Rosewill SATA+Ultra ATA Raid Controller RC212の取扱説明書

ページ1に含まれる内容の要旨

SATA+Ultra ATA RAID CONTROLLER RC212
User Manual

ページ2に含まれる内容の要旨

SATA+ Ultra ATA RAID CONTROLLER RC212 User Manual Feature Highlights Compliant with PCI Specification, Rev. 2.2 Compliant with PCI “Plug & Play” 32-bit 33 MHz PCI interface Drive support: Serial ATA, Ultra ATA/133, Ultra ATA/100,Ultra ATA/66 Support ATA/ATAPI6 Supports SATA up to 150MB/Sec 48-bit LBA Support: Recognizes drives bigger than 137GB Support Windows 98SE, ME, 2000, XP, Server 2003 ant NT 4.0 Support RAID 0, 1, 0+1 and JBOD Pa

ページ3に含まれる内容の要旨

SATA+ Ultra ATA RAID CONTROLLER RC212 User Manual C SATA Connector (Internal) D SATA Connector (Internal) E PATA Connector F Jumpers control BC Switch G Jumpers control AD Switch IDE/RAID: Jumper Settings JP Description J8-J11 1-2 Enable SATA Connector B close 2-3 Enable SATA Connector C close J12-J15 1-2 Enable SATA Connector A close 2-3 Enable SATA Connector D close Default Mode is all jumper 2-3 close, so C-D is active and

ページ4に含まれる内容の要旨

b e e SATA+ Ultra ATA RAID CONTROLLER RC212 User Manual r r r attached hard drives. Please follow the steps below to setup your disk array. Warning: Please backup data in your hard drives to prevent data damage resulting from the unfamiliarity with the operation. Boot your system Please attach your hard drives to the VIA VT6421 RAID card, boot your system and then you will see the following message shown by the VIA VT6421 RAID card onboard BIOS on th

ページ5に含まれる内容の要旨

SATA+ Ultra ATA RAID CONTROLLER RC212 User Manual Array Mode RAID 1 (Mirroring) Select Disk Drives Start Create Process Totally, there are four configurations supported: RAID Configurations Number of disks level/Type needed RAID 0 Disk Striping 2 or 3 or 4 RAID 1 Disk Mirroring 2 RAID 0+1 Disk Striping 4 + Mirroring JBOD Disk 2 or 3 or 4 Concatenation Driver Installation Installing driver on Windows® 98SE/ME 1. Start your PC. Windows ® will

ページ6に含まれる内容の要旨

SATA+ Ultra ATA RAID CONTROLLER RC212 User Manual Folder “\ RC212\” and double click “Setup.exe” to start the driver installation procedure. 3. Follow the on-screen instructions to complete the installation. When the installation is complete, please select “Yes, I want to restart my computer now.” and restart your system. Installing driver on Windows® NT 1. Start your PC, insert the Driver CD into the CD-ROM Drive, and then please browse CD and locat