ページ1に含まれる内容の要旨
DM-950 DJ Mixer
Operating Instructions
INSIDE THE BOX:
(1) DM-950 DJ (1) DM-950
Mixer Power Adapter
ページ2に含まれる内容の要旨
Thank you for buying this Numark product package. Please read these operating instructions so you will know how to operate all of this equipment properly. After you have finished reading these instructions, keep them for future reference. WARNING: TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOISTURE. CAUTION: This product satisfies FCC regulations when shielded cables and connectors are used to connect the unit to other equipment. To prevent electromagnetic interfere
ページ3に含まれる内容の要旨
CAUTION! TO PREVENT THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. IMPORTANT The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of un-insulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. NOTICE The exclamation point within an equilateral tri
ページ4に含まれる内容の要旨
MIXER CONTROLS General Mixer Controls for DM-950 1. AC In and Power Switch This mixer is compatible only with the included power cable. Connect the AC plug into the jack on the rear of the mixer (A.) The mixer should be switched on after all devices are already connected to prevent damage to your equipment. A Red Power LED indicates that the unit has been switched on. 2. Master Volume This rotary control adjusts the main output levels for any equipment connected to the Master Output on the rear
ページ5に含まれる内容の要旨
21 3 4 5 6 7 8 9 11 10 G H A B C D E F MIXER CONTROLS PAGE 4
ページ6に含まれる内容の要旨
MIXER CONTROLS continued Input and Power Section NOTE: It is recommended that the mixer be turned off before connecting or disconnecting anything to/from the mixer. A. Power Switch and AC Jack Use only the included AC Power Adapter when operating this mixer. See Control 1 for additional notes on powering the mixer. B. RCA Master Output This RCA output is for connecting an external monitoring device such as a PA system, powered monitors or a home stereo. The level of the master stereo output sign
ページ7に含まれる内容の要旨
SETUP & INSTALLATION This mixer was designed to be placed between turntables and table top CD players. It is important that there is at least ¼" (7mm) between the mixer and the turntables or CD players to prevent damage to the equipment and to reduce unwanted system noise. Mixer Mixer 85 mm ¼" ¼" Setup Style 1 (traditional) Best For: Long mixes and blending techniques ¼" ¼" Setup Style 2 (battle style, scratching) Best For: Scratching, cutting and aggressive mixing techniques There are many vari
ページ8に含まれる内容の要旨
SPECIFICATIONS Inputs: Line: 18K ohm input impedance 200mV rms sensitivity for 4V output Mic: 3K ohm input impedance unbalanced 2mV rms sensitivity for 4V output 20mV rms max input Phono: 47K ohm input impedance 3mV rms sensitivity @ 1KHz for 4V output Outputs: Master: 8V rms max Headphone: 125mW into 32 ohm Distortion: less than 0.1% S/N Ratio: (maximum output) JIS-A weighted Line: Better than -90dB Mic: Better than -59dB Phono: Better than -65dB Frequency response: Line: 20Hz-20KHz +/-3dB Mic:
ページ9に含まれる内容の要旨
LIMITED PRODUCT WARRANTY 1. What is covered and for how long? NUMARK INDUSTRIES LCC ("NUMARK") warrants to the original purchaser that NUMARK'S mixers are free from defects in material and workmanship under normal use and service for the period commencing upon the date of purchase from an authorized NUMARK dealer and continuing for the following period of time after that date: 2Years 3 Years with the completion of the warranty card provided that the warranty card is completed and returned within
ページ10に含まれる内容の要旨
RETURN INFORMATION (US ONLY) a) A Return Authorization number must be obtained from Numark through the address or phone numbers below. b) A copy of the original sales receipt must also be included for the equipment to be repaired under warranty. c) The faulty equipment must be packed in its original packaging. d) One additional outer layer of packaging must be included to ensure product safety. Failure to do so may inadequately protect the equipment in transit and, therefore, jeopardize the cust
ページ11に含まれる内容の要旨
Problem Cause? Solution Mixer does not turn on. Disconnected Power Cord? Connect Power Cord. The sound level is very low. The Turntable is not connected to a Connect the turntable to the input device with a PHONO preamp. labeled PHONO, not the LINE. The sound is on one side only. The RCA audio cord is Properly secure the RCA cable to disconnected. the mixer. The RCA audio cord is damaged. If the RCA cord is frequently connected and disconnected, it may have become damaged and needs to be replace
ページ12に含まれる内容の要旨
INSIDE THE BOX: (1) DM-950 DJ (1) DM-950 Mixer Power Adapter DM950 Manual/ English Copyright Numark Industries, LLC 2002
