ページ1に含まれる内容の要旨
Transport GT24
B2881
Service Engineer’s Manual
ページ2に含まれる内容の要旨
ページ3に含まれる内容の要旨
PREFACE Copyright This publication, including all photographs, illustrations, and soft- ware, is protected under international copyright laws, with all rights reserved. Neither this manual, nor any material contained herein, may be reproduced without written consent of the manufacturer-. Copyright 2005 Version 1.0 Disclaimer Information contained in this document is furnished by TYAN Com- puter Corporation and has been reviewed for accuracy and reliability prior to printing. TYAN assumes no l
ページ4に含まれる内容の要旨
Federal Communications Commission (FCC) Notice for the USA Compliance Information State- ment (Declaration of Conformity Procedure) DoC FCC Part 15: This device complies with part 15 of the FCC Rules Operation is subject to the following conditions: 1) This device may not cause harmful interference, and 2) This device must accept any interference received including inter- ference that may cause undesired operation. If this equipment does cause harmful interference to radio or television
ページ5に含まれる内容の要旨
About this Manual This manual provides you with instructions on installing your Transport GT24, and consists of the following sections: Chapter 1: Provides an Introduction to the Transport GT24 B2881 bare-bones, packing list, describes the external components, gives a table of key compo- nents, and provides block diagrams of the system. Chapter 2: Covers procedures on installing the CPU, mem- ory modules, an optional PCI card, and hard drives. Chapter 3: Covers removal and replacement proce
ページ6に含まれる内容の要旨
SAFETY INFORMATION Before installing and using the Transport GT24, take note of the fol- lowing precautions: – Read all instructions carefully. – Do not place the unit on an unstable surface, cart, or stand. – Do not block the slots and opening on the unit, which are pro- vided for ventilation. – Only use the power source indicated on the marking label. If you are not sure, contact the Power Company. – The unit uses a three-wire ground cable, which is equipped with a third pin to ground the
ページ7に含まれる内容の要旨
Table of Contents Chapter 1:Overview 1.1 About the Transport GT24 B2881 . . . . . . . . . . . . . . . . . . . . . . . . .1 1.2 Product Models . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 1.3 Features . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 1.4 Unpacking . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 1.5 About the Product . . . . . . . . . . . . . . . . . . . . . .
ページ8に含まれる内容の要旨
3.4.2 Removing the Motherboard. . . . . . . . . . . . . . . . . . . . . . . . 43 3.5 Replacing the LED Control Board . . . . . . . . . . . . . . . . . . . . . . . .46 3.6 Replacing the M1012 Adapter Board . . . . . . . . . . . . . . . . . . . . . .48 3.6.1 M1012 Adapter Board Features. . . . . . . . . . . . . . . . . . . . . 49 3.6.2 M1012 Adapter Board Connector Pin Definition . . . . . . .50 3.6.3 System Fan Layout . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .55 3.7 Replacing
ページ9に含まれる内容の要旨
Chapter 1: Overview 1.1 About the Transport GT24 B2881 TM Congratulations on your purchase of the TYAN Transport GT24 (B2881), a highly-optimized rack-mountable barebone system. The Transport GT24 (B2881) offers the latest in dual processor server systems, providing a rich feature set and incredible performance. Leveraging advanced technology ® from AMD , the Transport GT24 (B2881) based server sys- tem are capable of offering scalable 32 and 64-bit computing, high-bandwidth memory design,
ページ10に含まれる内容の要旨
1.2 Product Models Hot-Swap HDD Model HDD Bays Support Backplane Removable, 4-port Ultra B2881G24U4H Yes 4 HDDs SCSI . Removable, B2881G24S4H Yes 4-port SATA 4 HDDs Internal (Fixed), B2881G24S4-LC No None 4 HDDs B2881G24S4H B2881G24U4H B2881G24S4-LC 2 Chapter 1: Overview
ページ11に含まれる内容の要旨
