Revolabs Inc.8000の取扱説明書

ページ1に含まれる内容の要旨

Revolabs Single Channel Wireless Microphone System- Tandberg 6000 / 8000
MXP Setup Guide
NOTES AND CAUTIONS:


This setup guide will guide you through the steps needed to properly connect a Revolabs
Single Channel System to a Tandberg 6000 / 8000 MXP video codec.

1. Connecting the Cables
2. Configuring the 6000 / 8000 MXP Video Codec

Note: It is important to carefully follow these instructions in order and completely.
Otherwise your Single Channel System and/or the video codec may

ページ2に含まれる内容の要旨

Connecting the Cables CONNECTING A REVOLABS SINGLE CHANNEL TO TANDBERG 6000 / 8000 MXP VIDEO CODEC 1. Connect the 07-STEMIC-PPP cable between the 2.5mm analog output of the Revolabs Single Channel to the MIC 1 input of the Tandberg 6000 / 8000 MXP

ページ3に含まれる内容の要旨

Configuring the 6000 / 8000 MXP Video Codec CONFIGURING THE AUDIO MENUS OF THE 6000 / 8000 MXP VIDEO CODEC 1. Go to AUDIO SETTINGS 2. Select INPUTS 3. Confirm that MIC 1 is ON 4. Adjust the audio Input Type Level if necessary (recommend +8dB) 5. Speak into the Revolabs microphones that are connected to MIC 1. The audio meter should peak at about 5dB for normal speech.

ページ4に含まれる内容の要旨

6. Return to previous menu and select ECHO CONTROL 7. Enable MIC 1 Echo Canceller (ON) 8. Return to previous menu and select AUDIO LEVELING (AGC) 9. Turn MIC Audio Leveling (AGC) OFF