ページ1に含まれる内容の要旨
ページ2に含まれる内容の要旨
This Operator’s Manual is an important part of your new equipment. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Table of Contents Slope Gauge........................................................ 3 Off-Season Storage .......................................... 11 Safe Operation Practices ................................... 4 Trouble Shooting .............................................. 12 Set-Up & Adjustments ......
ページ3に含まれる内容の要旨
ページ4に含まれる内容の要旨
WARNING: Engine Exhaust, some of its constituents, and certain vehicle components contain or emit chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. DANGER: This machine was built to be operated according to the rules for safe operation in this manual. As with 2 any type of power equipment, carelessness or error on the part of the operator can result in serious injury. This machine is capable of amputating hands and feet and throwing obje
ページ5に含まれる内容の要旨
3. Always be sure of your footing. A slip and fall can cause serious 13. To reduce fire hazard, keep mower free of grass, leaves, or personal injury. If you feel you are losing your balance, release other debris build-up. Clean up oil or fuel spillage and remove the blade control handle immediately, and the blade will stop any fuel soaked debris. rotating within 3 seconds. 14. Allow a mower to cool at least 5 minutes before storing. Do Not: General Service: 2 1. Do not mow near drop-offs, di
ページ6に含まれる内容の要旨
ページ7に含まれる内容の要旨
ページ8に含まれる内容の要旨
ページ9に含まれる内容の要旨
WARNING: If you strike a foreign object, stop the engine. Remove wire from the spark plug, thor- oughly inspect the mower for any 4 damage, and repair the damage before restarting and operating the mower. Extensive vibration Operating of the mower during operation is an indication of damage. The unit Your Lawn should be promptly inspected and repaired. Mower Operating Tips 1. To engage the drive, squeeze the drive control handle towards the upper handle. Release the drive contr
ページ10に含まれる内容の要旨
ページ11に含まれる内容の要旨
ページ12に含まれる内容の要旨
Problem Cause Remedy Engine fails to start 1. Blade control handle disengaged. 1. Engage blade control handle. 2. Spark plug wire disconnected. 2. Connect wire to spark plug. 6 3. Fill tank with clean, fresh gasoline. 3. Fuel tank empty or stale fuel. 4. Engine not primed. 4. Refer to engine manual. 5. Faulty spark plug. 5. Clean, adjust gap, or replace. Trouble 6. Clean fuel line. 6. Blocked fuel line. 7. Engine flooding. 7. Wait a few minutes to restart, but do not prime. Shooting Engine runs
ページ13に含まれる内容の要旨
FOUR YEAR SUPREME WARRANTY: For four years from date of retail purchase within Canada, MTD PRODUCTS LIMITED will, at its option, repair or replace, for the original purchaser, free of charge, any part or parts found 7 to be defective in material or workmanship. This warranty covers units which have been oper- ated and maintained in accordance with the owner’s instructions furnished with the unit, and Warranty which have not been subject to misuse, abuse, commercial use, neglect, accident impr
ページ14に含まれる内容の要旨
ページ15に含まれる内容の要旨
REF PART NO. NO. N° DE N° DE RÉF PIÈCE DES CRIPT ION DE SCRIPT ION 1 712-0214 Hex L-Nut 3/8-24 Contre-écrou à six pans 3/8-24 8 2 736-0105 Cupped Washer Rondelle creuse 3 756-04132 Pulley, 3.82 x .313 x .68 Poulie 3,82 x 0,313 x 0,68 4 710-04329 Torx Screw Vis torx 5 707-04567A Trans mis sion Bracket Support de la transm ission Parts List 6 726-04043 Push Nut Écrou poussée 7 736-04178A Slot ted Washer Rondelle 8 731-05187 Clutch Lev er Levier de l'embrayage Pièces 9 721-04110 O-ring Bague en «
ページ16に含まれる内容の要旨
ページ17に含まれる内容の要旨
REF PART NO. NO. N° DE N° DE RÉF PIÈCE DES CRIPT ION DE SCRIP TION 1 746-04206A Drive Ca ble Câble de la commande1 2 731-04150C Rear Baf fle 21" Rear Dis charge Déflecteur arrière 21 po éjection arrière 8 3 710-01241 Hex Lock Screw 1/4-15 x 1.0 Vis à tête hex. 1/4-15 x 1,0 4 731-2626 Bail Cover - Black Couvercle - noir 731-04204 Bail Cover - Red Couvercle - rouge Parts List 5 747-1161A Blade Con trol Han dle Poignée de commande de la lame 6 749-04209B Up per Han dle Guidon supérieur 7 787-01258
ページ18に含まれる内容の要旨
NOTES: For parts and/or accessories refer to customer support on page 2. Adressez-vous au «Service après-vente» à la page 2 pour ce qui concerne les pièces et/ou accessoires. 1
ページ19に含まれる内容の要旨
GARANTIE SUPRÊME DE QUATRE ANS MTD PRODUCTS LIMITED s’engage à réparer ou à remplacer gratuitement, à son choix, à l’acheteur initial, la ou les pièces qui s’avèrent défectueuses en raison d’un vice de matière ou de 7 fabrication dans les quatre ans qui suivent la date d’achat au détail au Canada. Cette garantie s’applique seulement aux machines qui ont été utilisées et entretenues conformément aux instruc- tions publiées dans la notice d’utilisation accompagnant la machine, qui n’ont pas fai
ページ20に含まれる内容の要旨
Problème Cause Solution Le moteur ne 1. La poignée de commande de la lame n’est 1. Embrayez la poignée de commande de pas embrayée. la lame. démarre pas. 6 2. Fil de la bougie débranché. 2. Branchez le fil à la bougie. 3. Le réservoir est vide ou l’essence est 3. Faites le plein avec une essence propre éventée. et fraîche. 4. Moteur non amorcé. 4. Consultez la notice d’utilisation du Dépannage moteur. 5. La bougie est défectueuse. 5. Nettoyez, réglez l’écartement ou replacez la bougie. 6. C
