) (10.2 cm) Cabinet Depth 5” (12.7 cm)
ページ6に含まれる内容の要旨
DIMENSIONS - UNDERCOUNTER MODELS SIDE FRONT 23 7/8” 47 1/4” (120.0 cm) (60.7 cm) 30 3/4” Min 34” (78.1cm) (86.4 cm) Max 35” (88.9 cm) with leveling legs fully adjusted 22” (55.9 cm) 24 3/8” (61.6 cm) 26 7/8” (68.3 cm) 23 7/8” (60.7 cm) TOP 4” 12” (30.5 cm) (10.2 cm) 1 1/2” (3.8 cm) dia. 1 11/32” (3.4 cm) TYP 24 3/8” (61.9 cm) 2 11/16” (6.8 cm) TYP 11” 3/4” (1.9 cm) Dia. (27.9 cm) 5” 8” (12.7 cm) (20.3 cm) *Actual dimension of drain pan is 12” x 5” (30.5 cm x 12.7 cm) 6
ページ7に含まれる内容の要旨
ASSEMBLY 2. Insert the clear 1. Screw the black beverage line faucet knob onto from the tower the faucet. through the hole in the top of the unit. Mount the draft tower onto the refrigerator using the (4) furnished screws and (1) mounting gasket. 3. Attach the clear beverage line coming from the 4. Fasten the CO draft tower to 2 regulator to the the keg coupler. CO tank, Use the black 2 tightening the washer inside CO nut securely, 2 the hex nut and using the gray tighten securely fiber was
ページ8に含まれる内容の要旨
CO REGULATOR 2 1. Low pressure gauge. (reads the amount of internal keg pressure) 2. Adjustment lock nut. 3. Regulator adjustment screw (after keg is tapped, screw clockwise until low pressure gauge indicates between 12 & 14 lbs.) 4. Shut-off valve. 5. CO Nut (use fiber CO washer) 2 2 How to Replace an Empty CO Cylinder 2 1. Close cylinder valve by turning clockwise “A”. 2. Unscrew adjustment screw (counter-clockwise) “B” as far as it will go. 3. Remove the regulator from empty cylind
ページ9に含まれる内容の要旨
TAPPING PROCEDURES APPROXIMATE MEASUREMENTS REQUIRED TO TAP There are two keg sizes: MOST KEGS 1) the quarter barrel containing 7 3/4 gallons or Quarter Barrel Half Barrel approximately 3 1/2 cases of 12 ounce bottles or Height 17 - 21 inches 25 - 29 inches 2) the half barrel containing 15 1/2 gallons or Diameter 16 - 20 inches 18 - 22 inches approximately 7 cases. Weight 80 - 85 pounds 160 - 180 pounds SANKEY TYPE KEG COUPLER TM TM (Taps all Coors , Miller TM and Budweiser kegs) 1. Align
ページ10に含まれる内容の要旨
DRAIN HOSE AND CONTAINER Before using the beverage dispenser, make sure the drain hose and container are properly installed. 1. Attach the hose to the drain. 2. Attach the container to the hose. 3. Empty the container when it becomes full. 4. Rinse both the hose and container before reattaching to the beverage dispenser. Drain Drain hose Drain container FINAL PREPARATION All stainless steel parts should be wiped with hot soapy water. If buildup occurs, do not use steel wool, abrasive cloth
ページ11に含まれる内容の要旨
WIRING DIAGRAM 24” W. REFRIGERATED BEVERAGE DISPENSER W WA AR RN NIIN NG G:: E EL LE EC CT TR RIIC CA AL L G GR RO OU UN ND DIIN NG G IIN NS ST TR RU UC CT TIIO ON NS S This appliance is equipped with a three prong grounding plug for your protection against shock hazard and should be plugged directly into a properly grounded three prong receptacle. Do not cut or remove the grounding prong from this plug. OPERATING INSTRUCTIONS SETTING THE CONTROL o o NOTE: The control is factory set for
ページ12に含まれる内容の要旨
HOW TO DRAW THE PERFECT GLASS OF BEER 2. After the glass has reached half full, 1. Start with a clean beer glass that has been gradually bring the glass to an wetted in cold water. Place the glass at a o upright position. 45 angle, one inch below the faucet. Do .. not let the glass touch the faucet Open the faucet all the way. 4. Close the faucet completely and 3. Let the remaining beer run straight down quickly. the middle. This insures proper release of CO by producing a 3/4” to 1” fo
ページ13に含まれる内容の要旨
COMMON DRAFT PROBLEMS DESCRIPTION CAUSES Wild Beer Beer, when drawn, is all foam, or too much foam and Beer drawn improperly not enough liquid beer. Creeping regulator Applied pressure is set too high Hot spots in line Use of non-insulated beer line Beer runs are too long for proper cooling Tapped into a warm keg Cooler malfunctioning Kinks, dents, twists, or other obstructions in line Faucets in bad, dirty or worn condition Cloudy Beer When beer in glass appears hazy, not clear Frozen or nearly
ページ14に含まれる内容の要旨
CLEANING AND MAINTENANCE Condenser The condenser tubing under the cabinet for forced air units does not require frequent cleaning. However, satisfactory cooling depends on adequate ventilation over the condenser. Be sure that nothing obstructs the air flow openings in the lower front of the cabinet. At least once or twice a year brush or vacuum lint and dirt from the condenser for efficient performance by unscrewing the grill on the bottom front of the cabinet. Cabinet The painted cabinet can
ページ15に含まれる内容の要旨
PROFESSIONAL SERIES 24” W. BEVERAGE DISPENSER WARRANTY ONE YEAR FULL WARRANTY Built-in/freestanding beverage dispensers and all of their components and accessories, except as detailed below*, are warranted to be free from defects in material or workmanship under normal household use for a period of one (1) year from the date of original retail purchase. Viking Range Corporation, warrantor, agrees to repair or replace, at its option, any part which fails or is found to be defective during the wa
ページ16に含まれる内容の要旨
Specifications subject to change without notice F1755F (PS0205VR)
