ページ1に含まれる内容の要旨
EN
ページ2に含まれる内容の要旨
Main Connections (For UK only) If the colours of the wires in the mains lead of CAUTION: EN this apparatus may not correspond with the For UK Only coloured markings identifying the terminals in CONNECT THE MAIN LEAD INTO AC MAINS your plug, proceed as follows: POWER SOCKET BLUE wire to the terminal coded N (Neutral) or POWER SUPPLY 230V. It must not be connected coloured black. to D.C. mains. BROWN wire to the terminal coded L (Live) or Note: The mains lead of the set is fitted with a coloured
ページ3に含まれる内容の要旨
Safety Information TECHNICAL SPECIFICATIONS: Please respect the environment. EN Power supply Before throwing any batteries AC 230V ~50Hz away, consult your distributor who Clock backup:9V 6F22 may be able to take them back for Power consumption: 7W specific recycling. • Make sure that you keep your • No naked flame sources, such as lighted set away from water and high candles, should be placed on the apparatus. temperatures. • Attention should be drawn to the • Do not use your system envi
ページ4に含まれる内容の要旨
Battery Back-Up Operation This clock radio is equipped with a memory Install battery as follows: EN holding system that can be powered with 1. Remove battery compartment door (lo- a 9V battery (not included). The power cated at the bottom of the radio) by ap- failure protection circuit will not operate plying thumb pressure to area indicated unless battery is installed. on battery door and then lift the door When normal household power is inter- out and off the cabinet. rupted, or AC line cord
ページ5に含まれる内容の要旨
d w F E E N M U I T T w e R BAND SET ALARM Operating the radio EN Memory Set Recall Tuning the Stations Recalling the Stations 1. Press ON/BAND (located on the top of 1. Press ON/BAND to turn on the radio. the radio) to turn on the radio. 2. Press MEMORY RECALL to select the 2. Press ON/BAND to change the broad- preset station (if available). cast band (FM/MW for RR96M only, FM/ LW for RR96L), press OFF to turn off Automatic station search the radio. 1. Press ON/BAND (located on the top of 3. Pr
ページ6に含まれる内容の要旨
d w F E E N M U I T T w e R BAND SET ALARM Operating the clock EN Memory Set Recall Setting Clock Time Setting the Wake Time Your digital clock operates on a 24-hour 1. Press the SET button once to set standard mechanism. ALARM 1 (1 will flash on display), twice to set ALARM 2 (2 will flash on 1. Press the SET button until a clock icon display). is shown on display. 2. Press REV or FWD to set wake time. 2. Press REV or FWD to set the clock time. 3. When wake time is set. You can exit When you
ページ7に含まれる内容の要旨
Operating the Alarm Waking by Selected Source Turning off Alarm EN Silence the alarm momentarily Programme Press SNOOZE. The alarm will sound again You may be woken up by music or when the snooze period is over. alarm . 1. Select an AM or FM station. (refer to Stop the alarm “Tuning the Stations”) Press OFF. Then the alarm will be on the 2. Set wake time (see above direction). following day at the same time. 3. Press the ALARM 1 or ALARM 2 but- ton to select waking up by music or Disable th
ページ8に含まれる内容の要旨
Other Functions Nap Mode Sleep Mode EN This function wakes you up after a short In sleep mode, the radio will turn off au- period of time. Simply: tomatically. Simply: 1. Press NAP and release. The NAP indi- 1. Press SLEEP then the time display will cator will flash. exhibit 0:59 and the radio will turn on. 2. When the indicator is flashing, press 2. While holding SLEEP, press REV or FWD REV or FWD to adjust nap time (from to set the sleep time. The time range is 10 minutes to 2 hours at an
ページ9に含まれる内容の要旨
Other Functions Snooze Alarm Operation Brightness control EN This operation allows extra sleep time af- You can adjust the backlight by the ter the alarm is on. The alarm will be off BRIGHTNESS button, there are three by pressing SNOOZE until the snooze pe- modes you may select from: riod is over. Snooze function can be used repeatedly up to 2 hours. After this, the OFF - Backlight off. alarm will turn off until the next alarm con- HIGH - Backlight always high. ditions are met. Set the “quiet t
