ページ1に含まれる内容の要旨
Freescale Semiconductor, Inc.
ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005
Bluetooth Headset
User’s Guide
94001480400/D
Rev. 1.5, 2002-09-02
For More Information On This Product,
Go to: www.freescale.com
Freescale Semiconductor, Inc...
ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005
ページ2に含まれる内容の要旨
Freescale Semiconductor, Inc. ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 Motorola reserves the right to make changes without further notice to any products herein. Motorola makes no warranty, representation or guarantee regarding the suitability of its products for any particular purpose, nor does Motorola assume any liability arising out of the application or use of any product or circuit, and specifically disclaims any and all liability, including without limitation consequential or
ページ3に含まれる内容の要旨
Freescale Semiconductor, Inc. ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 Contents Chapter 1 Introduction 1.1 About This Document. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 1.2 Brief Description of Functionality . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1-1 Chapter 2 User Interface 2.1 Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
ページ4に含まれる内容の要旨
Freescale Semiconductor, Inc. ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 iv Headset MOTOROLA For More Information On This Product, Preliminary Go to: www.freescale.com Freescale Semiconductor, Inc... ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005
ページ5に含まれる内容の要旨
Freescale Semiconductor, Inc. ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 Chapter 1 Introduction 1.1 About This Document This document is the users guide accompanying the headset included with the Development Kit for the Bluetooth Platform Solution from Motorola. This introduction includes a brief description of the headset functionality. The following sections describe the user interface and system operational modes. 1.2 Brief Description of Functionality The Development Kit hea
ページ6に含まれる内容の要旨
Freescale Semiconductor, Inc. Introduction ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 1-2 Headset MOTOROLA For More Information On This Product, Preliminary Go to: www.freescale.com Freescale Semiconductor, Inc... ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005
ページ7に含まれる内容の要旨
Freescale Semiconductor, Inc. ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 Chapter 2 User Interface 2.1 Buttons The headset is equipped with a user interface including three buttons, referred to as VOL+, VOL-, and BT (Bluetooth). On the silk print of the Development Kit PCB, these buttons are designated +, -, and FUNC1 respectively. FUNC2 is never used. 1 The BT button is mainly used for connection management, including connection transfer , as well as muting the headset microphone.
ページ8に含まれる内容の要旨
Freescale Semiconductor, Inc. User Interface ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 2.2 System States and LED Indications The following information relates to the figure below showing LED Flash Patterns and Coherence. The system state is indicated by either a green or a red LED. The red LED is used for indicating the battery state exclusively, whereas the green LED indicates all other system state information. On theleft side in Figure 2-1, all possible state transitions are sho
ページ9に含まれる内容の要旨
Freescale Semiconductor, Inc. System Events and Audio Indications ARCHIVED BY FREESCALE SEMICONDUCT Table 2-2. LED Indications (Continued)OR, INC. 2005 System States Green ON Time Red ON Time Outgoing connection 500 ms on, 500 ms off, 500 ms on Outgoing connection—batt. very low 500 ms on, 500 ms off, 500 ms on Same as green LED Connected 500 ms on Connected—batt. very low 500 ms on Same as green LED Call active 1000 ms on Call active—Tx muted 450ms on, 100 ms off, 450 ms on Call active—
ページ10に含まれる内容の要旨
Freescale Semiconductor, Inc. User Interface ARCHIVED BY FREESCALE SEMICONDUCT Table 2-3. Audio Indications (Continued)OR, INC. 2005 Indication Name Indicated Event Frequency Duration Sound Pairing complete Successful pairing 1.3 kHz 150 ms di-diip off 50 ms 2 kHz 350 ms Reset to default All settings reset to 500 Hz 500 ms doop their factory settings Ring Incoming call 800 Hz 250 ms duu-duup off 50 ms 650 Hz 350 ms Long button Press Long button press 500 Hz 150 ms dop was registered Shor
ページ11に含まれる内容の要旨
Freescale Semiconductor, Inc. ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 Chapter 3 System Operational Modes This section describes typical operations that the user must carry out to operate the Development Kit headset. It is divided into a number of use situations, each focusing on an aspect of system use. Refer to Chapter 2, User Interface for an overview of the system MMI, including button action matrix and illustrations of audible and visual system indications. On the silk print
ページ12に含まれる内容の要旨
Freescale Semiconductor, Inc. System Operational Modes ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 3.2 Incoming Connection The AG will usually establish a connection to the headset no later than when the AG, or the equipment to which it is connected, initiates an outgoing or detects an incoming call, where call might be a connection 2 over the POTS , a Voice-over-IP connection, or a mobile phone call. Regardless of whether the AG initiates the call or detects an incoming call, th
ページ13に含まれる内容の要旨
Freescale Semiconductor, Inc. Call Active (Ongoing Audio Connection) ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 It is up to the AG to decide the right behavior in this situation. Possible actions include dialing a pre-programmed number, requesting user input via a pop-up window, or prompting the user for spoken input for speech recognition processing. However, the AG will be expected to add a voice connection over the established data connection at some point, in accordance with the
ページ14に含まれる内容の要旨
Freescale Semiconductor, Inc. System Operational Modes ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 The headset supports entering Sniff Mode while maintaining an HV2 or HV3 link. This can be achieved in one of two ways: 1. The AG accepts the Sniff request send by the headset when the data link was established, without pulling the headset out of Sniff Mode when adding the SCO link. 2. The AG requests to put the headset in Sniff Mode when the SCO link has been established. 3.5 Connecti
ページ15に含まれる内容の要旨
Freescale Semiconductor, Inc. Configuration Mode (Bonding) ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 If the link is lost, the user is notified by an audio indication. The headset then cleans up all internal connection variables, and returns to the connection scan (idle) state, as if it had just been powered up. Thus, it will be ready for any reconnect attempt from the AG. 3.8 Configuration Mode (Bonding) From time to time, the user may want to reconfigure the headset, either to ch
ページ16に含まれる内容の要旨
Freescale Semiconductor, Inc. System Operational Modes ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005 3-6 Headset MOTOROLA For More Information On This Product, Preliminary Go to: www.freescale.com Freescale Semiconductor, Inc... ARCHIVED BY FREESCALE SEMICONDUCTOR, INC. 2005