1.3 Features Enclosure Networking • Industry 19” rack-mountable 1U • (2) Gigabit Ethernet ports (Broad- chassis storage bay com BCM5704 dual port controller) – (4) 3.5” HDD bays connected to 133MHz PCI-X bus – (1) slim line CD-ROM bay Video – (1) slim line FDD bay • ATI RAGE XL PCI graphics control- • Dimension: D 25.4 x W 17.17 x H ler 1.71 inch (645x436x43.6mm) • 8MB Frame Buffer of video memory Processors Integrated Storage Controller • Supports one or two AMD Opter- • Model B2881G24S4H/S4-
ページ12に含まれる内容の要旨
Regulatory Environment Temperature o o • FCC Class B (Declaration of Con- • Operating temperature 5 C~35 C) formity) o • Non-operating temperature -40 C ~ • CE (Declaration of Conformity) o 70 C Power Supply • EPS 12V, 1U, 500W with PFC • 100V~240V AC input • 4 Chapter 1: Overview
ページ13に含まれる内容の要旨
1.4 Unpacking If any items are missing or appear damaged, contact your retailer or browse to TYAN’s Web site for service: http://www.tyan.com. The Web site also provides information on other TYAN prod- ucts, plus FAQs, compatibility lists, BIOS settings, and more. 1 x Tyan driver CD SMDC Kit Power Cords HDD Screws Left to right: Europe, US FDDs Mounting Ears & Screws FDD Kit FDD Backplane FDD Cable FDD Backplane Cable FDD Rails & Screws Chapter 1: Overview 5
ページ14に含まれる内容の要旨
Barebone Manual Mainboard Manual Heatsink x 2 Rail Kit Front Rear Sliding Brackets Front L-Bracket x 2 Rear L-Bracket x 2 Mounting Bracket x 4 Sliding Rails x 2 Screws Kit 6 Chapter 1: Overview
ページ15に含まれる内容の要旨
CD-ROM Accessory Kit (for B2881G24S4-LC only) CD-ROM Bracket CD-ROM Cable Power Cable CD-ROM Backplane & Screws Chapter 1: Overview 7
ページ16に含まれる内容の要旨
1.5 About the Product This section contains the hardware diagrams and a block dia- gram of the GT24 system. 1.5.1 System Front View B2881G24S4-LC Reset switch Warning LED HDD activity LED Power LED CD-ROM Drive *Reserved USB ports (Option) Power switch LAN LEDs Hard Drive Bay x 4 *Reserved: Reserved LED for future upgrade B2881G24IU4H/B2881G24S4H Reset switch Warning LED HDD activity LED Power LED *Reserved USB ports CD-ROM Drive Power switch LAN LEDs Hard Drive Bay x 4 8 Chapter 1: Overview
ページ17に含まれる内容の要旨
1.5.2 System Rear View Power Supply Socket Power Supply LED PS/2 Mouse/Keyboard Ports PCI-X Slot PCI-X Slot USB Port Serial Port LAN Port x 2 VGA Port 1.5.3 LED Definition Front Panel LED Color State Description Power Green ON Power ON OFF OFF Power OFF HDD Activity Amber Blinking HDD access activity OFF OFF No disk activity LAN1/LAN2 Activity Green ON LAN connected Green Blinking LAN access activity OFF OFF LAN disconnected Warning Reserved LED for future upgrade. It is not functional in the B
ページ18に含まれる内容の要旨
Rear I/O LED LED Color State Description RJ45 NIC1 Linkage Green ON LAN linked (Left Side) Green Blinking LAN accessing OFF OFF No LAN linked RJ45 NIC1 Mode Amber ON Gigabit mode (Right Side) Green ON 100M mode OFF OFF 10M mode RJ45 NIC2 Linkage Green ON LAN linked (Left Side) Green Blinking LAN accessing OFF OFF No LAN linked RJ45 NIC2 Mode Amber ON Gigabit mode (Right Side) Green ON 100M mode OFF OFF 10M mode Delta Power Green ON Output ON and OK Supply LED Green 1Hz Blinking AC present/Only 5
ページ19に含まれる内容の要旨
1.5.4 System Internal View B2881G24S4-LC 1 2 3 4 5 6 7 9 8 9 1. PCI-X Slot (with riser card 6. System Fans (Left to right: M2057) FAN5, FAN4, FAN3, FAN2, FAN1) 2. PCI-X Slot (with riser card M2052) 7. M1012 Adapter Board 3. EPS 12V Power Supply 8. Front Control Board Cable 4. Memory Slots 9. Four Internal HDD trays 5. CPU Sockets Chapter 1: Overview 11
ページ20に含まれる内容の要旨
B2881G24S4H 2 3 1 12 4 5 6 11 7 8 10 9 1. PCI-X Slot (with riser card 7. SATA Backplane M2057) 8. LED Control Board Cable 2. PCI-Slot (with riser card 9. Four SATA HDDs M2052) 10. Slim CD-ROM 3. EPS 12V Power Supply 11. CD-ROM Cable 4. CPU Sockets 12. Memory Slots 5. System Fans (Left to right: FAN5, FAN4, FAN3, FAN2, FAN1) 6. Adapter Board 12 Chapter 1: Overview
