ページ1に含まれる内容の要旨
instruction manual
AXC-INP8
Switch/Opto Voltage Input Card
Axcess Control Cards
ページ2に含まれる内容の要旨
AMX Limited Warranty and Disclaimer AMX Corporation warrants its products to be free of defects in material and workmanship under normal use for three (3) years from the date of purchase from AMX Corporation, with the following exceptions: • Electroluminescent and LCD Control Panels are warranted for three (3) years, except for the display and touch overlay components that are warranted for a period of one (1) year. Disk drive mechanisms, pan/tilt heads, power supplies, MX Series products, a
ページ3に含まれる内容の要旨
Table of Contents Table of Contents Product Information .................................................................................................1 Input Mode Selections .............................................................................................3 Input Mode Selection Jumpers.......................................................................................... 3 Voltage Mode ..............................................................................................
ページ4に含まれる内容の要旨
Table of Contents ii AXC-INP8 Eight Switch/Opto-Logic Voltage Input Card
ページ5に含まれる内容の要旨
Product Information Product Information The AXC-INP8 Switch Opto Voltage Input Card provides eight inputs that can respond to switch closures or voltage level (high/low) changes. Input signals may originate from tape transports, limit switches, foot mats, or the AMX PCS Power Current Sensor. Each input may be set for either switch closure (SW) or voltage operation (VO), allowing a combination of either application on the same AXC-INP8 card. Inputs set to the switch mode share the same Axcess
ページ6に含まれる内容の要旨
Product Information 2 AXC-INP8 Eight Switch/Opto-Logic Voltage Input Card
ページ7に含まれる内容の要旨
Input Mode Selections Input Mode Selections Input Mode Selection Jumpers FIG. 1 shows the Input Mode selection jumpers. 1 A Input 1 B 2 A 3 Input 2 B 4 5 A Input 3 B 6 A 7 Input 4 8 B 9 A Input 5 B 10 11 A Input 6 12 B 13 A Input 7 B 14 A 15 Input 8 B 16 FIG. 1 Input Mode selection jumpers Voltage Mode Voltage Mode is used to sense high and low voltage states, commonly from AC or DC signals from relay-controlled tape transports and LED feedback from preset dimming systems. This mode provides
ページ8に含まれる内容の要旨
AMX reserves the right to alter specifications without notice at any time. brussels dallas los angeles mexico city philadelphia shanghai singapore tampa toronto york 3000 research drive, richardson, TX 75082 USA 469.624.8000 800.222.0193 fax 469.624.7153 technical support 800.932.6993 © 031-004-2459 6/01 2001 AMX Corporation. All rights reserved. AMX, the AMX logo, the building icon, the home icon, and the light bulb icon are all trademarks of AMX
