ページ1に含まれる内容の要旨
User’s Manual
ページ2に含まれる内容の要旨
Table of Contents 1. Introduction 1.1 About the KanguruMicro MP3 --------------------------------------------------2 1.2 Features -----------------------------------------------------------------------------3 2. How to use KanguruMicro MP3 player 2.1 Mechanical parts------------------------------------------------------------------4 2.2 How to install replacement battery--------------------------------------------4 2.3 Function-------------------------------------------------
ページ3に含まれる内容の要旨
Important Notice: Some computers may have a small power leakage from the USB port. To avoid any direct damage caused to KanguruMicro MP3, we suggest you use the extension cable, USB hub, or docking station to connect the KanguruMicro MP3 to your computer. Do not plug the KanguruMicro MP3 directly into the computer. 1. Introduction 1.1 About the KanguruMicro MP3 Palm Sized MP3 Player PLUS Portable Storage! The KanguruMicro MP3 is a portable USB flash drive AND MP3 Player r
ページ4に含まれる内容の要旨
1.2 Features - Supports MP3 music format - Earphone jack: 2.5 mm - Universal Headphone adapter - Audio output: 5mW+5mW - Output frequency range: 20HZ – 20KHZ - Battery: Lithium-ION 500mA 3.7V - Battery Life: 7.5 hours of continuous use at full charge - Support USB specification revision 1.1 - Transferring rate: up to 12MB per second at “Full Speed”. - Power saving mode to reduce power consumption while unit is idle. - Supported by Windows 2000, ME, XP, Mac OS 8.6 or above and Linu
ページ5に含まれる内容の要旨
2. How to use KanguruMicro MP3 player 2.1 Mechanical parts 2.2 How to install a replacement battery 1. Remove battery cover by pressing two sides. 2. Connect battery’s cord to the power port. 3. Put back battery cover. 4. Connect to USB port to fully charge battery for first time use. 4
ページ6に含まれる内容の要旨
2.3 Function: MP3 player mode 1. The MP3 function is enabled when the earphones plugged in. (Earphone port is 2.5mm) 5
ページ7に含まれる内容の要旨
2. Press the Control Switch button once: Play / Pause Slide to right side and hold to increase the volume. 3. Slide to left side and hold to lower the volume. Volume down Volume raise 6
ページ8に含まれる内容の要旨
4. Quick pull to right side: next song Quick pull to left side: previous song previous song next song 5. Power LED: (i) Plug KanguruMicro MP3 into USB port to re-charge battery through computer. Orange LED light indicates battery is charging. (ii) Green LED light indicates battery is fully charged. Power LED 7
ページ9に含まれる内容の要旨
6. Play LED: (i) Red LED light indicates you are in MP3 player mode. (ii) Red LED light flashes quickly when no MP3 files are found. (iii) Red LED flashes slowly when you pause MP3 player. (iv) Green LED indicates you are in USB removable disk mode. (v) Green LED blinks when you are reading/writing. Play LED 7. Read/Write protection 8
ページ10に含まれる内容の要旨
7. To charge battery: plug the unit into a USB port of notebook or desktop computer. For best results, please charge at least 1 hour and 45 minutes. 9
ページ11に含まれる内容の要旨
3. How to Install / Modify / Repair / Remove driver 3.1 Windows 98/98SE Installation： (1) Go to CD or floppy disk driver in “My Computer.” (2) Execute “Setup.exe” by double click on the icon. (3) Follow the instructions and click “Next”. 10
ページ12に含まれる内容の要旨
(4) System will install all the necessary files into your Windows operating system. After setup installation completed, click “OK” to restart computer. Once the installation has finished completely, you can see a “Removable Disk” in “My Computer” when you plug in the KanguruMicro MP3. 11
ページ13に含まれる内容の要旨
3.2 Modify or repair driver for Win 98 / Win 98 SE (1) If you have previously installed the drivers you will see the following screen after executing the “Setup.exe” file again. If somehow the driver is damaged, you can select “Repair” to fix the corrupted files. Select “Modify” or “Repair” and then click “Next”. (2) Select all files and click “Next”. 12
ページ14に含まれる内容の要旨
(3) Click “Finish” to complete modification. 13
ページ15に含まれる内容の要旨
3.3 Remove driver from Win 98 / Win 98 SE (1) To remove the driver from your operating system. Execute the “Setup.exe” file from CD driver disk again. Select “Remove” and click “Next”. (2) System will then ask you to confirm deletion. Click “OK”. (3) This screen may or may not appear. If your system asks you to confirm the files for deletion just click “Yes”. 14
ページ16に含まれる内容の要旨
(4) Click “Finish” to complete the process of removing device driver from your system. 15
ページ17に含まれる内容の要旨
3.4 Windows ME / Windows 2000 / XP Installation For these three operating systems NO Driver is needed, because Windows has built-in driver to support USB removable disk. Simply plug the KanguruMicro MP3 into the USB port and it will be recognized by the system. Once installation has completed, you will see a “Removable Disk” drive in My Computer. 4 Removing the KanguruMicro MP3 After using the KanguruMicro MP3, please choose one of the methods below according to your Operati
ページ18に含まれる内容の要旨
5 Linux 2.4.0 + / Mac 8.6 + Installation Again, No Driver is required for these two operating systems. Simply plug the KanguruMicro MP3into the USB port and the system will automatically find the KanguruMicro MP3. After using the KanguruMicro MP3, you can unplug the unit from the USB port directly once the LED stops blinking, and then its icon will disappear automatically. For Linux user, please refer to Important Notices. Important Notices： (i) In Windows 98/98SE, run the s
ページ19に含まれる内容の要旨
Warranty: This product carries a 1-year limited warranty from the date of purchase. - 1 Year for the Flash Memory - 6 months for the lithium battery. - 90 days labor Tech Support If you experience any problems installing your KanguruMicro MP3 or have any technical questions regarding any of our products, please call our tech support department. Our tech support is free and available Monday thru Friday, 9am to 5pm EST. Call 1-508-663-0105 or Visit our website at www.KanguruSo
